Disclaimer
How to change front anti roll bar links on NISSAN Murano II (Z51) – replacement guide
downloads:
2
Views:
43
Important!
This replacement procedure can be used for:
NISSAN MURANO (Z51) 3.5 4x4, NISSAN MURANO (Z51) 3.5 4x4, NISSAN MURANO (Z51) 2.5 dCi 4x4 … View more
The steps may slightly vary depending on the car design.
NISSAN MURANO (Z51) 3.5 4x4, NISSAN MURANO (Z51) 3.5 4x4, NISSAN MURANO (Z51) 2.5 dCi 4x4 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Anti Roll Bar Links for MURANO (Z51) and other NISSAN models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Torque wrench
Combination spanner #17
Combination spanner #19
Combination spanner #21
Drive socket # 19
Drive socket # 21
Wheel impact socket #21
Ratchet wrench
Wheel chock
Replacement: anti roll bar links – NISSAN MURANO (Z51). Tip from AUTODOC experts:
- Replace the stabiliser links on NISSAN MURANO (Z51) in pairs.
- The replacement procedure is identical for both stabiliser links on the same axle.
- Please note: all work on the car – NISSAN MURANO (Z51) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Secure the wheels with chocks.Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #21. - Step 3Raise the front of the car and secure on supports.Step 4
Unscrew the wheel bolts.Replacement: anti roll bar links – NISSAN MURANO (Z51). Tip:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 5
Remove the wheel. - Step 6
Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray. - Step 7
Unscrew the fastener connecting the stabilizer link to the shock strut. Use a drive socket #21. Use a ratchet wrench. - Step 8
Unscrew the fasteners connecting the stabiliser link to the stabiliser bar. Use a combination spanner #17. Use a combination spanner #21. - Step 9
Remove the stabilizer rod.Replacement: anti roll bar links – NISSAN MURANO (Z51). AUTODOC recommends:Examine stabiliser bushes. Replace them if needed. - Step 10
Clean the mounting seats of the stabiliser link. Use a wire brush. Use WD-40 spray. - Step 11
Install a new rod, tighten the fasteners.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the NISSAN Murano II (Z51) model
Popular maintenance tutorials for Nissan Murano Z51
Complete guides for changing the Drop links on different NISSAN MURANO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your NISSAN MURANO (Z51)
View more
5 Ways You’re Scrubbing Your Car Wrong | AUTODOC Tips
#DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit
5 more brake repair mistakes | Stop making these brake repair mistakes
How to align the timing marks correctly on an EA888 engine
Most commonly replaced car parts on NISSAN MURANO
Time to replace parts? Get even better deals in our Shop app.

SCAN ME

























