Disclaimer
How to change rear brake pads on FIAT 500X (334) – replacement guide
downloads:
69
Views:
1500
Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
FIAT 500X (334_) 1.4 (334AXC1B, 334AXC11), FIAT 500X (334_) 1.6 D Multijet (334AXA1B, 334AXA11), FIAT 500X (334_) 2.0 D Multijet 4x4 (334AXB22, 334AXD2B), FIAT 500X (334_) 1.6 D Multijet (334AXA1B), FIAT 500X (334_) 1.4 (334AXC1B), FIAT 500X (334_) 2.0 D Multijet 4x4 (334AXB22, 334AXD2B), FIAT 500X (334_) 1.6 (334AXE1A), FIAT 500X (334_) 1.4 4x4 (334AXF22), FIAT 500X (334_) 1.4 4x4 (334AXF22), FIAT 500X (334_) 1.4 (334AXC1B), FIAT 500X (334_) 2.4 (334AX), FIAT 500X (334_) 2.4 4x4 (334AX), FIAT 500X (334_) 1.3 D Multijet (334AXH1A), FIAT 500X (334_) 2.4 4x4 (334AX), FIAT 500X (334_) 1.4 LPG (334AXL1B), FIAT 500X (334_) 2.4 (334AX), FIAT 500X (334_) 2.0 D Multijet 4x4 (334AX), FIAT 500X (334_) 1.3 (334.AXR11), FIAT 500X (334_) 1.0 (334.AXN1B) … View more
The steps may slightly vary depending on the car design.
FIAT 500X (334_) 1.4 (334AXC1B, 334AXC11), FIAT 500X (334_) 1.6 D Multijet (334AXA1B, 334AXA11), FIAT 500X (334_) 2.0 D Multijet 4x4 (334AXB22, 334AXD2B), FIAT 500X (334_) 1.6 D Multijet (334AXA1B), FIAT 500X (334_) 1.4 (334AXC1B), FIAT 500X (334_) 2.0 D Multijet 4x4 (334AXB22, 334AXD2B), FIAT 500X (334_) 1.6 (334AXE1A), FIAT 500X (334_) 1.4 4x4 (334AXF22), FIAT 500X (334_) 1.4 4x4 (334AXF22), FIAT 500X (334_) 1.4 (334AXC1B), FIAT 500X (334_) 2.4 (334AX), FIAT 500X (334_) 2.4 4x4 (334AX), FIAT 500X (334_) 1.3 D Multijet (334AXH1A), FIAT 500X (334_) 2.4 4x4 (334AX), FIAT 500X (334_) 1.4 LPG (334AXL1B), FIAT 500X (334_) 2.4 (334AX), FIAT 500X (334_) 2.0 D Multijet 4x4 (334AX), FIAT 500X (334_) 1.3 (334.AXR11), FIAT 500X (334_) 1.0 (334.AXN1B) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Pads for 500X (334_) and other FIAT models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Anti-squeal paste
Copper grease
Combination spanner #17
Drive socket # 13
Wheel impact socket #17
Ratchet wrench
Torque wrench
Brake caliper wind back tool
Crow bar
Wheel chock
Replacement: brake pads – FIAT 500X. AUTODOC experts recommend:
- The replacement procedure is identical for all brake pads on the same axle.
- All work should be done with the engine stopped.
Replacement: brake pads – FIAT 500X. Recommended sequence of steps:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2
Secure the wheels with chocks. - Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 4Raise the rear of the car and secure on supports.Step 5
Unscrew the wheel bolts.AUTODOC recommends:Important! Hold the wheel while unscrewing the fastening bolts. FIAT 500X - Step 6
Remove the wheel. - Step 7
Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray. - Step 8
Unscrew the brake caliper fastening. Use a drive socket #13. Use a combination spanner #17. Use a ratchet wrench. - Step 9
Remove the brake caliper.Replacement: brake pads – FIAT 500X. Professionals recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. - Step 10
Remove the brake pads. Use a crowbar.AUTODOC recommends:Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced. - Step 11
Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake pads – FIAT 500X. After applying the spray, wait a few minutes. - Step 12
Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.Replacement: brake pads – FIAT 500X. AUTODOC recommends:Make sure the disc surface is clean before installing the pads. - Step 13
Install new brake pads.AUTODOC recommends:Make sure the pads are installed with linings facing the disc.
Comments –
1
- @user_360986027.05.2025 10:23Membermy 500x has electric powered parking not in your manual
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 1
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the FIAT 500X (334) model
Popular maintenance tutorials for Fiat 500X
Complete guides for changing the Brake pad set on different FIAT 500 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your FIAT 500X (334_)
View more
Checking the starter without removing it | AUTODOC tips
2 ways to clean the EGR valve – which one is better?
How to inspect and troubleshoot your car heater when it’s not working
#DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit
Most commonly replaced car parts on FIAT 500
Time to replace parts? Get even better deals in our Shop app.

SCAN ME





























