How to carry out replacement: Control Arm 120d BMW E82
Disclaimer
Change BMW E82 123d Control Arm yourself – manuals and video tutorials

How to change rear upper arm on BMW 1 Coupe (E82) – replacement guide

downloads: 6
Views: 51
Download your free tutorial and fix BMW 1 Coupe (E82) 120d problems yourself Download for free 1.24 MB Control Arm for BMW E82 Shop now
Leave a comment Open in a new tab
Important!
This replacement procedure can be used for:
BMW 1 Coupe (E82) M, BMW 1 Coupe (E82) 118 d, BMW 1 Coupe (E82) 135 i, BMW 1 Coupe (E82) 120d, BMW 1 Coupe (E82) 123d, BMW 1 Coupe (E82) 125i, BMW 1 Coupe (E82) 120d, BMW 1 Coupe (E82) 120 i, BMW 1 Coupe (E82) 118 d, BMW 1 Coupe (E82) 128 i, BMW 1 Coupe (E82) 120 i, BMW 1 Coupe (E82) 120d, BMW 1 Coupe (E82) 135 i … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Control Arm for 1 Coupe (E82) and other BMW models
Alternative products
How to change Suspension arm on BMW E82 120d – step-by-step instructions for straightforward car repair Suspension arm
Tools
Replacement: rear upper arm – BMW 1 Coupe (E82). Tools you might need:
Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #18
Drive socket # 18
Wheel impact socket #17
Ratchet wrench
Torque wrench
Tap wrench
Flat Screwdriver
Hydraulic transmission jack
Wheel chock
Buy tools
Replacement: rear upper arm – BMW 1 Coupe (E82). AUTODOC experts recommend:
  • The replacement procedure is identical for the right and left upper control arms.
  • Please note: all work on the car – BMW 1 Coupe (E82) – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    How to change Control Arm on BMW E82 2006 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 2
    How to replace BMW 1 Coupe (E82) 120d 2007 Control Arm - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  3. Step 3
    Raise the rear of the car and secure on supports.
    Step 4
    BMW E82 123d 2008 Control Arm replacement: free workshop manuals
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Important! Hold the wheel while unscrewing the fastening bolts. BMW 1 Coupe (E82)
  4. Step 5
    Changing Control Arm on BMW 1 Coupe (E82) 118d 2.0 2009 by yourself
    Remove the wheel.
  5. Step 6
    Clean all joints of the arm. Use a wire brush. Use WD-40 spray.
    Step 7
    How to remove BMW 1 SERIES 125i 2010 Control Arm - online easy-to-follow instructions
    Unscrew the fastener connecting the control arm to the rear knuckle. Use a drive socket #18. Use a tap wrench. Use a ratchet wrench.
  6. Step 8
    Remove the fastening bolt.
    Step 9
    How to replace Control Arm on BMW 1 Coupe (E82) 2011: download PDF manuals and video instructions
    Detach the suspension arm from the rear knuckle.
  7. Step 10
    Disconnect the ABS sensor wiring. Use a flat screwdriver.
    Step 11
    How hard is it to do yourself: Control Arm replacement on BMW E82 120i 2.0 2012 - download illustrated guide
    Unscrew the arm fastening to the beam. Use a combination spanner #18 (2 pieces).
  8. Step 12
    Remove the rear fastener of the control arm.
    Step 13
    Need to know how to renew Control Arm on BMW 1 SERIES 2013? This free workshop manual will help you to do it yourself
    Remove the rear upper arm.
  9. Step 14
    Changing of Control Arm on BMW E82 2006 won't be an issue if you follow this illustrated step-by-step guide
    Clean the mounting seats and the thread of the suspension arm. Use a wire brush. Use WD-40 spray.
  10. Step 15
    BMW 1 SERIES 123d Control Arm replacement: online guides and video tutorials
    Mount the rear upper arm.
    Replacement: rear upper arm – BMW 1 Coupe (E82). AUTODOC experts recommend:
    During the installation process, use only new bolts and nuts.
  11. Step 16
    Install the rear fastener of the control arm.
    Step 17
    Replacing Control Arm on BMW E82 2008 120d by yourself
    Tighten the arm fastening to the beam. Use a combination spanner #18 (2 pieces). Use a torque wrench. Tighten it to 100 Nm torque.
    AUTODOC recommends:
    Important! Be sure to use new fasteners.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?

Find out which tyre and wheel sizes are compatible with the BMW 1 Coupe (E82) model

BMW E82 tyre size

Popular maintenance tutorials for BMW E82

More manuals for BMW E82

Complete guides for changing the Control arm on different BMW 1 SERIES models

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

DIY BMW 1 Coupe (E82) Control Arm replacement - online guide
Tips & tricks for your BMW 1 Coupe (E82)
View more
  • How to change Control arm on BMW 1 Coupe (E82) 135i 3.0 - replacement tricks
    How to fix your car with AUTODOC CLUB
    17K views
    Published on: 30/11/2021
  • Changing Wishbone BMW E82 120d - Replacement Tips
    How to tighten cylinder head bolts
    13K views
    Published on: 06/03/2025
  • Maintenance Hacks - BMW 1 Coupe (E82) 123d Control arms replacement guide
    #DIY Wheel Rim Restoration: Revive Scratches and Chips Easily!
    7K views
    Published on: 18/07/2024
  • Replace Trailing arm on BMW E82 - free video tips
    How to Fix a Squealing Belt: Causes & Solutions | AUTODOC Expert Tips
    5K views
    Published on: 04/03/2021

Most commonly replaced car parts on BMW 1 SERIES

Professional manuals for the most common BMW models

ОЕ number
Autodoc CLUB App icon
Time to replace parts? Get even better deals in our Shop app.
BMW 1 Coupe (E82) Control Arm replace by yourself - Scan QR-code and download AUTODOC CLUB app
SCAN ME