Disclaimer
How to change rear wheel bearing on RENAULT Sandero / Stepway II (B8_) – replacement guide
downloads:
7
Views:
38
Important!
This replacement procedure can be used for:
RENAULT Sandero / Stepway II (B8_) 1.5 dCi, RENAULT Sandero / Stepway II (B8_) 1.6 16V, RENAULT Sandero / Stepway II (B8_) 1.6, RENAULT Sandero / Stepway II (B8_) 1.6, RENAULT Sandero / Stepway II (B8_) 1.6, RENAULT Sandero / Stepway II (B8_) 1.6 (B8JA), RENAULT Sandero / Stepway II (B8_) 1.2 16V, RENAULT Sandero / Stepway II (B8_) 1.5 dCi (B8AL), RENAULT Sandero / Stepway II (B8_) 1.0 SCe (B8JD) … View more
The steps may slightly vary depending on the car design.
RENAULT Sandero / Stepway II (B8_) 1.5 dCi, RENAULT Sandero / Stepway II (B8_) 1.6 16V, RENAULT Sandero / Stepway II (B8_) 1.6, RENAULT Sandero / Stepway II (B8_) 1.6, RENAULT Sandero / Stepway II (B8_) 1.6, RENAULT Sandero / Stepway II (B8_) 1.6 (B8JA), RENAULT Sandero / Stepway II (B8_) 1.2 16V, RENAULT Sandero / Stepway II (B8_) 1.5 dCi (B8AL), RENAULT Sandero / Stepway II (B8_) 1.0 SCe (B8JD) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Wheel Bearing for Sandero / Stepway II (B8_) and other RENAULT models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Multipurpose grease
Copper grease
Combination spanner №15
Drive socket # 13
Drive socket # E16
Drive socket # 30
Wheel impact socket #19
Ratchet wrench
Torque wrench
Brake caliper wind back tool
Tap wrench
Hammer
Rubber mallet
Crow bar
Wheel chock
Replacement: wheel bearing – RENAULT SANDERO/STEPWAY II. AUTODOC experts recommend:
- Do not re-use the bearing assembly of your RENAULT SANDERO/STEPWAY II car.
- The wheel hub bearing replacement procedure is identical for both wheels on the same axle.
- All work should be done with the engine stopped.
Replacement: wheel bearing – RENAULT SANDERO/STEPWAY II. Recommended sequence of steps:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2
Secure the wheels with chocks. - Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #19. - Step 4Raise the rear of the car and secure on supports.Step 5
Unscrew the wheel bolts.AUTODOC recommends:Important! Hold the wheel while unscrewing the fastening bolts. RENAULT SANDERO/STEPWAY II - Step 6
Remove the wheel. - Step 7
Spread the brake pads. Use a crowbar. - Step 8
Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray. - Step 9
Unscrew the brake caliper fastening. Use a combination spanner #15. Use a drive socket #13. Use a ratchet wrench. - Step 10
Remove the brake caliper.Replacement: wheel bearing – RENAULT SANDERO/STEPWAY II. AUTODOC recommends:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. - Step 11
Remove the brake pads. Use a crowbar. - Step 12
Clean the brake caliper bracket fasteners. Use WD-40 spray. - Step 13
Unscrew the caliper bracket fastening. Use a drive socket #E16. Use a tap wrench. - Step 14
Remove the caliper bracket. - Step 15
Pry up and remove the wheel hub cap. Use a crowbar. Use a hammer. - Step 16
Unscrew the hub lock nut. Use a drive socket #30. Use a tap wrench. - Step 17
Remove the brake disc assemled with the wheel hub bearing. - Step 18
Install the brake disc assembled with the wheel hub bearing. - Step 19
Screw the wheel hub lock nut. Use a drive socket #30. Use a torque wrench. Tighten it to 175 Nm torque. - Step 20
Treat the hub where it contacts the brake disk. Use a multipurpose grease.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the RENAULT Sandero / Stepway II (B8_) model
Popular maintenance tutorials for Renault Sandero Stepway 2
Complete guides for changing the Wheel bearings on different RENAULT SANDERO / STEPWAY models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your RENAULT Sandero / Stepway II (B8_)
View more
How to choose the right engine oil for your car | AUTODOC
How to replace a timing chain yourself
Understanding Airbag Light Warnings | Essential Tips for Car Safety
What to do if your car’s bonnet won’t open | AUTODOC tips
Most commonly replaced car parts on RENAULT SANDERO / STEPWAY
Time to replace parts? Get even better deals in our Shop app.

SCAN ME





























