Important!
This replacement procedure can be used for:
VW New Beetle Hatchback (9C1, 1C1) 2.0, VW New Beetle Hatchback (9C1, 1C1) 1.9 TDI, VW New Beetle Hatchback (9C1, 1C1) 1.6, VW New Beetle Hatchback (9C1, 1C1) 1.8 T, VW New Beetle Hatchback (9C1, 1C1) 3.2 RSI 4motion (1C9), VW New Beetle Hatchback (9C1, 1C1) 1.6, VW New Beetle Hatchback (9C1, 1C1) 2.3 V5, VW New Beetle Hatchback (9C1, 1C1) 1.9 TDI, VW New Beetle Hatchback (9C1, 1C1) 1.4, VW New Beetle Hatchback (9C1, 1C1) 1.9 TDI, VW New Beetle Hatchback (9C1, 1C1) 1.8 T, VW New Beetle Hatchback (9C1, 1C1) 2.5 View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Strut Mount for New Beetle Hatchback (9C1, 1C1) and other VW models
Tools
Replacement: strut mount – VW NEW BEETLE (9C1, 1C1). List of the tools you'll need:
Wire brush
WD-40 spray
Drive socket # 13
Drive socket # 18
Flare nut socket №22
HEX bit No.H6.
12-point socket 1-3/16”
Shock absorber socket
Combination spanner #18
Combination spanner #21
Ratchet wrench
Torque wrench
Copper grease
Wheel impact socket #17
Hydraulic transmission jack
Rubber mallet
Hydraulic strut spring compressor
Wheel chock
Fender cover
Replacement: strut mount – VW NEW BEETLE (9C1, 1C1). Tip from AUTODOC experts:
  • The replacement procedure is identical for the mounts of the left and right shock struts of the front suspension.
  • Be sure to replace all self-locking nuts and bolts during installation.
  • Warning! Shut down the engine before starting any work – VW NEW BEETLE (9C1, 1C1).
Carry out replacement in the following order:
  1. Step 1
    Secure the wheels with chocks.
    Step 2
    Open the bonnet.
    Step 3
    Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
    Step 4
    How to change Strut Mount on VW Beetle 9c 1998 - free PDF and video manuals
    Remove the wheel rim cover.
  2. Step 5
    How to replace VW New Beetle Hatchback (9C1, 1C1) 2.0 1999 Strut Mount - step-by-step manuals and video guides
    Unscrew the hub lock nut. Use 1-3/16" drive 12-point socket.
    Replacement: strut mount – VW NEW BEETLE (9C1, 1C1). Tip from AUTODOC:
    Do not unscrew the fastener by more than 90 degrees.
  3. Step 6
    VW Beetle 9c 1.9 TDI 2000 Strut Mount replacement: free workshop manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  4. Step 7
    Raise the front of the car and secure on supports.
    Step 8
    Changing Strut Mount on VW New Beetle Hatchback (9C1, 1C1) 1.8 T 2001 by yourself
    Unscrew the wheel bolts.
    Replacement: strut mount – VW NEW BEETLE (9C1, 1C1). AUTODOC recommends:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  5. Step 9
    Remove the wheel.
    Step 10
    How to remove VW NEW BEETLE 1.4 2002 Strut Mount - online easy-to-follow instructions
    Disconnect the wiring and the brake hose from the bracket on the shock strut.
  6. Step 11
    How to replace Strut Mount on VW New Beetle Hatchback (9C1, 1C1) 2003: download PDF manuals and video instructions
    Unscrew the fastener connecting the drive shaft to the wheel hub. Use 1-3/16" drive 12-point socket.
  7. Step 12
    How hard is it to do yourself: Strut Mount replacement on VW Beetle 9c 2.5 2004 - download illustrated guide
    Clean the fasteners connecting the shock strut to the steering knuckle. Clean the fasteners connecting the ball joint to the suspension control arm. Use a wire brush. Use WD-40 spray.
  8. Step 13
    Need to know how to renew Strut Mount on VW NEW BEETLE 2005? This free workshop manual will help you to do it yourself
    Unscrew the fastener connecting the ball joint to the suspension control arm. Use a drive socket #13.
  9. Step 14
    Disconnect the spherical joint from the arm.
    Step 15
    Changing of Strut Mount on VW Beetle 9c 2006 won't be an issue if you follow this illustrated step-by-step guide
    Pull the drive shaft out of the steering knuckle and lifting it, tie to the body.
    AUTODOC recommends:
    Make sure that the drive shaft is not unloaded (when the car is jacked).
  10. Step 16
    VW NEW BEETLE 1.9 TDI Strut Mount replacement: online guides and video tutorials
    Prop up the steering knuckle. Use a hydraulic transmission jack.
  11. Step 17
    Replacing Strut Mount on VW Beetle 9c 2008 2.0 by yourself
    Unscrew the lower fastener connecting the shock strut to the steering knuckle. Use a combination spanner #18. Use a drive socket #18. Use a ratchet wrench.
  12. Step 18
    New Beetle Hatchback (9C1, 1C1) 1.4 2009 Strut Mount DIY replacement workshop manual
    Remove the support from under the steering knuckle.
  13. Step 19
    How to change Strut Mount on VW New Beetle Hatchback (9C1, 1C1) 2010 - tips and tricks
    Release the lower fastener connecting the shock strut to the steering knuckle. Use a special drive socket to remove the shock absorber.
  14. Step 20
    Step-by-step recommendations for DIY replacement VW Beetle 9c 1998 1.4 Strut Mount
    Disconnect the steering knuckle from the shock absorber strut.
    Replacement: strut mount – VW NEW BEETLE (9C1, 1C1). AUTODOC recommends:
    If necessary, use a rubber mallet.
  15. Step 21
    DIY replacement of Strut Mount on VW New Beetle Hatchback (9C1, 1C1) 1.6 1999 is not an issue anymore with our step-by-step tutorial
    Prop up the steering knuckle. Use a hydraulic transmission jack.
    Replacement: strut mount – VW NEW BEETLE (9C1, 1C1). Tip:
    Make sure that the steering knuckle is not released from load.
  16. Step 22
    How to change Strut Mount on VW Beetle 9c 1998 - free PDF and video manuals
    Unscrew the upper fastening of the shock absorber strut. Use a combination spanner #21. Use HEX No.H6.
    AUTODOC recommends:
    Important! Hold the suspension strut while unscrewing the fastening bolts. VW NEW BEETLE (9C1, 1C1)
  17. Step 23
    How to replace VW New Beetle Hatchback (9C1, 1C1) 2.0 1999 Strut Mount - step-by-step manuals and video guides
    Remove the suspension strut. Set the shock absorber strut on the spring compressor tool.
    Replacement: strut mount – VW NEW BEETLE (9C1, 1C1). Professionals recommend:
    Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles.
  18. Step 24
    VW Beetle 9c 1.9 TDI 2000 Strut Mount replacement: free workshop manuals
    Compress the spring.
  19. Step 25
    Changing Strut Mount on VW New Beetle Hatchback (9C1, 1C1) 1.8 T 2001 by yourself
    Remove the strut piston rod nut. Use flare nut socket #22. Use HEX No.H6.
  20. Step 26
    How to remove VW NEW BEETLE 1.4 2002 Strut Mount - online easy-to-follow instructions
    Remove the shock strut mount.
  21. Step 27
    Clean the mounting seat of the shock strut mount. Use a wire brush.
    Step 28
    How to replace Strut Mount on VW New Beetle Hatchback (9C1, 1C1) 2003: download PDF manuals and video instructions
    Install a new strut mount.
  22. Step 29
    How hard is it to do yourself: Strut Mount replacement on VW Beetle 9c 2.5 2004 - download illustrated guide
    Tighten the shock strut piston rod nut. Use flare nut socket #22. Use HEX No.H6. Use a torque wrench. Tighten it to 60 Nm torque.
    Replacement: strut mount – VW NEW BEETLE (9C1, 1C1). AUTODOC experts recommend:
    Check to make sure the spring is positioned correctly. Avoid its misalignment.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VW New Beetle Hatchback (9C1, 1C1) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
VW New Beetle Hatchback (9C1, 1C1) Strut Mount replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY VW New Beetle Hatchback (9C1, 1C1) Strut Mount replacement - online guide
Tips & tricks for your VW New Beetle Hatchback (9C1, 1C1)
View more
  • How to change Strut mount on VW New Beetle Hatchback (9C1, 1C1) 1.6 - replacement tricks
    How to find and change a fuse | AUTODOC
  • Changing Top mount VW Beetle 9c 2.0 - Replacement Tips
    How to repair a chipped or cracked windscreen | AUTODOC tips
  • Maintenance Hacks - VW New Beetle Hatchback (9C1, 1C1) 1.9 TDI Top strut mount replacement guide
    How to repair a bumper yourself | AUTODOC tips
  • Replace Top mounts on VW Beetle 9c - free video tips
    How to polish an old engine valve cover to a shiny finish | AUTODOC Tips