
Disclaimer
How to change track rod end on VW POLO PLAYA – replacement guide
downloads:
5
Views:
38
Important!
This replacement procedure can be used for:
VW POLO PLAYA 1.0 … View more
The steps may slightly vary depending on the car design.
VW POLO PLAYA 1.0 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Track Rod End for POLO PLAYA and other VW models
Track rod end
Alternative products

Wire brush
WD-40 spray
All-purpose cleaning spray
Copper grease
Torque wrench
Combination spanner #19
Combination spanner #22
Drive socket # 19
Wheel impact socket #17
Ratchet wrench
Ball joint puller
Vernier caliper
Wheel chock
Replacement: track rod end – VW POLO PLAYA. Tip from AUTODOC:
- Replace tie rod ends in pairs.
- The replacement procedure is identical for the right and left tie rod ends.
- Please note: all work on the car – VW POLO PLAYA – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Secure the wheels with chocks.Step 2Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 3Raise the car.Replacement: track rod end – VW POLO PLAYA. Tip:If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.Step 4Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW POLO PLAYA
- Step 5Remove the wheel.
- Step 6Clean all tie rod end connections. Use a wire brush. Use WD-40 spray.
- Step 7When deinstalling, mark or measure the precise position of the ball joint on the track rod, or count the number of turns in order to prevent misalignment afterward. Use a vernier caliper.
- Step 8Loosen the lock nut securing the tie rod end to the tie rod. Use a combination spanner #19. Use a combination spanner #22.
- Step 9Unscrew the end fastening nut to the steering knuckle. Use a drive socket #19. Use a ratchet wrench.
- Step 10Disconnect the tie rod end from the steering knuckle. Use a ball joint puller.
- Step 11Screw the end out of the tie rod.
- Step 12Clean the mounting seats of the tie rod end. Use a wire brush. Use all-purpose cleaning spray.
- Step 13Treat the mounting seats of the tie rod end. Use copper grease.
- Step 14Screw on a new tie rod end. Use a vernier caliper.Replacement: track rod end – VW POLO PLAYA. AUTODOC experts recommend:While installing the steering rod end remember to make the same number of turns or to leave the same length of thread showing as per your measurements.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Polo Playa model
Popular maintenance tutorials for VW Polo Playa
Complete guides for changing the Tie rod end on different VW POLO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW POLO PLAYA
View more
- How to easily repair a punctured tyre | AUTODOC tips
- How to Swap an M50 Engine in a BMW E30 Turbo | AUTODOC Project
- 5 mistakes made when washing the engine | AUTODOC tips
- How to remove rust | AUTODOC tips
Most commonly replaced car parts on VW POLO
Time to replace parts? Get even better deals in our Shop app.

SCAN ME