Disclaimer
How to change front coil springs on Skoda Octavia 1U – replacement guide
downloads:
7
Views:
70
Important!
This replacement procedure can be used for:
SKODA OCTAVIA (1U2) 1.6, SKODA OCTAVIA (1U2) 1.8, SKODA OCTAVIA (1U2) 1.9 TDI, SKODA OCTAVIA (1U2) 1.6, SKODA OCTAVIA (1U2) 1.9 SDI, SKODA OCTAVIA (1U2) 1.9 TDI, SKODA OCTAVIA (1U2) 1.8 T, SKODA OCTAVIA (1U2) 2.0, SKODA OCTAVIA (1U2) 1.4, SKODA OCTAVIA (1U2) 1.4 16V, SKODA OCTAVIA (1U2) 1.8 T 4x4, SKODA OCTAVIA (1U2) 1.9 TDI … View more
The steps may slightly vary depending on the car design.
SKODA OCTAVIA (1U2) 1.6, SKODA OCTAVIA (1U2) 1.8, SKODA OCTAVIA (1U2) 1.9 TDI, SKODA OCTAVIA (1U2) 1.6, SKODA OCTAVIA (1U2) 1.9 SDI, SKODA OCTAVIA (1U2) 1.9 TDI, SKODA OCTAVIA (1U2) 1.8 T, SKODA OCTAVIA (1U2) 2.0, SKODA OCTAVIA (1U2) 1.4, SKODA OCTAVIA (1U2) 1.4 16V, SKODA OCTAVIA (1U2) 1.8 T 4x4, SKODA OCTAVIA (1U2) 1.9 TDI … View more
The steps may slightly vary depending on the car design.
How to change a Front Springs on SKODA OCTAVIA 1U TUTORIAL | AUTODOC

All the parts you need to replace – Springs for OCTAVIA (1U2) and other SKODA models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
High-temperature ceramic grease
Torque wrench
HEX bit No.H6.
Combination spanner #18
Drive socket # 16
Drive socket # 18
Drive socket # 20.6
Wheel impact socket #17
Ratchet wrench
Hydraulic strut spring compressor
Hammer
Rubber mallet
Hydraulic transmission jack
Fender cover
Wheel chock
Replacement: coil springs – Skoda Octavia 1U. Tip from AUTODOC:
- Both coil springs of the front suspension should be replaced simultaneously.
- The replacement procedure is identical for the left and right coil springs of the front suspension.
- All work should be done with the engine stopped.
Replacement: coil springs – Skoda Octavia 1U. Use the following procedure:
- Step 1
Secure the wheels with chocks. - Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 3
Raise the front of the car and secure on supports. - Step 4
Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. Skoda Octavia 1U - Step 5
Remove the wheel. - Step 6Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.Step 7
Unscrew the fastener connecting the stabilizer link to the control arm. Use a drive socket #16. Use a ratchet wrench. - Step 8Remove the fastening bolt.Step 9Remove the stabilizer rod.Step 10
Disconnect the ABS sensor wiring. - Step 11
Clean the lower fastener connecting the suspension strut to the steering knuckle. Use a wire brush. Use WD-40 spray. - Step 12
Unscrew the lower fastener connecting the shock strut to the steering knuckle. Use a combination spanner #18. Use a drive socket #18. Use a ratchet wrench. - Step 13
Remove the fastening bolt. - Step 14
Disconnect the steering knuckle from the shock absorber strut. Use a rubber mallet. - Step 15
Lower the car. - Step 16
Open the bonnet. - Step 17
Use a fender protection cover to prevent damaging paintwork and plastic parts of the car. - Step 18
Clean the upper fastener of the suspension strut mount. Use a wire brush. Use WD-40 spray. - Step 19
Unscrew the top fasteners of the suspension strut mount. Use a drive socket #20.6. Use a ratchet wrench.AUTODOC recommends:Skoda Octavia 1U – To avoid injury, hold the suspension strut while unscrewing the fastening bolts. - Step 20
Remove the suspension strut. - Step 21
Set the shock absorber strut on the spring compressor tool.Replacement: coil springs – Skoda Octavia 1U. Tip from AUTODOC:Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles. - Step 22
Compress the spring. - Step 23
Treat the shock strut rod. Use a wire brush. Use WD-40 spray. - Step 24
Remove the strut piston rod nut. Use a drive socket #20.6. Use a ratchet wrench. - Step 25
Remove the top strut mount.AUTODOC recommends:Replacement: coil springs – Skoda Octavia 1U. Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary. - Step 26
Release the coil spring. - Step 27
Remove the spring. - Step 28Clean the coil spring mounting seats. Use a wire brush.Step 29
Install the spring on the shock absorber. - Step 30
Compress the spring. - Step 31
Install the upper strut mount and the strut mount bearing. - Step 32
Tighten the shock strut piston rod nut. Use a drive socket #20.6. Use HEX No.H6. Use a torque wrench. Tighten it to 60 Nm torque.Replacement: coil springs – Skoda Octavia 1U. AUTODOC recommends:Check to make sure the spring is positioned correctly. Avoid its misalignment.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the SKODA Octavia I Hatchback (1U2) model
Popular maintenance tutorials for Skoda Octavia 1u
Complete guides for changing the Springs on different SKODA OCTAVIA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your SKODA OCTAVIA (1U2)
View more
How to repair a bumper yourself | AUTODOC tips
Top 5 reasons why your car squeals | AUTODOC Tips
Coolant comparison test | AUTODOC
How to prevent car windows from fogging up | AUTODOC tips
Most commonly replaced car parts on SKODA OCTAVIA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME


































