How to change engine oil and filter on Toyota Auris E15 – replacement guide
downloads:
24
Views:
772
0
Users voted – 0
Recommended replacement interval for the part category Oil filter : 1year / 15000km
Important!
This replacement procedure can be used for:
TOYOTA AURIS (NRE15_, ZZE15_, ADE15_, ZRE15_, NDE15_) 1.5 (NZE151_),
TOYOTA AURIS (NRE15_, ZZE15_, ADE15_, ZRE15_, NDE15_) 1.6 (ZRE151_),
TOYOTA AURIS (NRE15_, ZZE15_, ADE15_, ZRE15_, NDE15_) 1.8 (ZRE152_)
…
View more
The steps may slightly vary depending on the car design.
How to change oil filter and engine oil on TOYOTA AURIS 1 (E150) [TUTORIAL AUTODOC]
All the parts you need to replace – Oil Filter for AURIS (NRE15_, ZZE15_, ADE15_, ZRE15_, NDE15_) and other TOYOTA models
Replacement: engine oil and filter – Toyota Auris E15. AUTODOC experts recommend:
Replace the oil filter every time when changing motor oil.
All work should be done with the engine stopped.
Wear gloves to prevent contact with hot liquid.
Replacement: engine oil and filter – Toyota Auris E15. Use the following procedure:
Step 1
Open the hood.
Step 2
Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
Step 3
Unscrew the oil filler plug.
Step 4
Lift the car using a jack or place it over an inspection pit.
Replacement: engine oil and filter – Toyota Auris E15. AUTODOC experts recommend:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
Step 5
Undo the fasteners of the oil pan lower cover. Use a clip removal tool.
Step 6
Remove the oil pan cover.
Step 7
Put a waste oil container with at least 5 l capacity under the drainage hole.
Step 8
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
Step 9
Unscrew the drain plug. Use a combination spanner #14. Use a drive socket #14. Use a ratchet wrench.
Step 10
Drain the used oil.
Replacement: engine oil and filter – Toyota Auris E15. Tip from AUTODOC:
Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
Step 11
Prepare a container for the old oil filter.
Step 12
Unscrew the filter housing cap together with the old filter element. Use the 67-14F socket. Use a ratchet wrench.
Step 13
Put the old oil filter in the container.
Replacement: engine oil and filter – Toyota Auris E15. Tip from AUTODOC experts:
Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
Step 14
Detach the oil filter from the filter cover.
Step 15
Remove the oil filter cover O-ring. Use a flat screwdriver.
Step 16
Clean the oil filter housing cap. Use all-purpose cleaning spray.
Step 17
Install a new O-ring to its mounting seat on the filter cover.
Step 18
Install the new oil filter to the mounting seat on the filter cover.
Please note!
Make sure to install the filter correctly. Don't mix up the sides of the part.
Step 19
Clean the oil filter seat. Use all-purpose cleaning spray.
Step 20
Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 21
Screw the new filter into its place.
Step 22
Screw the cap. Use the 67-14F socket. Use a torque wrench. Tighten it to 25 Nm torque.
Step 23
Clean the area of the oil pan drainage hole.
Step 24
Screw in the new drainage plug and tighten it. Use a drive socket #14. Use a torque wrench. Tighten it to 27 Nm torque.
Step 25
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 26
Reinstall the oil pan lower cover.
Step 27
Tighten the fasteners of the oil pan lower cover.
Step 28
Lower the car.
Step 29
Remove the oil filler cap.
Step 30
Insert the funnel.
Step 31
Pour oil into the engine through the filler. Required amount of oil: 4 l.
Replacement: engine oil and filter – Toyota Auris E15. Tip:
Use the oil recommended by the manufacturer.
Step 32
Check the oil level using the dipstick. Top up oil if necessary.
Please note!
The oil level should be between the Min and Max marks.
Step 33
Install the oil filler cap. Tighten the oil filler cap.
Step 34
Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.
Step 35
Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.
Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 36
Remove the fender protection cover.
Step 37
Close the hood.
Replacement: engine oil and filter – Toyota Auris E15. AUTODOC experts recommend:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?
Find out which tyre and wheel sizes are compatible with the TOYOTA Auris Hatchback (E15) model.
It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents
Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
Scan
To download the app:
- scan the QR code
- download from App Store
- download from Google Play
Tips & tricks for your TOYOTA AURIS (NRE15_, ZZE15_, ADE15_, ZRE15_, NDE15_)