When to replace the Wheel Cylinder on your OPEL CORSA
Recommended replacement interval for the part category Wheel Cylinder : 60000 km
Important!
This replacement procedure can be used for:
OPEL Corsa Utility Pickup 1.4 View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Tools
Replacement: wheel cylinder – OPEL CORSA C Utility Pick-up. Tools you'll need:
Wire brush
WD-40 spray
Copper grease
Drive socket # 10
Combination spanner #9
Combination spanner #24
Flare Nut Wrench № 10
Wheel impact socket #17
Ratchet wrench
Torque wrench
Round-nose pliers
Rubber mallet
Flat Screwdriver
Crow bar
Wheel chock
Replacement: wheel cylinder – OPEL CORSA C Utility Pick-up. AUTODOC experts recommend:
  • Replace the wheel brake cylinders of the rear drum brakes in pairs.
  • The replacement procedure is identical for the right and left wheel brake cylinders of the rear drum brakes.
  • All work should be done with the engine stopped.
Replacement: wheel cylinder – OPEL CORSA C Utility Pick-up. Recommended sequence of steps:
  1. Step 1
    How to change Wheel Cylinder on Opel Corsa C Utility 2003 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 2
    How to replace OPEL Corsa Utility Pickup 1.7 DTi 2004 Wheel Cylinder - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  3. Step 3
    Raise the rear of the car and secure on supports.
    Step 4
    Opel Corsa C Utility 1.4 2005 Wheel Cylinder replacement: free workshop manuals
    Unscrew the wheel bolts.
    Replacement: wheel cylinder – OPEL CORSA C Utility Pick-up. Tip from AUTODOC:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  4. Step 5
    Changing Wheel Cylinder on OPEL Corsa Utility Pickup 1.7 D 2006 by yourself
    Remove the wheel.
  5. Step 6
    How to remove OPEL CORSA 1.7 DTi 2007 Wheel Cylinder - online easy-to-follow instructions
    Remove the hub bearing protection cap. Use a flat screwdriver.
  6. Step 7
    How to replace Wheel Cylinder on OPEL Corsa Utility Pickup 2008: download PDF manuals and video instructions
    Remove the cotter pin securing the hub nut. Use round-nose pliers.
  7. Step 8
    How hard is it to do yourself: Wheel Cylinder replacement on Opel Corsa C Utility 1.8 2009 - download illustrated guide
    Unscrew the wheel hub axle nut. Use a combination spanner #24.
  8. Step 9
    Need to know how to renew Wheel Cylinder on OPEL CORSA 2010? This free workshop manual will help you to do it yourself
    Remove the brake drum.
    Replacement: wheel cylinder – OPEL CORSA C Utility Pick-up. Professionals recommend:
    Examine the brake drum. Replace it if necessary.
  9. Step 10
    Unscrew the fastener connecting the brake pipe to the wheel cylinder. Use a flare nut spanner #10.
    Step 11
    Changing of Wheel Cylinder on Opel Corsa C Utility 2003 won't be an issue if you follow this illustrated step-by-step guide
    Detach the brake pipe.
    Replacement: wheel cylinder – OPEL CORSA C Utility Pick-up. AUTODOC recommends:
    Immediately plug the brake line open end to prevent fluid leakage and ingress of dirt into the hydraulic system.
  10. Step 12
    OPEL CORSA 1.7 DTi Wheel Cylinder replacement: online guides and video tutorials
    Unscrew the wheel cylinder fastener. Use a drive socket #10. Use a ratchet wrench.
  11. Step 13
    Replacing Wheel Cylinder on Opel Corsa C Utility 2005 1.7 DTi by yourself
    Remove the brake cylinder from the backplate. Use a crowbar.
  12. Step 14
    Clean the brake drum. Use a wire brush. Use WD-40 spray.
    Step 15
    Corsa Utility Pickup 1.7 DTi 2006 Wheel Cylinder DIY replacement workshop manual
    Clean the brake pipe attachment spot  and the brake drum fastening bolts on :maker :model.
  13. Step 16
    How to change Wheel Cylinder on OPEL Corsa Utility Pickup 2007 - tips and tricks
    Install a new brake cylinder.
  14. Step 17
    Step-by-step recommendations for DIY replacement Opel Corsa C Utility 2008 1.7 DTi Wheel Cylinder
    Tighten the wheel cylinder fastener. Use a drive socket #10. Use a torque wrench. Tighten it to 10 nm torque.
  15. Step 18
    DIY replacement of Wheel Cylinder on OPEL Corsa Utility Pickup 1.8 2009 is not an issue anymore with our step-by-step tutorial
    Attach the brake pipe. Use a flare nut spanner #10.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the OPEL Corsa C Utility Pickup model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
OPEL Corsa Utility Pickup Wheel Cylinder replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY OPEL Corsa Utility Pickup Wheel Cylinder replacement - online guide
Tips & tricks for your OPEL Corsa Utility Pickup
View more
  • How to change Brake wheel cylinder on OPEL Corsa Utility Pickup 1.8 - replacement tricks
    DIY jack restoration | AUTODOC tips
  • Changing Brake cylinder Opel Corsa C Utility 1.7 DTi - Replacement Tips
    Why do your brakes squeak? | AUTODOC tips
  • Maintenance Hacks - OPEL Corsa Utility Pickup 1.4 Brake wheel cylinder replacement guide
    8 bad driving habits | AUTODOC tips
  • Replace Brake cylinder on Opel Corsa C Utility - free video tips
    How to clean an engine bay | AUTODOC

Professional manuals for the most common OPEL models