When to replace the Wheel Cylinder on your OPEL TIGRA
Recommended replacement interval for the part category Wheel Brake Cylinder : 60000 km
Important!
This replacement procedure can be used for:
OPEL Tigra Coupe (S93) 1.4 16V (F07), OPEL Tigra Coupe (S93) 1.6 16V (F07), OPEL Tigra Coupe (S93) 1.4 16V (F07), OPEL Tigra Coupe (S93) 1.6 16V (F07) View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Tools
Replacement: wheel cylinder – OPEL TIGRA (95_). Tools you'll need:
Wire brush
WD-40 spray
Copper grease
Drive socket # 10
Combination spanner #9
Combination spanner #24
Flare Nut Wrench № 10
Wheel impact socket #17
Ratchet wrench
Torque wrench
Round-nose pliers
Rubber mallet
Flat Screwdriver
Crow bar
Wheel chock
Replacement: wheel cylinder – OPEL TIGRA (95_). AUTODOC experts recommend:
  • Replace the wheel brake cylinders of the rear drum brakes in pairs.
  • The replacement procedure is identical for the right and left wheel brake cylinders of the rear drum brakes.
  • All work should be done with the engine stopped.
Replacement: wheel cylinder – OPEL TIGRA (95_). Recommended sequence of steps:
  1. Step 1
    How to change Wheel Cylinder on Opel Tigra S93 1994 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 2
    How to replace OPEL Tigra Coupe (S93) 1.4 16V (F07) 1995 Wheel Cylinder - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  3. Step 3
    Raise the rear of the car and secure on supports.
    Step 4
    Opel Tigra S93 1.6 16V (F07) 1996 Wheel Cylinder replacement: free workshop manuals
    Unscrew the wheel bolts.
    Replacement: wheel cylinder – OPEL TIGRA (95_). Tip from AUTODOC:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  4. Step 5
    Changing Wheel Cylinder on OPEL Tigra Coupe (S93) 1.6 16V (F07) 1997 by yourself
    Remove the wheel.
  5. Step 6
    How to remove OPEL TIGRA 1.4 16V (F07) 1998 Wheel Cylinder - online easy-to-follow instructions
    Remove the hub bearing protection cap. Use a flat screwdriver.
  6. Step 7
    How to replace Wheel Cylinder on OPEL Tigra Coupe (S93) 1999: download PDF manuals and video instructions
    Remove the cotter pin securing the hub nut. Use round-nose pliers.
  7. Step 8
    How hard is it to do yourself: Wheel Cylinder replacement on Opel Tigra S93 1.4 16V (F07) 2000 - download illustrated guide
    Unscrew the wheel hub axle nut. Use a combination spanner #24.
  8. Step 9
    Need to know how to renew Wheel Cylinder on OPEL TIGRA 1994? This free workshop manual will help you to do it yourself
    Remove the brake drum.
    Replacement: wheel cylinder – OPEL TIGRA (95_). Professionals recommend:
    Examine the brake drum. Replace it if necessary.
  9. Step 10
    Unscrew the fastener connecting the brake pipe to the wheel cylinder. Use a flare nut spanner #10.
    Step 11
    Changing of Wheel Cylinder on Opel Tigra S93 1995 won't be an issue if you follow this illustrated step-by-step guide
    Detach the brake pipe.
    Replacement: wheel cylinder – OPEL TIGRA (95_). AUTODOC recommends:
    Immediately plug the brake line open end to prevent fluid leakage and ingress of dirt into the hydraulic system.
  10. Step 12
    OPEL TIGRA 1.4 16V (F07) Wheel Cylinder replacement: online guides and video tutorials
    Unscrew the wheel cylinder fastener. Use a drive socket #10. Use a ratchet wrench.
  11. Step 13
    Replacing Wheel Cylinder on Opel Tigra S93 1997 1.4 16V (F07) by yourself
    Remove the brake cylinder from the backplate. Use a crowbar.
  12. Step 14
    Clean the brake drum. Use a wire brush. Use WD-40 spray.
    Step 15
    Tigra Coupe (S93) 1.4 16V (F07) 1998 Wheel Cylinder DIY replacement workshop manual
    Clean the brake pipe attachment spot  and the brake drum fastening bolts on :maker :model.
  13. Step 16
    How to change Wheel Cylinder on OPEL Tigra Coupe (S93) 1999 - tips and tricks
    Install a new brake cylinder.
  14. Step 17
    Step-by-step recommendations for DIY replacement Opel Tigra S93 2000 1.4 16V (F07) Wheel Cylinder
    Tighten the wheel cylinder fastener. Use a drive socket #10. Use a torque wrench. Tighten it to 10 nm torque.
  15. Step 18
    DIY replacement of Wheel Cylinder on OPEL Tigra Coupe (S93) 1.4 16V (F07) 1994 is not an issue anymore with our step-by-step tutorial
    Attach the brake pipe. Use a flare nut spanner #10.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the OPEL Tigra Coupe (S93) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
OPEL Tigra Coupe (S93) Wheel Cylinder replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY OPEL Tigra Coupe (S93) Wheel Cylinder replacement - online guide
Tips & tricks for your OPEL Tigra Coupe (S93)
View more
  • How to change Brake wheel cylinder on OPEL Tigra Coupe (S93) 1.4 16V (F07) - replacement tricks
    How to save when buying car parts
  • Changing Brake cylinder Opel Tigra S93 1.4 16V (F07) - Replacement Tips
    The most common problems when buying a used car | AUTODOC
  • Maintenance Hacks - OPEL Tigra Coupe (S93) 1.6 16V (F07) Brake wheel cylinder replacement guide
    Top 5 reasons why the suspension knocks | AUTODOC tips
  • Replace Brake cylinder on Opel Tigra S93 - free video tips
    5 car tips for a winter's day | AUTODOC tips

Professional manuals for the most common OPEL models