
Disclaimer
How to change spark plugs on VW Multivan VI (SGF, SGM, SGN) – replacement guide
downloads:
1
Views:
36

Recommended replacement interval for the part category Spark plug : 4 year / 60000 km
Important!
This replacement procedure can be used for:
VW Multivan VI (SGF, SGM, SGN) 2.0 TSI, VW Multivan VI (SGF, SGM, SGN) 2.0 TSI 4motion, VW Multivan VI (SGF, SGM, SGN) 2.0 TSI … View more
The steps may slightly vary depending on the car design.
VW Multivan VI (SGF, SGM, SGN) 2.0 TSI, VW Multivan VI (SGF, SGM, SGN) 2.0 TSI 4motion, VW Multivan VI (SGF, SGM, SGN) 2.0 TSI … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Spark Plug for Multivan VI (SGF, SGM, SGN) and other VW models
Spark plug
Alternative products

High-temperature anti-seize lubricant
Electronic spray
Spark plug socket # 16
Ratchet wrench
Torque wrench
Crow bar
Fender cover
Replacement: spark plugs – VW MULTIVAN VI (SGF, SGM, SGN). Professionals recommend:
- The replacement procedure is the same for all spark plugs.
- All work should be done with the engine stopped.
Replacement: spark plugs – VW MULTIVAN VI (SGF, SGM, SGN). Take the following steps:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Remove the engine cover.
- Step 4Unplug the connectors from the ignition coils.
- Step 5Raise a little the wiring of the ignition coils and move it aside.
- Step 6Pry up the ignition coil (4 pieces). Use a crowbar.
- Step 7Take out the ignition coils from the spark plug wells.Replacement: spark plugs – VW MULTIVAN VI (SGF, SGM, SGN). Tip:Remember the sequence of steps for ignition coil demounting.
- Step 8Clean dirt, dust and debris from inside the spark plug wells.
- Step 9Unscrew the spark plugs. Use the spark plug socket #16. Use a ratchet wrench.
- Step 10Take out the spark plugs.
- Step 11Apply a thin layer of a special high temperature anti-seize lubricant to the threads of the new spark plugs. Treat the surface of the terminals of the new spark plugs. Use high-temperature grease.
- Step 12Install the new spark plugs into their mounting seats.
- Step 13Screw new spark plugs and tighten them. Use the spark plug socket #16. Use a torque wrench. Tighten it to 25 nm torque.Replacement: spark plugs – VW MULTIVAN VI (SGF, SGM, SGN). AUTODOC recommends:Be careful when working with a spark plug wrench. Its skewing can cause damage to the threaded connection.Don't tighten the plugs with excessive force. Exceeding tightening torque can damage the thread connection.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Multivan T6 (SGF, SGM, SGN) model
Popular maintenance tutorials for VW Multivan T6
Complete guides for changing the Engine spark plug on different VW MULTIVAN models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW Multivan VI (SGF, SGM, SGN)
View more
- How do EGR valves work? | AUTODOC
- DIY rear axle restoration | Drivetrain restoration – Part 2
- Top 7 Manual Transmission Mistakes to Avoid | AUTODOC Tips
- How to Make a DIY Foam Sprayer | AUTODOC tips
Most commonly replaced car parts on VW MULTIVAN
Time to replace parts? Get even better deals in our Shop app.

SCAN ME