Important!
This replacement procedure can be used for:
VW Golf VI Convertible (517) 2.0 R, VW Golf VI Convertible (517) 2.0 TDI, VW Golf VI Convertible (517) 1.6 TDI, VW Golf VI Convertible (517) 2.0 GTI, VW Golf VI Convertible (517) 1.4 TSI, VW Golf VI Convertible (517) 1.4 TSI, VW Golf VI Convertible (517) 1.2 TSI View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Tools
Replacement: front lower arm – VW GOLF VI Convertible (517). Tools you need:
Wire brush
WD-40 spray
Copper grease
Combination spanner #18
Drive socket # 15
Drive socket # 18
Wheel impact socket #17
Ratchet wrench
Torque wrench
Tap wrench
Crow bar
Hydraulic transmission jack
Wheel chock
Replacement: front lower arm – VW GOLF VI Convertible (517). AUTODOC recommends:
  • The replacement procedure is identical for the left and right lower control arms.
  • All work should be done with the engine stopped.
Replacement: front lower arm – VW GOLF VI Convertible (517). Use the following procedure:
  1. Step 1
    How to change Control Arm on VW Golf 6 Convertible 2011 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 2
    How to replace VW Golf VI Convertible (517) 1.6 TDI 2012 Control Arm - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  3. Step 3
    Raise the front of the car and secure on supports.
    Step 4
    VW Golf 6 Convertible 2.0 TDI 2013 Control Arm replacement: free workshop manuals
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Important! Hold the wheel while unscrewing the fastening bolts. VW GOLF VI Convertible (517)
  4. Step 5
    Changing Control Arm on VW Golf VI Convertible (517) 1.4 TSI 2014 by yourself
    Remove the wheel.
  5. Step 6
    Clean all joints of the arm. Use a wire brush. Treat all joints of the arm. Use WD-40 spray.
    Replacement: front lower arm – VW GOLF VI Convertible (517). Tip:
    After applying the spray, wait a few minutes.Wear protective goggles.
    Step 7
    How to remove VW GOLF 2.0 GTI 2015 Control Arm - online easy-to-follow instructions
    Unscrew the fasteners of the ball joint. Use a drive socket #15. Use a tap wrench.
  6. Step 8
    How to replace Control Arm on VW Golf VI Convertible (517) 2016: download PDF manuals and video instructions
    Unscrew the rear fastener connecting the control arm to the subframe. Use a drive socket #15. Use a tap wrench.
  7. Step 9
    How hard is it to do yourself: Control Arm replacement on VW Golf 6 Convertible 2.0 R 2011 - download illustrated guide
    Unscrew the rear fastener connecting the control arm to the car body. Use a drive socket #18. Use a tap wrench.
  8. Step 10
    Need to know how to renew Control Arm on VW GOLF 2012? This free workshop manual will help you to do it yourself
    Unscrew the front arm fastener. Use a drive socket #15. Use a drive socket #18. Use a tap wrench.
  9. Step 11
    Changing of Control Arm on VW Golf 6 Convertible 2013 won't be an issue if you follow this illustrated step-by-step guide
    Remove the arm. Use a crowbar.
  10. Step 12
    VW GOLF 2.0 TDI Control Arm replacement: online guides and video tutorials
    Treat the fasteners of the ball joint. Use copper grease.
  11. Step 13
    Replacing Control Arm on VW Golf 6 Convertible 2015 1.6 TDI by yourself
    Install a new arm.
    Replacement: front lower arm – VW GOLF VI Convertible (517). Tip from AUTODOC experts:
    During the installation process, use only new bolts and nuts.Do not damage the ball joint cover.
  12. Step 14
    Golf VI Convertible (517) 2.0 GTI 2016 Control Arm DIY replacement workshop manual
    Install the front fastener of the arm. Do not tighten it.
  13. Step 15
    How to change Control Arm on VW Golf VI Convertible (517) 2011 - tips and tricks
    Attach the ball joint to the control arm.
  14. Step 16
    Step-by-step recommendations for DIY replacement VW Golf 6 Convertible 2012 2.0 GTI Control Arm
    Install the fasteners of the ball joint.
  15. Step 17
    DIY replacement of Control Arm on VW Golf VI Convertible (517) 1.2 TSI 2013 is not an issue anymore with our step-by-step tutorial
    Screw the fasteners of the ball joint. Use a drive socket #15. Use a ratchet wrench.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VW Golf VI Convertible (517) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
VW Golf VI Convertible (517) Control Arm replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY VW Golf VI Convertible (517) Control Arm replacement - online guide
Tips & tricks for your VW Golf VI Convertible (517)
View more
  • How to change Control arm on VW Golf VI Convertible (517) 1.2 TSI - replacement tricks
    Top 5 mistakes when working in the engine bay | AUTODOC tips
  • Changing Wishbone VW Golf 6 Convertible 1.6 TDI - Replacement Tips
    Things you should never do with your manual transmission | AUTODOC tips
  • Maintenance Hacks - VW Golf VI Convertible (517) 2.0 TDI Control arms replacement guide
    DIY jack restoration | AUTODOC tips
  • Replace Trailing arm on VW Golf 6 Convertible - free video tips
    Coolant comparison test | AUTODOC