Advice on diagnosing a burnt or bent valve
PEUGEOT 308 I Hatchback (4A_, 4C_)
7 
71 
16.02.24 Back to topics
Peugeot 3008 license plate light
PEUGEOT 3008 (0U_)
-
PEUGEOT 3008 (0U_) 2.0 HDi@user_561483 Sep 15, 2021MemberHello I wish to change my standard lights to led for the rear license plate but I’m finding it very tricky do I need to remove the boot cover to do this
Reply 15.09.21 
29.09.21 - @Chise1942 Sep 29, 2021MemberTo access the plafones, you need to partially unfasten the fold-over strip.Remove the seal, take out the plugs. For the seal, there are 4 Torx screws.Plus two screws on the sides. Bend the lid and there is an operational space and access to the shades. Unfasten the plafond.And a pin chip. And squeeze them out. Lift the lid and remove the curtains.Leave the lid in an upright position and install new shades, connect the contact pieces. Reassemble in reverse order.Reply
Only registered users may reply to topics and posts
Other PEUGEOT topics that might interest you
Section Subsection Views Activity
7 71 16.02.24 Camshaft & Crankshaft correlation.
PEUGEOT 5008 (0U_, 0E_)
5 1047 23.08.21 Bizarre fault ….
PEUGEOT 207 CC (WD_)
4 632 25.12.21 Replacing the oil filter gaskets
PEUGEOT 407 SW (6E_)
3 501 24.09.20 3008 licence plate light fitting replacement
PEUGEOT 3008 (0U_)
3 629 19.10.20 Over revving
PEUGEOT 207
3 224 25.07.23 Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
Scan To download the app:
- scan the QR code
- download from App Store
- download from Google Play
