When to replace the Brake Discs on your HONDA CR-V
Recommended replacement interval for the part category Brake disc : 50000 km
Important!
This replacement procedure can be used for:
HONDA CR-V II (RD_) 2.0, HONDA CR-V II (RD_) 2.4 Vtec 4WD (RD7), HONDA CR-V II (RD_) 2.0 (RD5) View more

The steps may slightly vary depending on the car design.

How to change rear brake discs and rear brake pads on HONDA CR-V 2 TUTORIAL | AUTODOC

video
All the parts you need to replace – Brake Discs for CR-V II (RD_) and other HONDA models
Tools
Replacement: brake discs – Honda CR-V II. Tools you'll need:
Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #17
Drive socket # 12
Drive socket # 14
Wheel impact socket #19
Ratchet wrench
Torque wrench
Brake caliper wind back tool
Phillips screwdriver
Flat Screwdriver
Crow bar
Hammer
Wheel chock
AUTODOC recommends:
  • Replace the brake disks on the car Honda CR-V II in complete set for each axis. Regardless of the state of components. This will ensure even braking.
  • The replacement procedure is identical for both brake disks on the same axle.
  • When changing the brake discs, always replace the brake pads.
  • Please note: all work on the car – Honda CR-V II – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    How to change Brake Discs on Honda CR-V Mk2 2001 - free PDF and video manuals
    Open the bonnet. Unscrew the brake fluid reservoir cap.
  2. Step 2
    How to replace HONDA CR-V II (RD_) 2.0 (RD5) 2002 Brake Discs - step-by-step manuals and video guides
    Secure the wheels with chocks.
  3. Step 3
    Honda CR-V Mk2 2.2 CTDi (RD9) 2003 Brake Discs replacement: free workshop manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #19.
  4. Step 4
    Changing Brake Discs on HONDA CR-V II (RD_) 2.4 Vtec 4WD 2004 by yourself
    Raise the rear of the car and secure on supports.
  5. Step 5
    How to remove HONDA CR-V 2.4 2005 Brake Discs - online easy-to-follow instructions
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. Honda CR-V II
  6. Step 6
    How to replace Brake Discs on HONDA CR-V II (RD_) 2006: download PDF manuals and video instructions
    Remove the wheel.
  7. Step 7
    How hard is it to do yourself: Brake Discs replacement on Honda CR-V Mk2 2.4 4WD (RD7) 2001 - download illustrated guide
    Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
  8. Step 8
    Need to know how to renew Brake Discs on HONDA CR-V 2002? This free workshop manual will help you to do it yourself
    Unscrew the brake caliper fastening. Use a combination spanner #17. Use a drive socket #12. Use a ratchet wrench.
  9. Step 9
    Changing of Brake Discs on Honda CR-V Mk2 2003 won't be an issue if you follow this illustrated step-by-step guide
    Spread the brake pads. Use a crowbar.
  10. Step 10
    HONDA CR-V 2.0 (RD5) Brake Discs replacement: online guides and video tutorials
    Remove the brake caliper. Use a crowbar.
    Replacement: brake discs – Honda CR-V II. Tip from AUTODOC experts:
    Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
  11. Step 11
    Replacing Brake Discs on Honda CR-V Mk2 2005 2.0 (RD5) by yourself
    Remove the brake pads. Use a crowbar.
  12. Step 12
    CR-V II (RD_) 2.4 2006 Brake Discs DIY replacement workshop manual
    Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
  13. Step 13
    How to change Brake Discs on HONDA CR-V II (RD_) 2001 - tips and tricks
    Unscrew the caliper bracket fastening. Use a drive socket #14. Use a ratchet wrench.
  14. Step 14
    Step-by-step recommendations for DIY replacement Honda CR-V Mk2 2002 2.4 Brake Discs
    Remove the caliper bracket.
  15. Step 15
    DIY replacement of Brake Discs on HONDA CR-V II (RD_) 2.0 2003 is not an issue anymore with our step-by-step tutorial
    Clean the brake disc fasteners. Use a wire brush. Use WD-40 spray.
  16. Step 16
    How to change Brake Discs on Honda CR-V Mk2 2001 - free PDF and video manuals
    Unscrew the brake disc fastening. Use a Phillips screwdriver.
  17. Step 17
    How to replace HONDA CR-V II (RD_) 2.0 (RD5) 2002 Brake Discs - step-by-step manuals and video guides
    Extract the adjuster hole plug. Use a flat screwdriver.
  18. Step 18
    Honda CR-V Mk2 2.2 CTDi (RD9) 2003 Brake Discs replacement: free workshop manuals
    Remove the brake disc. Use a hammer.
  19. Step 19
    Changing Brake Discs on HONDA CR-V II (RD_) 2.4 Vtec 4WD 2004 by yourself
    Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease.
  20. Step 20
    How to remove HONDA CR-V 2.4 2005 Brake Discs - online easy-to-follow instructions
    Install the brake disc.
  21. Step 21
    How to replace Brake Discs on HONDA CR-V II (RD_) 2006: download PDF manuals and video instructions
    Tighten the brake disc fastening. Use a Phillips screwdriver. Use a torque wrench. Tighten it to 9 Nm torque.
  22. Step 22
    How hard is it to do yourself: Brake Discs replacement on Honda CR-V Mk2 2.4 4WD (RD7) 2001 - download illustrated guide
    Move the parking brake shoes against the drum. Use a flat screwdriver.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the HONDA CR-V II (RD) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
HONDA CR-V II (RD_) Brake Discs replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY HONDA CR-V II (RD_) Brake Discs replacement - online guide
Tips & tricks for your HONDA CR-V II (RD_)
View more
  • How to change Brake rotors on HONDA CR-V II (RD_) 2.0 - replacement tricks
    How to polish your car | AUTODOC tips
  • Changing Brake disc Honda CR-V Mk2 2.0 (RD5) - Replacement Tips
    TOP 5 mistakes during DIY oil change | AUTODOC tips
  • Maintenance Hacks - HONDA CR-V II (RD_) 2.2 CTDi (RD9) Brake disc kit replacement guide
    How to restore a steering wheel | AUTODOC tips
  • Replace Disc brake set on Honda CR-V Mk2 - free video tips
    Headlight Restoration | AUTODOC tips