Recommended replacement interval for the part category Brake Shoe Set : 100000 km

Important!

This replacement procedure can be used for:
VW Vento (1H2) 1.9 D, VW Vento (1H2) 1.9 TD, VW Vento (1H2) 1.9 TDI, VW Vento (1H2) 1.4, VW Vento (1H2) 1.4, VW Vento (1H2) 1.6, VW Vento (1H2) 1.8, VW Vento (1H2) 1.8, VW Vento (1H2) 1.6, VW Vento (1H2) 1.9 TDI, VW Vento (1H2) 1.9 SDI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Shoes for Vento (1H2) and other VW models

Brake Shoe Set

        Brake Shoe Set for Vento (1H2) Diesel (65 hp)
      
        Brake Shoe Set for Vento (1H2) Diesel (75 hp)
      
        Brake Shoe Set for Vento (1H2) Diesel (90 hp)
      
        Brake Shoe Set for Vento (1H2) Petrol (55 hp)
      
        Brake Shoe Set for Vento (1H2) Petrol (60 hp)
      
        Brake Shoe Set for Vento (1H2) Petrol (75 hp)
      
        Brake Shoe Set for Vento (1H2) Petrol (75 hp)
      
        Brake Shoe Set for Vento (1H2) Petrol (90 hp)
      
        Brake Shoe Set for Vento (1H2) Petrol (101 hp)

Replacement: brake shoes – VW VENTO (1H2). Tools you'll need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Copper grease 
                      
                        Combination spanner #24
                      
                        Wheel impact socket #17
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Pliers 
                      
                        Flat chisel
                      
                        Hammer
                      
                        Rubber mallet
                      
                        Flat Screwdriver
                      
                        Nippers
                      
                        Wheel chock

Buy tools

Replacement: brake shoes – VW VENTO (1H2). AUTODOC experts recommend:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake shoes – VW VENTO (1H2). Take the following steps:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the rear of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW VENTO (1H2)
Step 6

Remove the wheel.
Step 7

Remove the hub bearing protection cap. Use a flat metal-working chisel. Use a hammer. Use a flat screwdriver.

Please note!
Some cars are not equipped with wheel hub caps.
Step 8

Remove the cotter pin securing the hub nut. Use nippers.
Step 9

Unscrew the wheel hub axle nut. Use a combination spanner #24.
Step 10

Remove the brake drum.

Replacement: brake shoes – VW VENTO (1H2). Tip:
Examine the brake drum. Replace it if necessary.
Step 11

Remove the retaining spring of the brake pads. Use pliers.
Step 12

Remove the brake pads retaining clips. Use pliers.
Step 13

Pull both brake shoes with the adjuster from the working brake cylinder, avoiding damage to the boots.

Replacement: brake shoes – VW VENTO (1H2). Tip from AUTODOC experts:
Don't press the brake pedal after removing the rear brake drum shoes. This will cause the piston to fall out of the brake cylinder, leakage of brake fluid and depressurization of the system.
Step 14

Disconnect the parking brake cable. Use nippers.
Step 15

Remove the retaining spring of the brake pads.
Step 16

Remove both shoes from the mounting bracket.
Step 17

Perform further demounting of the upper retaining spring and the adjuster mechanism. Use pliers.
Step 18

Install the upper retaining springs and adjustment mechanism on new brake shoes. Use pliers.
Step 19

Place the brake shoes so that their inward edges rest on the anchor plate.
Step 20

Install the retaining spring of the brake pads.
Step 21

Connect the parking brake cable to the parking brake lever. Use nippers. Use pliers.
Step 22

Attach the brake shoes, together with the brake adjuster, to the wheel cylinder.
Step 23

Install the brake pads retaining clips. Use pliers.
Step 24

Install the retaining spring of the brake pads. Use pliers.
Step 25

Install a brake drum.
Step 26

Screw in the wheel hub fastener. Use a combination spanner #24.
Step 27

Install the cotter pin of the hub bearing fastening nut. Use a hammer. Use nippers.
Step 28

Install the hub bearing protection cap. Use a rubber mallet.
Step 29

Clean the wheel rim mounting seat. Use a wire brush. Treat the surface where the wheel rim contacts the brake drum. Use copper grease.
Step 30

Install the wheel.

Replacement: brake shoes – VW VENTO (1H2). Professionals recommend:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 31

Screw in the wheel bolts. Use wheel impact socket #17.
Step 32

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 120 nm torque.
Step 33

Remove the jacks and chocks.

Replacement: brake shoes – VW VENTO (1H2). Tip from AUTODOC experts:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 34

Tighten the brake fluid reservoir cap. Close the hood.

AUTODOC recommends:
VW VENTO (1H2) – Press the brake pedal several times with the engine shut down until you feel the resistance built up.Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.
Step 35

Adjust the gap between the brake shoes and the drum on :maker :model, pressing the brake pedal 10-15 times.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VW Vento (1H2) model.

Browse tyres

How to change rear brake pads on VW Vento (1H2) – replacement guide

Free download PDF
2.29 MB
How to change front ABS sensor on VW Vento (1H2) – replacement guide

Free download PDF
1.94 MB
How to change front brake discs on VW Vento (1H2) – replacement guide

Free download PDF
1.62 MB
How to change wheel cylinder on VW Vento (1H2) – replacement guide

Free download PDF
1.39 MB
How to change front brake pads on VW Vento (1H2) – replacement guide

Free download PDF
1.5 MB
How to change brake drum on VW Vento (1H2) – replacement guide

Free download PDF
1.73 MB

How to change rear brake shoes on VW Polo 6N1 – replacement guide

Free download PDF
3.35 MB
How to change rear brake shoes on VW Lupo 6X1 – replacement guide

Free download PDF
2.33 MB
How to change rear brake shoes on VW Golf 3 – replacement guide

Free download PDF
2.05 MB
How to change rear brake shoes on VW Golf 2 – replacement guide

Free download PDF
2.05 MB
How to change rear brake shoes on VW POLO PLAYA – replacement guide

Free download PDF
1.92 MB
How to change rear brake shoes on VW GOLF I (17) – replacement guide

Free download PDF
1.91 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

5 mistakes made when washing the engine | AUTODOC tips

29K views

Published on: 22/04/2021
5 common car washing mistakes | AUTODOC tips

5K views

Published on: 23/09/2021
What to do if your car heater isn't working | AUTODOC tips

4K views

Published on: 11/02/2021
How to polish your car | AUTODOC tips

5K views

Published on: 31/03/2022