Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
FORD Transit Connect V408 Van 1.5 TDCi, FORD Transit Connect V408 Van 1.5 TDCi, FORD Transit Connect V408 Van 1.5 TDCi, FORD Transit Connect V408 Van 1.5 TDCi, FORD Transit Connect V408 Van 1.0 EcoBoost, FORD Transit Connect V408 Van 1.6 EcoBoost, FORD Transit Connect V408 Van 1.6 TDCi, FORD Transit Connect V408 Van 1.6 TDCi, FORD Transit Connect V408 Van 1.6 TDCi … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for Transit Connect V408 Van and other FORD models

Brake pad set

        Brake pad set for Transit Connect V408 Van Diesel (115 hp)
      
        Brake pad set for Transit Connect V408 Van Diesel (95 hp)
      
        Brake pad set for Transit Connect V408 Van Diesel (75 hp)
      
        Brake pad set for Transit Connect V408 Van Petrol (150 hp)
      
        Brake pad set for Transit Connect V408 Van Petrol (100 hp)
      
        Brake pad set for Transit Connect V408 Van Diesel (101 hp)
      
        Brake pad set for Transit Connect V408 Van Diesel (120 hp)
      
        Brake pad set for Transit Connect V408 Van Diesel (75 hp)
      
        Brake pad set for Transit Connect V408 Van Diesel (95 hp)

Replacement: brake pads – FORD TRANSIT CONNECT Box. Tools you might need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner
                      
                        Anti-squeal paste
                      
                        Brake caliper guide pins grease
                      
                        Copper grease
                      
                        HEX bit no.H7.
                      
                        Wheel impact socket #19
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Brake caliper wind back tool
                      
                        Flat Screwdriver
                      
                        Crow bar
                      
                        Wheel chock

Buy tools

Replacement: brake pads – FORD TRANSIT CONNECT Box. AUTODOC recommends:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – FORD TRANSIT CONNECT Box. Use the following procedure:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #19.
Step 4

Raise the rear of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

Replacement: brake pads – FORD TRANSIT CONNECT Box. Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Detach the brake caliper retaining spring. Use a flat screwdriver.
Step 8

Remove the dust boot caps of the brake caliper guide pins. Use a flat screwdriver.
Step 9

Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
Step 10

Remove the guide pins from the brake caliper.

Step 11

Spread the brake pads. Use a crowbar.
Step 12

Remove the brake caliper.

Replacement: brake pads – FORD TRANSIT CONNECT Box. AUTODOC experts recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 13

Remove the brake pads.

Replacement: brake pads – FORD TRANSIT CONNECT Box. Tip from AUTODOC:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 14

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – FORD TRANSIT CONNECT Box. After applying the spray, wait a few minutes.
Step 15

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – FORD TRANSIT CONNECT Box. Tip from AUTODOC experts:
Make sure the disc surface is clean before installing the pads.
Step 16

Install new brake pads.

Replacement: brake pads – FORD TRANSIT CONNECT Box. Tip:
Make sure the pads are installed with linings facing the disc.
Step 17

Treat the brake caliper piston. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – FORD TRANSIT CONNECT Box. After applying the spray, wait a few minutes.
Step 18

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 19

Install the brake caliper and fix it.
Step 20

Clean the brake caliper guide pins.
Step 21

Treat the brake caliper guide pins. Use the brake caliper guide pin grease.
Step 22

Screw in the guide pins.
Step 23

Tighten the brake caliper fasteners. Use HEX No.H7. Use a torque wrench. Tighten it to 35 Nm torque.
Step 24

Install the dust boot caps of the brake caliper guide pins.
Step 25

Install the brake caliper retaining spring. Use a flat screwdriver.
Step 26

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 27

Clean the brake disk surface. Use a brake cleaner.

Replacement: brake pads – FORD TRANSIT CONNECT Box. AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 28

Install the wheel.

AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. FORD TRANSIT CONNECT Box
Step 29

Screw in the wheel bolts. Use wheel impact socket #19.
Step 30

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #19. Use a torque wrench. Tighten it to 120 Nm torque.
Step 31

Remove the jacks and chocks.

Replacement: brake pads – FORD TRANSIT CONNECT Box. Professionals recommend:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 32

Tighten the brake fluid reservoir cap. Close the hood.

AUTODOC recommends:
FORD TRANSIT CONNECT Box – Without starting the engine, press the brake pedal several times until it feels firm.Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the FORD Transit Connect V408 Van model.

Browse tyres

How to change front brake pads on FORD Transit Connect V408 Van – replacement guide

Free download PDF
2.35 MB
How to change front brake caliper on FORD Transit Connect V408 Van – replacement guide

Free download PDF
2.11 MB
How to change serpentine belt on FORD Transit Connect V408 Van – replacement guide

Free download PDF
768 KB
How to change front windshield wipers on FORD Transit Connect V408 Van – replacement guide

Free download PDF
1.49 MB
How to change rear windshield wipers on FORD Transit Connect V408 Van – replacement guide

Free download PDF
1.44 MB
How to change front anti roll bar links on FORD Transit Connect V408 Van – replacement guide

Free download PDF
1.26 MB

How to change rear brake pads on FORD TRANSIT CONNECT (P65_, P70_, P80_) – replacement guide

Free download PDF
1.72 MB
How to change front brake pads on FORD Transit Connect V408 Van – replacement guide

Free download PDF
2.35 MB
How to change front brake pads on FORD Transit Connect Mk2 Estate – replacement guide

Free download PDF
2.35 MB
How to change rear brake pads on FORD TRANSIT CONNECT Kombi – replacement guide

Free download PDF
1.71 MB
How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB
How to change rear brake pads on Ford Focus MK2 – replacement guide

Free download PDF
1.81 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Top 5 reasons why the suspension knocks | AUTODOC tips

1M views

Published on: 09/09/2022
Top 5 brake repair mistakes | AUTODOC tips

184K views

Published on: 27/10/2022
How to polish an old engine valve cover to a shiny finish | AUTODOC Tips

8K views

Published on: 30/11/2023
How to replace the suspension on a BMW E30 Turbo | SUPERCAR AUTODOC

1K views

Published on: 04/03/2021