Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
MERCEDES-BENZ CLS (C219) CLS 350 (219.356), MERCEDES-BENZ CLS (C219) CLS 500 (219.375), MERCEDES-BENZ CLS (C219) CLS 320 CDI (219.322), MERCEDES-BENZ CLS (C219) CLS 350 (219.357), MERCEDES-BENZ CLS (C219) CLS 500 (219.372), MERCEDES-BENZ CLS (C219) CLS 280 (219.354), MERCEDES-BENZ CLS (C219) CLS 300 (219.354), MERCEDES-BENZ CLS (C219) CLS 350 CDI (219.322), MERCEDES-BENZ CLS (C219) CLS 320 CDI, MERCEDES-BENZ CLS (C219) CLS 350 CDI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Brake pad set

Replacement: brake pads – MERCEDES-BENZ CLS (C219). Tools you need:

                      Wire brush
                    
                      Nylon cleaning brush
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Torque wrench
                    
                      HEX bit No.H7
                    
                      Wheel impact socket #17
                    
                      Brake caliper wind back tool
                    
                      Ratchet wrench
                    
                      Round-nose pliers
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – MERCEDES-BENZ CLS (C219). AUTODOC experts recommend:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
Please note: all work on the car – MERCEDES-BENZ CLS (C219) – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Open the bonnet.

Step 2

Connect the service equipment and switch the SBC system to service mode.

Please note!
Some vehicles may not have the SBC system.
Step 3

Unscrew the brake fluid reservoir cap.
Step 4

Secure the wheels with chocks.

Step 5

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 6

Raise the rear of the car and secure on supports.

Step 7

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. MERCEDES-BENZ CLS (C219)
Step 8

Remove the wheel.
Step 9

Detach the connector of the brake pad wear sensor. Use round-nose pliers.
Step 10

Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
Step 11

Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
Step 12

Detach the brake caliper retaining spring. Use a crowbar.
Step 13

Spread the brake pads. Use a crowbar.
Step 14

Remove the brake caliper.

Replacement: brake pads – MERCEDES-BENZ CLS (C219). Tip:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 15

Remove the brake pads.

Replacement: brake pads – MERCEDES-BENZ CLS (C219). Tip from AUTODOC experts:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 16

Disconnect the brake pads wear sensor.

Step 17

Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – MERCEDES-BENZ CLS (C219). After applying the spray, wait a few minutes.
Step 18

Install the brake caliper wind back tool.
Step 19

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – MERCEDES-BENZ CLS (C219). After applying the spray, wait a few minutes.
Step 20

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.
Step 21

Press in the brake caliper piston. Use brake caliper wind back tool.

Replacement: brake pads – MERCEDES-BENZ CLS (C219). Tip from AUTODOC:
Make sure the disc surface is clean before installing the pads.
Step 22

Install new brake pads.

Replacement: brake pads – MERCEDES-BENZ CLS (C219). Professionals recommend:
Make sure the pads are installed with linings facing the disc.
Step 23

Install the brake caliper and fix it. Use HEX No.H7. Use a torque wrench. Tighten it to 28 Nm torque.
Step 24

Install the dust boot caps of the brake caliper guide pins.
Step 25

Install the brake caliper retaining spring.
Step 26

Connect the brake pads wear sensor.
Step 27

Attach the connector of the brake pad wear sensor.
Step 28

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 29

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – MERCEDES-BENZ CLS (C219). After applying the spray, wait a few minutes.
Step 30

Install the wheel.

AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. MERCEDES-BENZ CLS (C219)
Step 31

Screw in the wheel bolts. Use wheel impact socket #17.
Step 32

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 130 Nm torque.
Step 33

Remove the jacks and chocks.
Step 34

Switch the SBC system to operating mode and disconnect the service equipment.

Replacement: brake pads – MERCEDES-BENZ CLS (C219). AUTODOC experts recommend:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 35

Tighten the brake fluid reservoir cap. Close the hood.

Replacement: brake pads – MERCEDES-BENZ CLS (C219). Tip:
Without starting the engine, press the brake pedal several times until you feel significant resistance.Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the MERCEDES-BENZ CLS Coupe (C219) model

Mercedes CLS c219 tyre size

How to change rear brake caliper on MERCEDES-BENZ CLS (C219) – replacement guide

Free download PDF
2.55 MB
How to change rear brake discs on MERCEDES-BENZ CLS (C219) – replacement guide

Free download PDF
2.36 MB
How to change front brake pad wear sensor on MERCEDES-BENZ CLS Coupe (C219) – replacement guide

Free download PDF
1.51 MB
How to change rear brake pad wear sensor on MERCEDES-BENZ CLS Coupe (C219) – replacement guide

Free download PDF
2.11 MB
How to change front wheel bearing on MERCEDES-BENZ CLS (C219) – replacement guide

Free download PDF
4.02 MB
How to change rear wheel bearing on MERCEDES-BENZ CLS (C219) – replacement guide

Free download PDF
5.8 MB

How to change rear brake pads on MERCEDES-BENZ CLS (C218) – replacement guide

Free download PDF
1.82 MB
How to change rear brake pads on MERCEDES-BENZ CLS Shooting Brake (X218) – replacement guide

Free download PDF
1.84 MB
How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB
How to change rear brake pads on Mercedes W169 – replacement guide

Free download PDF
1.55 MB
How to change rear brake pads on Mercedes W204 – replacement guide

Free download PDF
1.91 MB
How to change front brake pads on Mercedes W204 – replacement guide

Free download PDF
1.62 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

5 possible reasons why your car heater isn't working

7K views

Published on: 21/11/2024
Transform Your Car's Look: 6 Simple Accessories You Need to Try!

3K views

Published on: 18/11/2021
Easy Steps to Paint Brake Calipers Without Special Skills or High Costs

10K views

Published on: 08/04/2021
Transform Your Engine Bay: Affordable Valve Cover Restoration with AUTODOC

8K views

Published on: 29/06/2023