Important!
This replacement procedure can be used for:
SKODA OCTAVIA (1U2) 1.6, SKODA OCTAVIA (1U2) 1.8, SKODA OCTAVIA (1U2) 1.9 TDI, SKODA OCTAVIA (1U2) 1.6, SKODA OCTAVIA (1U2) 1.9 SDI, SKODA OCTAVIA (1U2) 1.9 TDI, SKODA OCTAVIA (1U2) 1.8 T, SKODA OCTAVIA (1U2) 2.0, SKODA OCTAVIA (1U2) 1.4, SKODA OCTAVIA (1U2) 1.4 16V, SKODA OCTAVIA (1U2) 1.6, SKODA OCTAVIA (1U2) 1.9 TDI, SKODA OCTAVIA (1U2) 1.9 TDI View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Shock Absorber for OCTAVIA (1U2) and other SKODA models
Tools
Replacement: suspension strut – SKODA OCTAVIA (1U2). List of the tools you'll need:
Wire brush
WD-40 spray
Drive socket # 18
Drive socket # 13
Combination spanner #18
Combination spanner #19
Combination spanner #21
Drive socket # 19
HEX bit No.H6.
Torque wrench
Copper grease
Wheel impact socket #17
12-point socket 1-3/16”
Flare nut socket №22
Pin punch
Hammer
Shock absorber socket
Hydraulic transmission jack
Hydraulic strut spring compressor
Rubber mallet
Wheel chock
Fender cover
Replacement: suspension strut – SKODA OCTAVIA (1U2). Professionals recommend:
  • Both shock struts of the front suspension should be replaced simultaneously.
  • The replacement procedure is identical for the left and right shock struts of the front suspension.
  • All work should be done with the engine stopped.
  • You might need other tools.
Replacement: suspension strut – SKODA OCTAVIA (1U2). Use the following procedure:
  1. Step 1
    Open the bonnet.
    Step 2
    Secure the wheels with chocks.
    Step 3
    Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
    Step 4
    How to change Shock Absorber on Skoda Octavia 1u 1996 - free PDF and video manuals
    Remove the wheel rim cover.
  2. Step 5
    How to replace SKODA OCTAVIA (1U2) 1.9 TDI 1997 Shock Absorber - step-by-step manuals and video guides
    Unscrew the hub lock nut. Use 1-3/16" drive 12-point socket.
    Replacement: suspension strut – SKODA OCTAVIA (1U2). AUTODOC recommends:
    Do not unscrew the fastener by more than 90 degrees.
  3. Step 6
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
    Step 7
    Raise the front of the car and secure on supports.
    Step 8
    Skoda Octavia 1u 1.6 1998 Shock Absorber replacement: free workshop manuals
    Unscrew the wheel bolts.
    Replacement: suspension strut – SKODA OCTAVIA (1U2). AUTODOC experts recommend:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  4. Step 9
    Remove the wheel.
    Step 10
    Changing Shock Absorber on SKODA OCTAVIA (1U2) 1.8 T 1999 by yourself
    Disconnect the wiring and the brake hose from the bracket on the shock strut.
  5. Step 11
    How to remove SKODA OCTAVIA 2.0 2000 Shock Absorber - online easy-to-follow instructions
    Unscrew the fastener connecting the drive shaft to the wheel hub. Use 1-3/16" drive 12-point socket.
  6. Step 12
    How to replace Shock Absorber on SKODA OCTAVIA (1U2) 2001: download PDF manuals and video instructions
    Clean the fasteners connecting the shock strut to the steering knuckle. Clean the fasteners connecting the ball joint to the suspension control arm. Use a wire brush. Use WD-40 spray.
  7. Step 13
    How hard is it to do yourself: Shock Absorber replacement on Skoda Octavia 1u 1.9 TDI 2002 - download illustrated guide
    Unscrew the fastener connecting the ball joint to the suspension control arm. Use a drive socket #13.
  8. Step 14
    Disconnect the spherical joint from the arm.
    Step 15
    Need to know how to renew Shock Absorber on SKODA OCTAVIA 2003? This free workshop manual will help you to do it yourself
    Pull the drive shaft out of the steering knuckle and lifting it, tie to the body. Use a hammer. Use a pin punch.
    AUTODOC recommends:
    Make sure that the drive shaft is not unloaded (when the car is jacked).
  9. Step 16
    Changing of Shock Absorber on Skoda Octavia 1u 2004 won't be an issue if you follow this illustrated step-by-step guide
    Prop up the steering knuckle. Use a hydraulic transmission jack.
  10. Step 17
    SKODA OCTAVIA RS 1.8 T Shock Absorber replacement: online guides and video tutorials
    Unscrew the lower fastener connecting the shock strut to the steering knuckle. Use a combination spanner #18. Use a drive socket #18.
  11. Step 18
    Replacing Shock Absorber on Skoda Octavia 1u 2006 1.9 TDI by yourself
    Remove the support from under the steering knuckle.
  12. Step 19
    OCTAVIA (1U2) 2.0 2007 Shock Absorber DIY replacement workshop manual
    Release the lower fastener connecting the shock strut to the steering knuckle. Use a special drive socket to remove the shock absorber.
  13. Step 20
    How to change Shock Absorber on SKODA OCTAVIA (1U2) 2008 - tips and tricks
    Disconnect the steering knuckle from the shock absorber strut.
    Replacement: suspension strut – SKODA OCTAVIA (1U2). Tip:
    If necessary, use a rubber mallet.
  14. Step 21
    Step-by-step recommendations for DIY replacement Skoda Octavia 1u 2009 2.0 Shock Absorber
    Prop up the steering knuckle. Use a hydraulic transmission jack.
    AUTODOC recommends:
    Make sure that the steering knuckle is not released from load.
  15. Step 22
    DIY replacement of Shock Absorber on SKODA OCTAVIA (1U2) RS 1.8 T 2010 is not an issue anymore with our step-by-step tutorial
    Unscrew the upper fastening of the shock absorber strut. Use a combination spanner #21. Use HEX No.H6.
    Replacement: suspension strut – SKODA OCTAVIA (1U2). Tip from AUTODOC experts:
    To avoid injuries, hold the shock strut when undoing the fastening bolts.
  16. Step 23
    How to change Shock Absorber on Skoda Octavia 1u 1996 - free PDF and video manuals
    Remove the suspension strut. Set the shock absorber strut on the spring compressor tool.
    Replacement: suspension strut – SKODA OCTAVIA (1U2). Tip from AUTODOC:
    Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles.
  17. Step 24
    How to replace SKODA OCTAVIA (1U2) 1.9 TDI 1997 Shock Absorber - step-by-step manuals and video guides
    Compress the spring.
  18. Step 25
    Skoda Octavia 1u 1.6 1998 Shock Absorber replacement: free workshop manuals
    Remove the strut piston rod nut. Use flare nut socket #22. Use HEX No.H6.
  19. Step 26
    Changing Shock Absorber on SKODA OCTAVIA (1U2) 1.8 T 1999 by yourself
    Remove the top strut mount.
  20. Step 27
    How to remove SKODA OCTAVIA 2.0 2000 Shock Absorber - online easy-to-follow instructions
    Release the coil spring.
  21. Step 28
    How to replace Shock Absorber on SKODA OCTAVIA (1U2) 2001: download PDF manuals and video instructions
    Remove the spring.
  22. Step 29
    How hard is it to do yourself: Shock Absorber replacement on Skoda Octavia 1u 1.9 TDI 2002 - download illustrated guide
    Remove the shock absorber dust cap and the bump stop.
  23. Step 30
    Remove the old shock absorber from the hydraulic coil spring compressor.
    AUTODOC recommends:
    Replacement: suspension strut – SKODA OCTAVIA (1U2). Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.Before installing a new shock absorber you should pump it manually 3-5 times.
    Step 31
    Need to know how to renew Shock Absorber on SKODA OCTAVIA 2003? This free workshop manual will help you to do it yourself
    Install the new shock absorber on the hydraulic coil spring compressor.
  24. Step 32
    Changing of Shock Absorber on Skoda Octavia 1u 2004 won't be an issue if you follow this illustrated step-by-step guide
    Install the dust sleeve and the bump stop on the new shock absorber.
  25. Step 33
    SKODA OCTAVIA RS 1.8 T Shock Absorber replacement: online guides and video tutorials
    Install the spring on the shock absorber.
  26. Step 34
    Replacing Shock Absorber on Skoda Octavia 1u 2006 1.9 TDI by yourself
    Compress the spring.
  27. Step 35
    OCTAVIA (1U2) 2.0 2007 Shock Absorber DIY replacement workshop manual
    Install the upper strut mount and the strut mount bearing.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the SKODA Octavia I Hatchback (1U2) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
SKODA OCTAVIA (1U2) Shock Absorber replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY SKODA OCTAVIA (1U2) Shock Absorber replacement - online guide
Tips & tricks for your SKODA OCTAVIA (1U2)
View more
  • How to change Shocks on SKODA OCTAVIA (1U2) RS 1.8 T - replacement tricks
    What to do if your car heater isn't working | AUTODOC tips
  • Changing Shock absorbers Skoda Octavia 1u 1.9 TDI - Replacement Tips
    TOP 6 WD-40 lifehacks | AUTODOC tips
  • Maintenance Hacks - SKODA OCTAVIA (1U2) 1.6 Struts replacement guide
    How to shine your tyres | AUTODOC tips
  • Replace Struts and shocks on Skoda Octavia 1u - free video tips
    DIY jack restoration | AUTODOC tips