How to change engine oil and filter on Nissan Micra K12 – replacement guide
downloads:
37
Views:
2680
0
Users voted – 0
Recommended replacement interval for the part category Oil filter : 15000km
Important!
This replacement procedure can be used for:
NISSAN MICRA III (K12) 1.2 16V,
NISSAN MICRA III (K12) 1.2 16V,
NISSAN MICRA III (K12) 1.0 16V,
NISSAN MICRA III (K12) 1.2 LPG
…
View more
The steps may slightly vary depending on the car design.
How to change oil filter and engine oil on NISSAN MICRA K12 [TUTORIAL AUTODOC]
All the parts you need to replace – Oil Filter for MICRA III (K12) and other NISSAN models
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out.
Step 28
Check the oil level with a dipstick 5 minutes after turning the engine off and add oil if necessary.
Please note!
The oil level should be between the Min and Max marks.
Step 29
Make sure that the oil filler cap is properly tightened.
Step 30
Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 31
Remove the fender protection cover.
Step 32
Close the bonnet.
Replacement: engine oil and filter – Nissan Micra K12. Tip from AUTODOC experts:
To protect the environment from pollution, be sure to dispose of the used filters at special collection points.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the NISSAN Micra III Hatchback (K12) model