Important!

This replacement procedure can be used for:
PEUGEOT 308 II Box Body / Hatchback (T9) 1.6 BlueHDi (LBBHZM), PEUGEOT 308 II Box Body / Hatchback (T9) 1.6 e-HDi (LB9HCG) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Anti-roll bar link

Replacement: anti roll bar links – PEUGEOT 308 II Kasten / Schrägheck (T9). Tools you need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Copper grease 
                    
                      Combination spanner #16
                    
                      Drive socket # 15 
                    
                      Drive socket # 17 
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Wheel chock

Buy tools

Replacement: anti roll bar links – PEUGEOT 308 II Kasten / Schrägheck (T9). AUTODOC experts recommend:

Replace the stabiliser links on PEUGEOT 308 II Kasten / Schrägheck (T9) in pairs.
The replacement procedure is identical for both stabiliser links on the same axle.
All work should be done with the engine stopped.

Replacement: anti roll bar links – PEUGEOT 308 II Kasten / Schrägheck (T9). Recommended sequence of steps:

Step 1

Secure the wheels with chocks.

Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 3

Raise the front of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

Replacement: anti roll bar links – PEUGEOT 308 II Kasten / Schrägheck (T9). AUTODOC recommends:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 5

Remove the wheel.
Step 6

Remove the ABS wiring harness bracket.
Step 7

Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Unscrew the fastener connecting the stabilizer link to the shock strut. Use a drive socket #15. Use a ratchet wrench.
Step 9

Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.
Step 10

Unscrew the fastener connecting the stabilizer link to the stabilizer bar. Use a combination spanner #16. Use a drive socket #15. Use a ratchet wrench.
Step 11

Remove the stabilizer rod.

Replacement: anti roll bar links – PEUGEOT 308 II Kasten / Schrägheck (T9). Tip from AUTODOC experts:
Examine stabiliser bushes. Replace them if needed.
Step 12

Clean the mounting seats of the stabiliser link. Use a wire brush. Use WD-40 spray.
Step 13

Install a new rod, tighten the fasteners.
Step 14

Tighten the fastener connecting the stabilizer link to the stabilizer bar. Use a drive socket #17. Use a torque wrench. Tighten it to 36 Nm torque.
Step 15

Tighten the fastener connecting the stabilizer link to the shock strut. Use a drive socket #17. Use a torque wrench. Tighten it to 36 Nm torque.
Step 16

Treat all joints of the stabiliser link. Use copper grease.
Step 17

Install the ABS wiring harness bracket.
Step 18

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 19

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: anti roll bar links – PEUGEOT 308 II Kasten / Schrägheck (T9). After applying the spray, wait a few minutes.
Step 20

Install the wheel.

Replacement: anti roll bar links – PEUGEOT 308 II Kasten / Schrägheck (T9). Tip from AUTODOC:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 21

Screw in the wheel bolts. Use wheel impact socket #17.
Step 22

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 100 nm torque.
Step 23

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the PEUGEOT 308 II Box Body / Hatchback (T9) model

PEUGEOT 308 II Kasten / Schrägheck (T9) tyre size

How to change front windshield wipers on PEUGEOT 308 II Box Body / Hatchback (T9) – replacement guide

Free download PDF
522.24 KB
How to change water pump & timing belt kit on Peugeot 307 SW – replacement guide

Free download PDF
7.01 MB
How to change fuel filter on Peugeot 206 CC 2D – replacement guide

Free download PDF
1.12 MB
How to change engine oil and filter on Peugeot 308 I – replacement guide

Free download PDF
3.3 MB
How to change engine oil and filter on Peugeot 207 hatchback – replacement guide

Free download PDF
1.96 MB
How to change serpentine belt on Peugeot 207 hatchback – replacement guide

Free download PDF
1.63 MB

How to change front anti roll bar links on PEUGEOT 308 II Hatchback – replacement guide

Free download PDF
1.33 MB
How to change front anti roll bar links on PEUGEOT 308 I Hatchback (4A, 4C) – replacement guide

Free download PDF
1.33 MB
How to change front anti roll bar links on PEUGEOT 308 II SW – replacement guide

Free download PDF
1.33 MB
How to change front anti roll bar links on PEUGEOT 308 I SW (4E, 4H) – replacement guide

Free download PDF
1.33 MB
How to change front anti roll bar links on PEUGEOT 308 I CC (4B) – replacement guide

Free download PDF
1.34 MB
How to change front anti roll bar links on PEUGEOT 308 II SW Box Body / Estate (LC_) – replacement guide

Free download PDF
1.35 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Deep interior cleaning | Car transformation by detailing

7K views

Published on: 05/09/2024
#DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit

9K views

Published on: 14/12/2023
How to Prevent Premature Wear on Your Car Boot Damper | AUTODOC

5K views

Published on: 04/07/2021
5 reasons why your car is making a knocking sound

11K views

Published on: 05/06/2025