How to carry out replacement: Strut Mount 1.0 TSI Polo 6
Disclaimer
Change Polo 6 2.0 GTI Strut Mount yourself – manuals and video tutorials

How to change rear strut mount on VW POLO (AW1, BZ1) – replacement guide

downloads: 0
Views: 19
Download your free tutorial and fix VW POLO (AW1, BZ1) 1.0 TSI problems yourself Download for free 2.65 MB Strut Mount for Polo 6 Shop now
Leave a comment Open in a new tab
Important!
This replacement procedure can be used for:
VW POLO (AW1, BZ1) 1.6 MSi … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Strut Mount for POLO (AW1, BZ1) and other VW models
How to change Top strut mount on Polo 6 1.0 TSI – step-by-step instructions for straightforward car repair Top strut mount
How to change Top strut mount on Polo VI (AW1, BZ1) – tips for proper car maintenance
Top strut mount for Polo VI (AW1, BZ1) Petrol (110 hp)
Tools
Replacement: strut mount – VW POLO (AW1, BZ1). Tools you might need:
Wire brush
WD-40 spray
Brake cleaner
Ceramic grease
Copper grease
Torque wrench
Combination spanner #18
Drive socket # 13
Drive socket # 16
Drive socket # 18
Shock absorber socket DD#5,2
Shock absorber socket DD#6
Torx bit T25
Wheel impact socket #17
Ratchet wrench
Vice
Crow bar
Hydraulic transmission jack
Wheel chock
Buy tools
Replacement: strut mount – VW POLO (AW1, BZ1). Tip from AUTODOC experts:
  • The replacement procedure is identical for the mounts of the right and left shock absorbers of the rear suspension.
  • Both mounts of the rear shock struts should be replaced simultaneously.
  • Please note: all work on the car – VW POLO (AW1, BZ1) – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    Secure the wheels with chocks.
    Step 2
    How to change Strut Mount on Polo 6 2017 - free PDF and video manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  2. Step 3
    Raise the car.
    Replacement: strut mount – VW POLO (AW1, BZ1). Tip from AUTODOC experts:
    If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.
    Step 4
    How to replace VW POLO (AW1, BZ1) 1.0 TSI 2018 Strut Mount - step-by-step manuals and video guides
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW POLO (AW1, BZ1)
  3. Step 5
    Polo 6 2.0 GTI 2019 Strut Mount replacement: free workshop manuals
    Remove the wheel.
  4. Step 6
    Changing Strut Mount on VW POLO (AW1, BZ1) 1.0 2020 by yourself
    Clean the lower shock absorber fastener. Use a wire brush. Use WD-40 spray.
  5. Step 7
    How to remove VW POLO 1.0 (CHYB) 2021 Strut Mount - online easy-to-follow instructions
    Support the rear knuckle. Use a hydraulic transmission jack.
  6. Step 8
    How to replace Strut Mount on VW POLO (AW1, BZ1) 2022: download PDF manuals and video instructions
    Unscrew the lower fastener of the shock absorber. Use a combination spanner #18. Use a drive socket #18. Use a ratchet wrench.
  7. Step 9
    How hard is it to do yourself: Strut Mount replacement on Polo 6 1.6 MSi 2023 - download illustrated guide
    Clean the locker fasteners. Use a wire brush.
  8. Step 10
    Need to know how to renew Strut Mount on VW POLO 2024? This free workshop manual will help you to do it yourself
    Unscrew the locker fasteners. Use Torx T25. Use a ratchet wrench.
  9. Step 11
    Changing of Strut Mount on Polo 6 2017 won't be an issue if you follow this illustrated step-by-step guide
    Move the locker aside to gain access to the upper shock absorber fasteners.
  10. Step 12
    VW POLO 2.0 GTI Strut Mount replacement: online guides and video tutorials
    Clean the charcoal canister fastener. Use a wire brush. Use WD-40 spray.
  11. Step 13
    Replacing Strut Mount on Polo 6 2019 1.0 TSI by yourself
    Unscrew the charcoal canister fastener. Use a drive socket #13. Use a ratchet wrench.
  12. Step 14
    POLO (AW1, BZ1) 1.0 (CHYB) 2020 Strut Mount DIY replacement workshop manual
    Move the charcoal canister aside to gain access to the upper shock absorber fasteners.
  13. Step 15
    How to change Strut Mount on VW POLO (AW1, BZ1) 2021 - tips and tricks
    Clean the fasteners of the shock absorber upper mount. Use a wire brush. Use WD-40 spray.
  14. Step 16
    Step-by-step recommendations for DIY replacement Polo 6 2022 1.0 (CHYB) Strut Mount
    Unscrew the shock absorber mount fasteners. Use a drive socket #16. Use a ratchet wrench.
  15. Step 17
    DIY replacement of Strut Mount on VW POLO (AW1, BZ1) 1.6 TDI 2023 is not an issue anymore with our step-by-step tutorial
    Remove the fastening bolts.
  16. Step 18
    How to change Strut Mount on Polo 6 2017 - free PDF and video manuals
    Lower the hydraulic transmission jack by 10-15 cm.
  17. Step 19
    How to replace VW POLO (AW1, BZ1) 1.0 TSI 2018 Strut Mount - step-by-step manuals and video guides
    Remove the fastening bolt.
  18. Step 20
    Polo 6 2.0 GTI 2019 Strut Mount replacement: free workshop manuals
    Remove the shock absorber.
  19. Step 21
    Changing Strut Mount on VW POLO (AW1, BZ1) 1.0 2020 by yourself
    Clean the shock absorber mounting seats. Use a wire brush. Use WD-40 spray.
  20. Step 22
    How to remove VW POLO 1.0 (CHYB) 2021 Strut Mount - online easy-to-follow instructions
    Grip the shock absorber in a vice.
  21. Step 23
    How to replace Strut Mount on VW POLO (AW1, BZ1) 2022: download PDF manuals and video instructions
    Remove the shock absorber mount cap. Use a crowbar.
  22. Step 24
    How hard is it to do yourself: Strut Mount replacement on Polo 6 1.6 MSi 2023 - download illustrated guide
    Clean the shock absorber rod fastener. Use a wire brush. Use WD-40 spray.
  23. Step 25
    Need to know how to renew Strut Mount on VW POLO 2024? This free workshop manual will help you to do it yourself
    Remove the fastener of the shock absorber piston rod. Use a drive socket #16. Use a shock absorber socket DD№5,2. Use a ratchet wrench.
  24. Step 26
    Changing of Strut Mount on Polo 6 2017 won't be an issue if you follow this illustrated step-by-step guide
    Remove the shock absorber mount, boot and bump stop.
    AUTODOC recommends:
    Replacement: strut mount – VW POLO (AW1, BZ1). Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.
  25. Step 27
    VW POLO 2.0 GTI Strut Mount replacement: online guides and video tutorials
    Install the new mount, boot, and bump stop on the shock absorber.
  26. Step 28
    Replacing Strut Mount on Polo 6 2019 1.0 TSI by yourself
    Tighten the shock absorber rod nut. Use a drive socket #16. Use a shock absorber socket DD№6. Use a torque wrench. Tighten it to 25 Nm torque.
  27. Step 29
    POLO (AW1, BZ1) 1.0 (CHYB) 2020 Strut Mount DIY replacement workshop manual
    Treat the shock absorber rod fastener. Use copper grease.
  28. Step 30
    How to change Strut Mount on VW POLO (AW1, BZ1) 2021 - tips and tricks
    Install the shock absorber mount cap.
  29. Step 31
    Step-by-step recommendations for DIY replacement Polo 6 2022 1.0 (CHYB) Strut Mount
    Release the vice and take out the shock absorber.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VW Polo VI (AW1, BZ1) model.

Browse tyres

Popular maintenance tutorials for Polo 6

More manuals for Polo 6

Complete guides for changing the Strut mount on different VW POLO models

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
VW POLO (AW1, BZ1) Strut Mount replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY VW POLO (AW1, BZ1) Strut Mount replacement - online guide
Tips & tricks for your VW POLO (AW1, BZ1)
View more
  • How to change Strut mount on VW POLO (AW1, BZ1) 1.6 TDI - replacement tricks
    How and why to check your oil | AUTODOC tips
    5K views
    Published on: 23/02/2023
  • Changing Top mount Polo 6 1.0 TSI - Replacement Tips
    What to do if your check engine light is on | AUTODOC tips
    15K views
    Published on: 19/08/2020
  • Maintenance Hacks - VW POLO (AW1, BZ1) 2.0 GTI Top strut mount replacement guide
    How to start a car after a long idle period | AUTODOC tips
    6K views
    Published on: 20/05/2021
  • Replace Top mounts on Polo 6 - free video tips
    8 bad driving habits | AUTODOC tips
    4K views
    Published on: 01/04/2021

Most commonly replaced car parts on VW POLO

Professional manuals for the most common VW models