Disclaimer

How to change front coil springs on Citroen C3 1 – replacement guide

downloads: 8

Important!

This replacement procedure can be used for:
CITROËN C3 I Hatchback (FC_, FN_) 1.4 HDi … View more

The steps may slightly vary depending on the car design.

How to change front springs / front coil springs on CITROEN C3 1 (FC, FN) [TUTORIAL AUTODOC]

Alternative products

Coil spring

Replacement: coil springs – Citroen C3 1. Tools you might need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Copper grease 
                    
                      Combination spanner #16
                    
                      Combination spanner #17
                    
                      Combination spanner #22
                    
                      Drive socket # 16 
                    
                      Drive socket # 17 
                    
                      Drive socket # 19 
                    
                      Drive socket # 22 
                    
                      Drive socket # 30 
                    
                      HEX bit No.H7.
                    
                      Torx bit T30
                    
                      Wheel impact socket #17
                    
                      Shock absorber socket
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Flat chisel
                    
                      Pin punch
                    
                      Tap wrench
                    
                      Hammer
                    
                      Crow bar
                    
                      Hydraulic strut spring compressor
                    
                      Hydraulic transmission jack
                    
                      Fender cover
                    
                      Wheel chock

Buy tools

Replacement: coil springs – Citroen C3 1. AUTODOC experts recommend:

Both coil springs of the front suspension should be replaced simultaneously.
The replacement procedure is identical for the left and right coil springs of the front suspension.
All work should be done with the engine stopped.

Replacement: coil springs – Citroen C3 1. Use the following procedure:

Step 1

Open the bonnet.
Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
Step 3

Clean the fasteners of the shock strut upper mount. Use a wire brush. Use WD-40 spray.
Step 4

Loosen the upper fastener of the shock strut mount. Use HEX No.H7. Use a combination spanner #22. Use a ratchet wrench.
Step 5

Secure the wheels with chocks.
Step 6

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 7

Clean the fastener of the driveshaft. Use a wire brush. Use WD-40 spray.
Step 8

Unstake the fastener of the driveshaft. Use a flat metal-working chisel. Use a hammer.
Step 9

Loosen the fastener of the driveshaft. Use a drive socket #30. Use a tap wrench.
Step 10

Raise the front of the car and secure on supports.
Step 11

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. Citroen C3 1
Step 12

Remove the wheel.
Step 13

Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.
Step 14

Disconnect the wiring and the brake hose from the bracket on the shock strut. Use a crowbar.
Step 15

Unscrew the fastener connecting the stabilizer link to the shock strut. Use a combination spanner #17. Use Torx T30. Use a ratchet wrench.
Step 16

Remove the stabilizer rod.
Step 17

Clean the fasteners connecting the shock strut to the steering knuckle. Use a wire brush. Use WD-40 spray.
Step 18

Clean all joints of the arm. Use a wire brush. Use WD-40 spray.
Step 19

Unscrew the fastener connecting the ball joint to the suspension control arm. Use a drive socket #16. Use a combination spanner #16. Use a tap wrench.
Step 20

Disconnect the spherical joint from the arm.
Step 21

Unscrew the fastener connecting the drive shaft to the wheel hub. Use a drive socket #30.
Step 22

Remove the drive shaft. Use a pin punch. Use a hammer.
Step 23

Unscrew the lower fastener connecting the shock strut to the steering knuckle. Use a drive socket #16. Use a tap wrench.
Step 24

Remove the fastening bolt.
Step 25

Prop up the steering knuckle. Use a hydraulic transmission jack.
Step 26

Release the lower fastener connecting the shock strut to the steering knuckle. Use a special drive socket to remove the shock absorber. Use a ratchet wrench.
Step 27

Disconnect the steering knuckle from the shock absorber strut. Use a hammer.
Step 28

Unscrew the top fastening of the shock strut mount. Use a drive socket #22.

AUTODOC recommends:
Citroen C3 1 – To avoid injury, hold the suspension strut while screwing in the fastening bolts.
Step 29

Remove the suspension strut.
Step 30

Set the shock absorber strut on the spring compressor tool.

Replacement: coil springs – Citroen C3 1. AUTODOC experts recommend:
Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles.
Step 31

Compress the spring.
Step 32

Remove the strut piston rod nut. Use a drive socket #19. Use HEX No.H7. Use a ratchet wrench.
Step 33

Remove the top strut mount.
Step 34

Release the coil spring.
Step 35

Remove the spring.

AUTODOC recommends:
Replacement: coil springs – Citroen C3 1. Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.
Step 36

Install the spring on the shock absorber.
Step 37

Compress the spring.
Step 38

Install the upper strut mount and the strut mount bearing.
Step 39

Tighten the shock strut piston rod nut. Use HEX No.H7. Use a drive socket #19. Use a torque wrench. Tighten it to 60 Nm torque.

Replacement: coil springs – Citroen C3 1. AUTODOC recommends:
Check to make sure the spring is positioned correctly. Avoid its misalignment.
Step 40

Decompress the spring.
Step 41

Remove the assembled shock strut.
Step 42

Install the shock strut into the wheel arch.
Step 43

Screw the top fastening of the shock strut mount. Do not tighten it.

AUTODOC recommends:
Citroen C3 1 – To avoid injury, hold the suspension strut while screwing in the fastening bolts.
Step 44

Treat the shock strut mounting seat on the steering knuckle. Use a wire brush. Use WD-40 spray.
Step 45

Fix the shock absorber strut on the steering knuckle.
Step 46

Install the fastening bolt.
Step 47

Screw in the fastener that connects the shock strut to the steering knuckle. Use a drive socket #16.
Step 48

Remove the support from under the steering knuckle.

AUTODOC recommends:
Replacement: coil springs – Citroen C3 1. Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 49

Clean the splines of the drive shaft CV joint. Use a wire brush. Use WD-40 spray.
Step 50

Install the drive shaft.
Step 51

Attach the ball joint to the control arm.
Step 52

Screw the fasteners of the ball joint. Use a drive socket #16.
Step 53

Ιnstall the transverse stabilizer link.
Step 54

Tighten the stabiliser link fastener. Use a drive socket #17.
Step 55

Fasten the brake hose on the strut. Connect the fastener of the ABS sensor cable to the shock absorber strut.
Step 56

Tighten the lower fasteners connecting the shock strut to the steering knuckle. Use a drive socket #16. Use a torque wrench. Tighten it to 59 Nm torque.
Step 57

Tighten the fastener connecting the stabilizer link to the shock strut. Use a drive socket #17. Use a torque wrench. Tighten it to 35 Nm torque.
Step 58

Tighten the ball joint fastener. Use a drive socket #16. Use a combination spanner #16. Use a torque wrench. Tighten it to 52 Nm torque.
Step 59

Screw the nut of the drive shaft. Use a drive socket #30.
Step 60

Treat all joints of the arm. Treat the shock strut fasteners. Use copper grease.
Step 61

Treat all joints of the stabiliser link. Use copper grease.
Step 62

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 63

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 64

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. Citroen C3 1
Step 65

Screw in the wheel bolts. Use wheel impact socket #17.
Step 66

Lower the car.
Step 67

Tighten the drive shaft nut. Use a drive socket #30. Use a torque wrench. Tighten it to 245 Nm torque.
Step 68

Tighten the wheel bolts using a criss-cross pattern. Use a torque wrench. Tighten it to 90 Nm torque.
Step 69

Restake the fastener of the driveshaft. Use a flat metal-working chisel. Use a hammer.
Step 70

Tighten the upper fastener of the shock absorber strut mount. Use a drive socket #22. Use HEX No.H7. Use a torque wrench. Tighten it to 60 nm torque.
Step 71

Treat the shock strut fasteners. Use copper grease.
Step 72

Remove the jacks and chocks.
Step 73

Remove the fender protection cover.
Step 74

Close the hood.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the CITROËN C3 I Hatchback (FC, FN) model

Citroen C3 Mk1 tyre size

How to change front suspension strut on Citroen C3 1 – replacement guide

Free download PDF
3.86 MB
How to change rear shock absorbers on Citroen C3 1 – replacement guide

Free download PDF
2 MB
How to change rear coil springs on Citroen C3 1 – replacement guide

Free download PDF
1.49 MB
How to change front brake pads on Citroen C3 1 – replacement guide

Free download PDF
1.42 MB
How to change rear brake pads on CITROËN C3 I Hatchback (FC_, FN_) – replacement guide

Free download PDF
1.58 MB
How to change front brake discs on Citroen C3 1 – replacement guide

Free download PDF
1.87 MB

How to change rear coil springs on Citroen C3 1 – replacement guide

Free download PDF
1.49 MB
How to change coil springs on a car – replacement tutorial

Universal

Free download PDF
1.91 MB
How to change front coil springs on Citroen C1 1 PM PN – replacement guide

Free download PDF
5.07 MB
How to change rear coil springs on Citroen C1 1 PM PN – replacement guide

Free download PDF
1.59 MB
How to change front coil springs on Citroen Xsara Picasso – replacement guide

Free download PDF
3.78 MB
How to change front coil springs on CITROËN C1 II (PA, PS) – replacement guide

Free download PDF
5.08 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Fuse Replacement Made Simple: Step-by-Step Guide | AUTODOC

3K views

Published on: 15/08/2020
What to do if your car’s bonnet won’t open | AUTODOC tips

18K views

Published on: 12/09/2024
5 easy car repairs you can do without a garage visit

5K views

Published on: 09/10/2025
TOP 5 mistakes during DIY oil change | AUTODOC tips

37K views

Published on: 17/06/2021