When to replace the Brake Pads on your NISSAN QASHQAI
Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.5 dCi, NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.6, NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0, NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0 Allrad, NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.6 dCi Allrad, NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.6 dCi, NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.5 dCi, NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0 dCi, NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0 dCi Allrad, NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.5 dCi View more

The steps may slightly vary depending on the car design.

How to change rear brake pads on NISSAN QASHQAI (J10, NJ10) [TUTORIAL AUTODOC]

video
All the parts you need to replace – Brake Pads for Qashqai / Qashqai +2 I (J10, NJ10) and other NISSAN models
Tools
Replacement: brake pads – Nissan Qashqai J10. Tools you might need:
Wire brush
Nylon cleaning brush
WD-40 spray
All-purpose cleaning spray
Brake cleaner
Anti-squeal paste
Brake caliper guide pins grease
Copper grease
Torque wrench
Drive socket # 14
Wheel impact socket #21
Brake caliper wind back tool
Tap wrench
Crow bar
Wheel chock
Replacement: brake pads – Nissan Qashqai J10. AUTODOC recommends:
  • Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
  • The replacement procedure is identical for all brake pads on the same axle.
  • All work should be done with the engine stopped.
Replacement: brake pads – Nissan Qashqai J10. Take the following steps:
  1. Step 1
    How to change Brake Pads on Nissan Qashqai j10 2006 - free PDF and video manuals
    Open the bonnet. Unscrew the brake fluid reservoir cap.
  2. Step 2
    How to replace NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.5 dCi 2007 Brake Pads - step-by-step manuals and video guides
    Secure the wheels with chocks.
  3. Step 3
    Nissan Qashqai j10 2.0 dCi Allrad 2008 Brake Pads replacement: free workshop manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #21.
  4. Step 4
    Changing Brake Pads on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0 dCi 2009 by yourself
    Raise the rear of the car and secure on supports.
  5. Step 5
    How to remove NISSAN QASHQAI 1.6 dCi 2010 Brake Pads - online easy-to-follow instructions
    Unscrew the wheel bolts.
    Replacement: brake pads – Nissan Qashqai J10. Tip from AUTODOC experts:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  6. Step 6
    How to replace Brake Pads on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2011: download PDF manuals and video instructions
    Remove the wheel.
  7. Step 7
    How hard is it to do yourself: Brake Pads replacement on Nissan Qashqai j10 2.0 Allrad 2012 - download illustrated guide
    Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray. Use all-purpose cleaning spray.
  8. Step 8
    Need to know how to renew Brake Pads on NISSAN QASHQAI 2013? This free workshop manual will help you to do it yourself
    Unscrew the brake caliper fastening. Use a drive socket #14. Use a tap wrench.
  9. Step 9
    Changing of Brake Pads on Nissan Qashqai j10 2006 won't be an issue if you follow this illustrated step-by-step guide
    Spread the brake pads. Use a crowbar.
  10. Step 10
    NISSAN QASHQAI 2.0 dCi Allrad Brake Pads replacement: online guides and video tutorials
    Remove the brake caliper.
    Replacement: brake pads – Nissan Qashqai J10. AUTODOC recommends:
    Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
  11. Step 11
    Replacing Brake Pads on Nissan Qashqai j10 2008 1.5 dCi by yourself
    Remove the brake pads.
    Replacement: brake pads – Nissan Qashqai J10. Tip:
    Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
  12. Step 12
    Qashqai / Qashqai +2 I (J10, NJ10) 1.6 dCi 2009 Brake Pads DIY replacement workshop manual
    Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use all-purpose cleaning spray.
  13. Step 13
    How to change Brake Pads on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2010 - tips and tricks
    Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.
    Replacement: brake pads – Nissan Qashqai J10. AUTODOC experts recommend:
    After applying the spray, wait a few minutes.
  14. Step 14
    Step-by-step recommendations for DIY replacement Nissan Qashqai j10 2011 1.6 dCi Brake Pads
    Press in the brake caliper piston. Use brake caliper wind back tool.
  15. Step 15
    DIY replacement of Brake Pads on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.6 2012 is not an issue anymore with our step-by-step tutorial
    Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.
    Replacement: brake pads – Nissan Qashqai J10. Tip from AUTODOC:
    Make sure the disc surface is clean before installing the pads.
  16. Step 16
    How to change Brake Pads on Nissan Qashqai j10 2006 - free PDF and video manuals
    Install new brake pads.
    Replacement: brake pads – Nissan Qashqai J10. Professionals recommend:
    Make sure the pads are installed with linings facing the disc.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 2
Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
NISSAN Qashqai / Qashqai +2 I (J10, NJ10) Brake Pads replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY NISSAN Qashqai / Qashqai +2 I (J10, NJ10) Brake Pads replacement - online guide
Tips & tricks for your NISSAN Qashqai / Qashqai +2 I (J10, NJ10)
View more
  • How to change Brake pad set on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.6 - replacement tricks
    Top 5 mistakes when buying car parts
  • Changing Disc pads Nissan Qashqai j10 1.5 dCi - Replacement Tips
    Causes of a worn car boot damper | AUTODOC
  • Maintenance Hacks - NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0 dCi Allrad Brake pad kit replacement guide
    How to repair a chipped or cracked windscreen | AUTODOC tips
  • Replace Disc brake pads on Nissan Qashqai j10 - free video tips
    What to do if your car heater isn't working | AUTODOC tips