Disclaimer
How to change rear brake caliper on MERCEDES-BENZ CLS (C219) – replacement guide
downloads:
2
Views:
101
Recommended replacement interval for the part category Brake caliper : 100000 km
Important!
This replacement procedure can be used for:
MERCEDES-BENZ CLS (C219) CLS 350 (219.356), MERCEDES-BENZ CLS (C219) CLS 500 (219.375), MERCEDES-BENZ CLS (C219) CLS 320 CDI (219.322), MERCEDES-BENZ CLS (C219) CLS 350 (219.357), MERCEDES-BENZ CLS (C219) CLS 280 (219.354), MERCEDES-BENZ CLS (C219) CLS 300 (219.354), MERCEDES-BENZ CLS (C219) CLS 350 CDI (219.322), MERCEDES-BENZ CLS (C219) CLS 320 CDI, MERCEDES-BENZ CLS (C219) CLS 350 CDI … View more
The steps may slightly vary depending on the car design.
MERCEDES-BENZ CLS (C219) CLS 350 (219.356), MERCEDES-BENZ CLS (C219) CLS 500 (219.375), MERCEDES-BENZ CLS (C219) CLS 320 CDI (219.322), MERCEDES-BENZ CLS (C219) CLS 350 (219.357), MERCEDES-BENZ CLS (C219) CLS 280 (219.354), MERCEDES-BENZ CLS (C219) CLS 300 (219.354), MERCEDES-BENZ CLS (C219) CLS 350 CDI (219.322), MERCEDES-BENZ CLS (C219) CLS 320 CDI, MERCEDES-BENZ CLS (C219) CLS 350 CDI … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Calipers for CLS (C219) and other MERCEDES-BENZ models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Flare nut spanner №14
Combination spanner #10
Drive socket # 8
Torx bit T40
Wheel impact socket #17
Ratchet wrench
Torque wrench
Flat Screwdriver
Round-nose pliers
Crow bar
Brake hose clip
Brake bleeder kit
Wheel chock
Replacement: brake caliper – MERCEDES-BENZ CLS (C219). AUTODOC experts recommend:
- The replacement procedure is identical for the left and right brake calipers on the same axle.
- All work should be done with the engine stopped.
Replacement: brake caliper – MERCEDES-BENZ CLS (C219). Use the following procedure:
- Step 1
Open the bonnet. Unscrew the brake fluid reservoir cap. - Step 2Secure the wheels with chocks.Step 3Loosen the wheel mounting bolts. Use wheel impact socket #17.Step 4Raise the rear of the car and secure on supports.Step 5
Unscrew the wheel bolts.Replacement: brake caliper – MERCEDES-BENZ CLS (C219). AUTODOC recommends:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 6
Remove the wheel. - Step 7
Detach the brake caliper retaining spring. Use a flat screwdriver. - Step 8
Disconnect the brake pads wear sensor. Use round-nose pliers.Please note!Some cars are not equipped with the brake pad wear sensor. - Step 9
Unscrew the ABS cable holder. Use a drive socket #8. Use a ratchet wrench. - Step 10
Detach the ABS wiring harness bracket. - Step 11Remove the dust boot caps of the brake caliper guide pins.Step 12
Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray. - Step 13
Unscrew the brake caliper fastening. Use Torx T40. Use a ratchet wrench. - Step 14
Remove the guide pins from the brake caliper. - Step 15
Spread the brake pads. Use a crowbar. - Step 16Clean the area where the brake hose is connected to the caliper, and the guide pins area. Use a brake cleaner.AUTODOC recommends:Replacement: brake caliper – MERCEDES-BENZ CLS (C219). After applying the spray, wait a few minutes.Step 17
Clamp the brake hose off using a brake hose clamp. - Step 18
Loosen the brake hose fastening. Use a flare nut spanner #14. - Step 19
Remove the brake caliper.Replacement: brake caliper – MERCEDES-BENZ CLS (C219). Professionals recommend:When replacing the brake caliper, it is recommended to check the brake hose for damages and, if necessary, to replace it with a new one.When replacing a brake caliper it is recommended to replace brake pads, check the state of the brake discs and replace them with new ones if necessary.Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. - Step 20
Remove the brake pads. - Step 21
Unscrew the brake hose from the brake caliper. Use a flare nut spanner #14. - Step 22
Disconnect the brake hose. - Step 23Treat the brake hose. Use a brake cleaner.Replacement: brake caliper – MERCEDES-BENZ CLS (C219). AUTODOC experts recommend:After applying the spray, wait a few minutes.Step 24
Install and fix the brake hose into a new caliper. Use a flare nut spanner #14. - Step 25
Install the brake pads.Replacement: brake caliper – MERCEDES-BENZ CLS (C219). Tip:If going to use the old brake pads, clean them. - Step 26
Install the brake caliper and fix it. - Step 27Screw in the guide pins.Step 28
Tighten the brake caliper fasteners. Use Torx T40. Use a torque wrench. Tighten it to 28 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the MERCEDES-BENZ CLS Coupe (C219) model
Popular maintenance tutorials for Mercedes CLS c219
Complete guides for changing the Brake calipers on different MERCEDES-BENZ CLS models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your MERCEDES-BENZ CLS (C219)
View more
How to Install a New Windscreen Yourself | AUTODOC Expert Tips
DIY starter repair | AUTODOC tips
TOP 8 mistakes car owners make | AUTODOC tips
How to tighten cylinder head bolts
Most commonly replaced car parts on MERCEDES-BENZ CLS
Time to replace parts? Get even better deals in our Shop app.

SCAN ME






























