Recommended replacement interval for the part category Oil filter : 12 month / 15000 km

Important!

This replacement procedure can be used for:
TOYOTA bB II (QNC2_) 1.5 (QNC21) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Oil filter

Replacement: engine oil and filter – TOYOTA bB II (QNC2_). Tools you need:

                      Wire brush
                    
                      All-purpose cleaning spray
                    
                      Drive socket # 12 
                    
                      Drive socket # 15 
                    
                      Oil filter cup socket 76-14F
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Oil drain pan
                    
                      Funnel
                    
                      Fender cover

Buy tools

Replacement: engine oil and filter – TOYOTA bB II (QNC2_). AUTODOC experts recommend:

Replace the oil filter every time when changing motor oil.
Wear gloves to prevent contact with hot liquid.
Please note: all work on the car – TOYOTA bB II (QNC2_) – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Unscrew the oil filler plug.
Step 4

Lift the car using a jack or place it over an inspection pit.

Replacement: engine oil and filter – TOYOTA bB II (QNC2_). Tip from AUTODOC:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All work should be done with the engine stopped.
Step 5

Undo the fasteners of the oil pan lower cover. Use a drive socket #12.
Step 6

Remove the oil pan cover.
Step 7

Clean the cap of the oil filler neck. Use a wire brush. Use all-purpose cleaning spray.
Step 8

Put a waste oil container with at least 5 l capacity under the drainage hole.
Step 9

Unscrew the drain plug. Use a drive socket #15. Use a ratchet wrench.
Step 10

Drain the used oil.

Replacement: engine oil and filter – TOYOTA bB II (QNC2_). AUTODOC experts recommend:
Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
Step 11

Prepare a container for the old oil filter.

Step 12

Unscrew the oil filter. Use the 76-14F socket. Use a ratchet wrench.
Step 13

Put the old oil filter in the container.

Replacement: engine oil and filter – TOYOTA bB II (QNC2_). AUTODOC recommends:
Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
Step 14

Clean the oil filter seat.
Step 15

Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 16

Screw the new filter into its place. Use the 76-14F socket. Use a torque wrench. Tighten it to 17 Nm torque.
Step 17

Clean the area of the oil pan drainage hole.
Step 18

Screw in the new drainage plug and tighten it. Use a drive socket #15. Use a torque wrench. Tighten it to 27 Nm torque.
Step 19

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 20

Reinstall the oil pan lower cover.
Step 21

Tighten the fasteners of the oil pan lower cover. Use a drive socket #12.
Step 22

Lower the car.

Step 23

Remove the oil filler cap. Insert the funnel.
Step 24

Pour new oil into the engine in the amount recommended by the car manufacturer.

Replacement: engine oil and filter – TOYOTA bB II (QNC2_). Tip:
Use the oil recommended by the manufacturer.
Step 25

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 26

Tighten the oil filler cap.
Step 27

Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.
Step 28

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 29

Remove the fender protection cover.

Step 30

Close the hood.

Replacement: engine oil and filter – TOYOTA bB II (QNC2_). Tip from AUTODOC experts:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the TOYOTA bB II model

bB II tyre size

How to change pollen filter on TOYOTA bB II (QNC2_) – replacement guide

Free download PDF
655.36 KB
How to change engine oil and filter on Toyota Aygo AB1 – replacement guide

Free download PDF
2.32 MB
How to change engine oil and filter on Toyota Auris E15 – replacement guide

Free download PDF
2.23 MB
How to change front brake pads on Toyota Prado J120 – replacement guide

Free download PDF
2.08 MB
How to change rear brake shoes on Toyota Yaris P1 – replacement guide

Free download PDF
2.32 MB
How to change rear brake pads on Toyota Auris E15 – replacement guide

Free download PDF
1.53 MB

How to change engine oil and filter on TOYOTA bB I – replacement guide

Free download PDF
2.03 MB
How to change engine oil and filter on a car – replacement tutorial

Universal

Free download PDF
2.82 MB
How to change engine oil and filter on Toyota Aygo AB1 – replacement guide

Free download PDF
2.32 MB
How to change engine oil and filter on Toyota Auris E15 – replacement guide

Free download PDF
2.23 MB
How to change engine oil and filter on Toyota Prado J120 – replacement guide

Free download PDF
2.23 MB
How to change engine oil and filter on Toyota Yaris Mk2 – replacement guide

Free download PDF
1.87 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

5 tools that make car repair incredibly simple | AUTODOC tips

49K views

Published on: 25/01/2024
Top 4 Car Cleaning Products to Protect Your Car's Body | AUTODOC Tips

2K views

Published on: 26/08/2021
Motorcycle fuel tank restoration

3K views

Published on: 03/07/2025
#DIY guide: Changing your car's color with a spray can | AUTODOC tips

6K views

Published on: 25/03/2021