Disclaimer
How to change engine oil and filter on OPEL INSIGNIA A Country Tourer (G09) – replacement guide
downloads:
2
Views:
112
Recommended replacement interval for the part category Oil filter : 1 year / 30000 km
Important!
This replacement procedure can be used for:
OPEL INSIGNIA A Country Tourer (G09) 1.6 SIDI (47) … View more
The steps may slightly vary depending on the car design.
OPEL INSIGNIA A Country Tourer (G09) 1.6 SIDI (47) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for INSIGNIA A Country Tourer (G09) and other OPEL models
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Drive socket # 24
Torx bit T45
Ratchet wrench
Flat screwdriver
Oil drain pan
Funnel
Microfibre towel
Fender cover
Replacement: engine oil and filter – OPEL INSIGNIA A Country Tourer (G09). Tip from AUTODOC:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Please note: all work on the car – OPEL INSIGNIA A Country Tourer (G09) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the oil filler plug. - Step 4
Clean the oil filter housing cap. Use all-purpose cleaning spray. - Step 5
Unscrew the filter housing cap together with the old filter element. Use a drive socket #24. Use a ratchet wrench. - Step 6Prepare a container for the old oil filter.Step 7
Put the old filter cartridge in the container. - Step 8Cover the oil filter housing with a microfibre towel to prevent dirt and foreign objects from getting into the system.Step 9Lift the car using a jack or place it over an inspection pit.AUTODOC recommends:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 10
Put a waste oil container with at least 5 l capacity under the drainage hole. - Step 11
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray. - Step 12
Unscrew the drain plug. Use Torx T45. Use a ratchet wrench. - Step 13
Drain the used oil.Replacement: engine oil and filter – OPEL INSIGNIA A Country Tourer (G09). AUTODOC recommends:Caution! The oil may be hot. - Step 14Detach the oil filter from the filter cover.Step 15
Remove the oil filter cover O-ring. Use a flat screwdriver. - Step 16
Clean the oil filter housing cap. Use all-purpose cleaning spray. - Step 17
Install a new O-ring to its mounting seat on the filter cover. - Step 18
Install a new oil filter.Please note!Make sure to install the filter correctly. Don't mix up the sides of the part.Wait until the oil has completely drained from the drainage hole. - Step 19
Clean the area of the oil pan drainage hole. - Step 20
Screw in the new drainage plug and tighten it. Use Torx T45. Use a torque wrench. Tighten it to 14 nm torque. - Step 21
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the OPEL Insignia A Country Tourer (G09) model
Popular maintenance tutorials for Opel Insignia A Country Tourer
Complete guides for changing the Oil filters on different OPEL INSIGNIA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your OPEL INSIGNIA A Country Tourer (G09)
View more
When, why, and how to change engine oil | AUTODOC tips
How to fix your car with AUTODOC CLUB
How to restore a steering wheel | AUTODOC tips
BMW E30 Turbo Suspension Swap: Boost Your Handling | AUTODOC project
Most commonly replaced car parts on OPEL INSIGNIA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME






















