Important!
This replacement procedure can be used for:
SEAT Cordoba Vario (6K5) 1.4, SEAT Cordoba Vario (6K5) 1.6 i, SEAT Cordoba Vario (6K5) 1.9 TDI, SEAT Cordoba Vario (6K5) 1.6 i, SEAT Cordoba Vario (6K5) 1.9 TDI, SEAT Cordoba Vario (6K5) 1.6 i, SEAT Cordoba Vario (6K5) 1.9 SDI, SEAT Cordoba Vario (6K5) 1.4 i View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Track Rod End for Cordoba Vario (6K5) and other SEAT models
Tools
Replacement: track rod end – SEAT CORDOBA Vario (6K5). List of the tools you'll need:
Wire brush
WD-40 spray
All-purpose cleaning spray
Copper grease
Torque wrench
Combination spanner #19
Combination spanner #22
Drive socket # 19
Wheel impact socket #17
Ratchet wrench
Ball joint puller
Vernier caliper
Wheel chock
Replacement: track rod end – SEAT CORDOBA Vario (6K5). Tip from AUTODOC:
  • Replace tie rod ends in pairs.
  • The replacement procedure is identical for the right and left tie rod ends.
  • Please note: all work on the car – SEAT CORDOBA Vario (6K5) – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    Secure the wheels with chocks.
    Step 2
    How to change Track Rod End on Seat Cordoba 6K5 1996 - free PDF and video manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  2. Step 3
    Raise the car.
    Replacement: track rod end – SEAT CORDOBA Vario (6K5). Tip:
    If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.
    Step 4
    How to replace SEAT Cordoba Vario (6K5) 1.9 TDI 1997 Track Rod End - step-by-step manuals and video guides
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. SEAT CORDOBA Vario (6K5)
  3. Step 5
    Seat Cordoba 6K5 1.6 i 1998 Track Rod End replacement: free workshop manuals
    Remove the wheel.
  4. Step 6
    Changing Track Rod End on SEAT Cordoba Vario (6K5) 1.4 i 1999 by yourself
    Clean all tie rod end connections. Use a wire brush. Use WD-40 spray.
  5. Step 7
    How to remove SEAT CORDOBA 1.4 16V 2000 Track Rod End - online easy-to-follow instructions
    When deinstalling, mark or measure the precise position of the ball joint on the track rod, or count the number of turns in order to prevent misalignment afterward. Use a vernier caliper.
  6. Step 8
    How to replace Track Rod End on SEAT Cordoba Vario (6K5) 2001: download PDF manuals and video instructions
    Loosen the lock nut securing the tie rod end to the tie rod. Use a combination spanner #19. Use a combination spanner #22.
  7. Step 9
    How hard is it to do yourself: Track Rod End replacement on Seat Cordoba 6K5 1.9 TDI 2002 - download illustrated guide
    Unscrew the end fastening nut to the steering knuckle. Use a drive socket #19. Use a ratchet wrench.
  8. Step 10
    Need to know how to renew Track Rod End on SEAT CORDOBA 1996? This free workshop manual will help you to do it yourself
    Disconnect the tie rod end from the steering knuckle. Use a ball joint puller.
  9. Step 11
    Changing of Track Rod End on Seat Cordoba 6K5 1997 won't be an issue if you follow this illustrated step-by-step guide
    Screw the end out of the tie rod.
  10. Step 12
    SEAT CORDOBA 1.9 SDI Track Rod End replacement: online guides and video tutorials
    Clean the mounting seats of the tie rod end. Use a wire brush. Use all-purpose cleaning spray.
  11. Step 13
    Replacing Track Rod End on Seat Cordoba 6K5 1999 1.9 TDI by yourself
    Treat the mounting seats of the tie rod end. Use copper grease.
  12. Step 14
    Cordoba Vario (6K5) 1.4 16V 2000 Track Rod End DIY replacement workshop manual
    Screw on a new tie rod end. Use a vernier caliper.
    Replacement: track rod end – SEAT CORDOBA Vario (6K5). AUTODOC experts recommend:
    While installing the steering rod end remember to make the same number of turns or to leave the same length of thread showing as per your measurements.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the SEAT Córdoba I Vario (6K5) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
SEAT Cordoba Vario (6K5) Track Rod End replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY SEAT Cordoba Vario (6K5) Track Rod End replacement - online guide
Tips & tricks for your SEAT Cordoba Vario (6K5)
View more
  • How to change Tie rod end on SEAT Cordoba Vario (6K5) 1.9 SDI - replacement tricks
    What to do if the belt squeals | AUTODOC tips
  • Changing Outer tie rod Seat Cordoba 6K5 1.9 TDI - Replacement Tips
    Causes of a worn car boot damper | AUTODOC
  • Maintenance Hacks - SEAT Cordoba Vario (6K5) 1.6 i Track rod end ball joint replacement guide
    4 reasons why your CHECK ENGINE light is on | AUTODOC tips
  • Replace Outer tie rod end on Seat Cordoba 6K5 - free video tips
    How to find and change a fuse | AUTODOC