Disclaimer
How to change front lower arm on Audi A4 B6 Avant – replacement guide
downloads:
13
Views:
272
Important!
This replacement procedure can be used for:
AUDI A4 Avant (8E5, B6) 1.6, AUDI A4 Avant (8E5, B6) 2.0, AUDI A4 Avant (8E5, B6) 1.8 T, AUDI A4 Avant (8E5, B6) 3.0, AUDI A4 Avant (8E5, B6) 1.9 TDI, AUDI A4 Avant (8E5, B6) 2.4, AUDI A4 Avant (8E5, B6) 2.5 TDI quattro, AUDI A4 Avant (8E5, B6) 2.5 TDI, AUDI A4 Avant (8E5, B6) 1.8 T quattro, AUDI A4 Avant (8E5, B6) 3.0 quattro, AUDI A4 Avant (8E5, B6) 1.9 TDI quattro, AUDI A4 Avant (8E5, B6) 2.0 FSI, AUDI A4 Avant (8E5, B6) 1.8 T, AUDI A4 Avant (8E5, B6) 1.8 T quattro, AUDI A4 Avant (8E5, B6) 2.5 TDI, AUDI A4 Avant (8E5, B6) 2.4, AUDI A4 Avant (8E5, B6) 1.8 T, AUDI A4 Avant (8E5, B6) 1.8 T quattro, AUDI A4 Avant (8E5, B6) S4 quattro, AUDI A4 Avant (8E5, B6) 1.9 TDI, AUDI A4 Avant (8E5, B6) 3.0, AUDI A4 Avant (8E5, B6) 3.0 quattro … View more
The steps may slightly vary depending on the car design.
AUDI A4 Avant (8E5, B6) 1.6, AUDI A4 Avant (8E5, B6) 2.0, AUDI A4 Avant (8E5, B6) 1.8 T, AUDI A4 Avant (8E5, B6) 3.0, AUDI A4 Avant (8E5, B6) 1.9 TDI, AUDI A4 Avant (8E5, B6) 2.4, AUDI A4 Avant (8E5, B6) 2.5 TDI quattro, AUDI A4 Avant (8E5, B6) 2.5 TDI, AUDI A4 Avant (8E5, B6) 1.8 T quattro, AUDI A4 Avant (8E5, B6) 3.0 quattro, AUDI A4 Avant (8E5, B6) 1.9 TDI quattro, AUDI A4 Avant (8E5, B6) 2.0 FSI, AUDI A4 Avant (8E5, B6) 1.8 T, AUDI A4 Avant (8E5, B6) 1.8 T quattro, AUDI A4 Avant (8E5, B6) 2.5 TDI, AUDI A4 Avant (8E5, B6) 2.4, AUDI A4 Avant (8E5, B6) 1.8 T, AUDI A4 Avant (8E5, B6) 1.8 T quattro, AUDI A4 Avant (8E5, B6) S4 quattro, AUDI A4 Avant (8E5, B6) 1.9 TDI, AUDI A4 Avant (8E5, B6) 3.0, AUDI A4 Avant (8E5, B6) 3.0 quattro … View more
The steps may slightly vary depending on the car design.
How to change front suspension arm / front control arm on AUDI A4 B6 (8E5) [TUTORIAL AUTODOC]

All the parts you need to replace – Control Arm for A4 Avant (8E5, B6) and other AUDI models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Multipurpose grease
Copper grease
Combination spanner #18
Drive socket # 10
Drive socket # 18
Wheel impact socket #17
Ratchet wrench
Torque wrench
Phillips screwdriver
Flat Screwdriver
Ball joint puller
Crow bar
Hydraulic transmission jack
Wheel chock
Replacement: front lower arm – Audi A4 B6 Avant. AUTODOC experts recommend:
- The replacement procedure is identical for the left and right lower control arms.
- All work should be done with the engine stopped.
Replacement: front lower arm – Audi A4 B6 Avant. Use the following procedure:
- Step 1
Secure the wheels with chocks. - Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 3
Raise the front of the car and secure on supports. - Step 4
Unscrew the wheel bolts.AUTODOC recommends:Important! Hold the wheel while unscrewing the fastening bolts. Audi A4 B6 Avant - Step 5
Remove the wheel. - Step 6
Unscrew fixing bolts of the protective cover. Use a flat screwdriver. - Step 7
Remove the protective cover. - Step 8
Clean all joints of the arm. Use a wire brush. Use WD-40 spray.Replacement: front lower arm – Audi A4 B6 Avant. Tip:After applying the spray, wait a few minutes.Wear protective goggles. - Step 9
Unscrew the ball joint fastening to the steering knuckle. Use a combination spanner #18. - Step 10
Disconnect the ball joint from the steering knuckle. Use a ball joint puller. - Step 11
Unscrew the rear fastener connecting the control arm to the subframe. Use a combination spanner #18 (2 pieces). - Step 12
Unscrew and remove the wheel arch cover fasteners. Use a Phillips screwdriver. Use a drive socket #10. Use a ratchet wrench. - Step 13
Remove the fastening bolt. Use a crowbar. - Step 14
Remove the arm. - Step 15
Clean the mounting seats and the thread of the suspension arm. Use a wire brush. Use WD-40 spray. - Step 16
Install a new arm.Replacement: front lower arm – Audi A4 B6 Avant. AUTODOC recommends:During the installation process, use only new bolts and nuts.Do not damage the ball joint cover. - Step 17
Install the fastening bolt. - Step 18
Screw the rear fastener connecting the control arm to the subframe. Use a combination spanner #18 (2 pieces). - Step 19
Treat all joints of the arm. Use a multipurpose grease. Use a flat screwdriver. - Step 20
Connect the ball joint to the steering knuckle.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the AUDI A4 B6 Avant (8E5) model
Popular maintenance tutorials for Audi A4 B6 Avant
Complete guides for changing the Control arm on different AUDI A4 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your AUDI A4 Avant (8E5, B6)
View more
How to Fix P0401 ✅ error code Insufficient EGR flow
5 mistakes made when washing the engine | AUTODOC tips
DIY engine block coffee table
5 signs of a faulty strut mount and how to fix it
Most commonly replaced car parts on AUDI A4
Time to replace parts? Get even better deals in our Shop app.

SCAN ME
































