Disclaimer
How to change spark plugs on SEAT Alhambra (710, 711) – replacement guide
downloads:
1
Views:
9
Recommended replacement interval for the part category Spark plug : 6 year / 90000 km
Important!
This replacement procedure can be used for:
SEAT Alhambra (710, 711) 2.0 TSI … View more
The steps may slightly vary depending on the car design.
SEAT Alhambra (710, 711) 2.0 TSI … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Spark Plug for Alhambra (710, 711) and other SEAT models
Alternative products

High-temperature anti-seize lubricant
Electronic spray
Spark plug socket # 16
Ratchet wrench
Torque wrench
Crow bar
Fender cover
Replacement: spark plugs – SEAT ALHAMBRA (710, 711). Professionals recommend:
- The replacement procedure is the same for all spark plugs.
- All work should be done with the engine stopped.
Replacement: spark plugs – SEAT ALHAMBRA (710, 711). Take the following steps:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Remove the engine cover. - Step 4
Unplug the connectors from the ignition coils. - Step 5
Raise a little the wiring of the ignition coils and move it aside. - Step 6
Pry up the ignition coil (4 pieces). Use a crowbar. - Step 7
Take out the ignition coils from the spark plug wells.Replacement: spark plugs – SEAT ALHAMBRA (710, 711). Tip:Remember the sequence of steps for ignition coil demounting. - Step 8
Clean dirt, dust and debris from inside the spark plug wells. - Step 9
Unscrew the spark plugs. Use the spark plug socket #16. Use a ratchet wrench. - Step 10
Take out the spark plugs. - Step 11
Apply a thin layer of a special high temperature anti-seize lubricant to the threads of the new spark plugs. Treat the surface of the terminals of the new spark plugs. Use high-temperature grease. - Step 12
Install the new spark plugs into their mounting seats. - Step 13
Screw new spark plugs and tighten them. Use the spark plug socket #16. Use a torque wrench. Tighten it to 25 nm torque.Replacement: spark plugs – SEAT ALHAMBRA (710, 711). AUTODOC recommends:Be careful when working with a spark plug wrench. Its skewing can cause damage to the threaded connection.Don't tighten the plugs with excessive force. Exceeding tightening torque can damage the thread connection.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the SEAT Alhambra II (710, 711) model
Popular maintenance tutorials for SEAT Alhambra 7N
Complete guides for changing the Engine spark plug on different SEAT ALHAMBRA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your SEAT Alhambra (710, 711)
View more
How to align the timing marks correctly on an EA888 engine
How to tell if a tie rod is faulty
CHECK ENGINE light turned on – step-by-step guide on what to do
How to Safely Wash Your Car in Winter Without Damage | AUTODOC tips
Most commonly replaced car parts on SEAT ALHAMBRA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME


















