Disclaimer
How to change engine oil and filter on OPEL MANTA B (58_, 59_) – replacement guide
downloads:
0
Views:
9
Recommended replacement interval for the part category Oil filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
OPEL MANTA B (58_, 59_) 1.8 S … View more
The steps may slightly vary depending on the car design.
OPEL MANTA B (58_, 59_) 1.8 S … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for MANTA B (58_, 59_) and other OPEL models
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Torx bit T40
Oil filter cup socket 76-F14
Ratchet wrench
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – OPEL MANTA B (58_, 59_). AUTODOC recommends:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Please note: all work on the car – OPEL MANTA B (58_, 59_) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the oil filler plug. - Step 4Lift the car using a jack or place it over an inspection pit.Step 5
Put a waste oil container with at least 4 l capacity under the drainage hole. - Step 6
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray. - Step 7
Unscrew the drain plug. Use Torx T40. Use a ratchet wrench. - Step 8
Drain the used oil.Replacement: engine oil and filter – OPEL MANTA B (58_, 59_). Professionals recommend:Caution! The oil may be hot. - Step 9
Clean the oil filter. Use all-purpose cleaning spray. - Step 10
Unscrew the oil filter. Use the 76-F14 socket. Use a ratchet wrench. - Step 11
Put the old oil filter in the container.Replacement: engine oil and filter – OPEL MANTA B (58_, 59_). Tip from AUTODOC experts:Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter. - Step 12
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 13
Install a new oil filter.Please note!Make sure to install the filter correctly. Don't mix up the sides of the part. - Step 14
Tighten the oil filter. Remember to observe the recommended tightening torque. Use the 76-F14 socket. Use a torque wrench. Tighten it to 18 Nm torque.Replacement: engine oil and filter – OPEL MANTA B (58_, 59_). Tip:Wait until the oil has completely drained from the drainage hole. - Step 15
Clean the area of the oil pan drainage hole. - Step 16
Screw in the new drainage plug and tighten it. Use Torx T40. Use a torque wrench. Tighten it to 24 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the OPEL Manta B Saloon model
Popular maintenance tutorials for Opel Manta B
Complete guides for changing the Oil filters on different OPEL MANTA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your OPEL MANTA B (58_, 59_)
View more
Reviving Your Car: How to Start After Extended Idle Time | AUTODOC Tips
Understanding Airbag Light Warnings | Essential Tips for Car Safety
How to tighten cylinder head bolts
#DIY guide: Changing your car's color with a spray can | AUTODOC tips
Most commonly replaced car parts on OPEL MANTA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME





















