Disclaimer
How to change engine oil and filter on TOYOTA Starlet Hatchback 1000 (KP_) – replacement guide
downloads:
0
Views:
14
Recommended replacement interval for the part category Oil filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
TOYOTA Starlet Hatchback 1000 (KP_) 1.0 (KP30_) … View more
The steps may slightly vary depending on the car design.
TOYOTA Starlet Hatchback 1000 (KP_) 1.0 (KP30_) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for Starlet Hatchback 1000 (KP_) and other TOYOTA models
Alternative products

Wire brush
All-purpose cleaning spray
Drive socket # 12
Drive socket # 15
Oil filter cup socket 76-14F
Ratchet wrench
Torque wrench
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – TOYOTA STARLET 1000 (KP). AUTODOC experts recommend:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Please note: all work on the car – TOYOTA STARLET 1000 (KP) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the oil filler plug. - Step 4
Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – TOYOTA STARLET 1000 (KP). Tip from AUTODOC:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All work should be done with the engine stopped. - Step 5
Undo the fasteners of the oil pan lower cover. Use a drive socket #12. - Step 6
Remove the oil pan cover. - Step 7
Clean the cap of the oil filler neck. Use a wire brush. Use all-purpose cleaning spray. - Step 8
Put a waste oil container with at least 5 l capacity under the drainage hole. - Step 9
Unscrew the drain plug. Use a drive socket #15. Use a ratchet wrench. - Step 10
Drain the used oil.Replacement: engine oil and filter – TOYOTA STARLET 1000 (KP). AUTODOC experts recommend:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 11Prepare a container for the old oil filter.Step 12
Unscrew the oil filter. Use the 76-14F socket. Use a ratchet wrench. - Step 13Put the old oil filter in the container.Replacement: engine oil and filter – TOYOTA STARLET 1000 (KP). AUTODOC recommends:Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.Step 14
Clean the oil filter seat. - Step 15
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 16
Screw the new filter into its place. Use the 76-14F socket. Use a torque wrench. Tighten it to 17 Nm torque. - Step 17
Clean the area of the oil pan drainage hole.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the TOYOTA Starlet 1000 Hatchback (KP30) model
Popular maintenance tutorials for TOYOTA STARLET 1000 (KP)
Complete guides for changing the Oil filters on different TOYOTA STARLET models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your TOYOTA Starlet Hatchback 1000 (KP_)
View more
TOP 5 mistakes when replacing shock absorbers | AUTODOC tips
5 causes of turbocharger failure and how to avoid them
5 signs of a faulty strut mount and how to fix it
2 ways to clean the EGR valve – which one is better?
Most commonly replaced car parts on TOYOTA STARLET
Time to replace parts? Get even better deals in our Shop app.

SCAN ME































