Disclaimer
How to change rear brake discs on FORD Focus II Hatchback (DA_, HCP, DP) – replacement guide
downloads:
5
Views:
41
Recommended replacement interval for the part category Brake disc : 50000 km
Important!
This replacement procedure can be used for:
FORD Focus II Hatchback (DA_, HCP, DP) 1.6 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.6, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 Ti, FORD Focus II Hatchback (DA_, HCP, DP) 1.4, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.8 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.8 Flexifuel, FORD Focus II Hatchback (DA_, HCP, DP) 1.8, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 LPG … View more
The steps may slightly vary depending on the car design.
FORD Focus II Hatchback (DA_, HCP, DP) 1.6 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.6, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 Ti, FORD Focus II Hatchback (DA_, HCP, DP) 1.4, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.8 TDCi, FORD Focus II Hatchback (DA_, HCP, DP) 1.8 Flexifuel, FORD Focus II Hatchback (DA_, HCP, DP) 1.8, FORD Focus II Hatchback (DA_, HCP, DP) 1.6 LPG … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Discs for Focus II Hatchback (DA_, HCP, DP) and other FORD models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Brake caliper guide pins grease
Copper grease
Drive socket # 13
HEX bit no.H7.
Wheel impact socket #19
Ratchet wrench
Torque wrench
Brake caliper wind back tool
Flat Screwdriver
Crow bar
Wheel chock
Replacement: brake discs – FORD FOCUS II (DA_). Tip from AUTODOC:
- Replace the brake disks on the car FORD FOCUS II (DA_) in complete set for each axis. Regardless of the state of components. This will ensure even braking.
- The replacement procedure is identical for both brake disks on the same axle.
- When changing the brake discs, always replace the brake pads.
- Warning! Shut down the engine before starting any work – FORD FOCUS II (DA_).
Carry out replacement in the following order:
- Step 1
Open the bonnet. Unscrew the brake fluid reservoir cap. - Step 2
Secure the wheels with chocks. - Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #19. - Step 4Raise the rear of the car and secure on supports.Step 5
Unscrew the wheel bolts.Replacement: brake discs – FORD FOCUS II (DA_). AUTODOC recommends:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 6
Remove the wheel. - Step 7
Detach the brake caliper retaining spring. Use a flat screwdriver. - Step 8
Remove the dust boot caps of the brake caliper guide pins. Use a flat screwdriver. - Step 9
Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench. - Step 10Remove the guide pins from the brake caliper.Step 11
Spread the brake pads. Use a crowbar. - Step 12
Remove the brake caliper.Replacement: brake discs – FORD FOCUS II (DA_). Professionals recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary. - Step 13
Remove the brake pads. - Step 14
Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray. - Step 15
Unscrew the caliper bracket fastening. Use a drive socket #13. Use a ratchet wrench. - Step 16Remove the fastening bolts (2 pieces).Step 17
Remove the caliper bracket. - Step 18
Remove the brake disc. - Step 19
Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease. - Step 20
Install the brake disc. - Step 21
Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake discs – FORD FOCUS II (DA_). After applying the spray, wait a few minutes. - Step 22
Install the brake caliper bracket. - Step 23Install the fastening bolts (2 pieces).Step 24
Tighten the brake caliper bracket. Use a drive socket #13. Use a torque wrench. Tighten it to 62 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the FORD Focus Mk2 Hatchback (DA_, HCP, DP) model
Popular maintenance tutorials for Ford Focus Mk2
Complete guides for changing the Brake rotors on different FORD FOCUS models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your FORD Focus II Hatchback (DA_, HCP, DP)
View more
Top Automatic Transmission Blunders You Must Dodge | AUTODOC Insights
How to unlock your car without a key | AUTODOC tips
DIY car soundproofing | AUTODOC tips
CHECK ENGINE light turned on – step-by-step guide on what to do
Most commonly replaced car parts on FORD FOCUS
Time to replace parts? Get even better deals in our Shop app.

SCAN ME

































