When to replace the Brake Calipers on your SEAT TOLEDO
Recommended replacement interval for the part category Brake caliper : 100000 km
Important!
This replacement procedure can be used for:
SEAT Toledo II Saloon (1M2) 1.6, SEAT Toledo II Saloon (1M2) 1.8 20V, SEAT Toledo II Saloon (1M2) 2.3 V5, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.4 16V, SEAT Toledo II Saloon (1M2) 1.6 16V, SEAT Toledo II Saloon (1M2) 2.3 V5 20V, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.8 20VT, SEAT Toledo II Saloon (1M2) 1.9 TDI View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Calipers for Toledo II Saloon (1M2) and other SEAT models
Tools
Replacement: brake caliper – SEAT TOLEDO II (1M2). List of the tools you'll need:
Wire brush
Brake cleaner
Copper grease
Combination spanner #11
Combination spanner #15
HEX bit No.H6.
Drive socket # 11
Drive socket # 13
Wheel impact socket #17
Ratchet wrench
Torque wrench
Fluid container
Water pump pliers
Brake hose clip
Brake bleeder kit
Crow bar
Wheel chock
Replacement: brake caliper – SEAT TOLEDO II (1M2). Tip from AUTODOC experts:
  • The replacement procedure is identical for the left and right brake calipers on the same axle.
  • All work should be done with the engine stopped.
Replacement: brake caliper – SEAT TOLEDO II (1M2). Use the following procedure:
  1. Step 1
    Open the bonnet. Unscrew the brake fluid reservoir cap.
    Step 2
    Secure the wheels with chocks.
    Step 3
    How to change Brake Calipers on Seat Toledo 1m 1998 - free PDF and video manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  2. Step 4
    Raise the rear of the car and secure on supports.
    Step 5
    How to replace SEAT Toledo II Saloon (1M2) 1.9 TDI 1999 Brake Calipers - step-by-step manuals and video guides
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. SEAT TOLEDO II (1M2)
  3. Step 6
    Seat Toledo 1m 1.6 16V 2000 Brake Calipers replacement: free workshop manuals
    Remove the wheel.
  4. Step 7
    Changing Brake Calipers on SEAT Toledo II Saloon (1M2) 1.8 20V 2001 by yourself
    Clean the area where the brake hose is connected to the caliper, and the guide pins area. Use a wire brush. Use a brake cleaner.
    AUTODOC recommends:
    Replacement: brake caliper – SEAT TOLEDO II (1M2). After applying the spray, wait a few minutes.
  5. Step 8
    How to remove SEAT TOLEDO 2.3 V5 2002 Brake Calipers - online easy-to-follow instructions
    Remove the retaining clip of the parking brake cable. Use a crowbar.
  6. Step 9
    How to replace Brake Calipers on SEAT Toledo II Saloon (1M2) 2003: download PDF manuals and video instructions
    Disconnect the parking brake cable from the caliper. Use water pump pliers. Release the parking brake cable.
  7. Step 10
    How hard is it to do yourself: Brake Calipers replacement on Seat Toledo 1m 1.8 20VT 2004 - download illustrated guide
    Clamp the brake hose off using a brake hose clamp.
  8. Step 11
    Need to know how to renew Brake Calipers on SEAT TOLEDO 2005? This free workshop manual will help you to do it yourself
    Put a container for gathering brake fluid beneath.
  9. Step 12
    Changing of Brake Calipers on Seat Toledo 1m 2006 won't be an issue if you follow this illustrated step-by-step guide
    Unscrew the brake hose from the brake caliper. Use a drive socket #13. Use a ratchet wrench.
  10. Step 13
    SEAT TOLEDO 1.6 16V Brake Calipers replacement: online guides and video tutorials
    Spread the brake pads. Use a crowbar.
  11. Step 14
    Replacing Brake Calipers on Seat Toledo 1m 1999 1.9 TDI by yourself
    Unscrew the brake caliper fastening. Use a combination spanner #15. Use a drive socket #13. Use a ratchet wrench.
  12. Step 15
    Toledo II Saloon (1M2) 2.3 V5 2000 Brake Calipers DIY replacement workshop manual
    Remove the brake caliper. Use a crowbar.
    Replacement: brake caliper – SEAT TOLEDO II (1M2). Tip from AUTODOC experts:
    When replacing the brake caliper, it is recommended to check the brake hose for damages and, if necessary, to replace it with a new one. When replacing a brake caliper it is recommended to replace brake pads, check the state of the brake discs and replace them with new ones if necessary.If no new guide pins were supplied in a kit with the new brake calipers, use the old pins.
  13. Step 16
    How to change Brake Calipers on SEAT Toledo II Saloon (1M2) 2001 - tips and tricks
    Install the brake caliper and fix it.
    Please note!
    Install the brake caliper starting with its lower part. Hold up the brake caliper.
  14. Step 17
    Step-by-step recommendations for DIY replacement Seat Toledo 1m 2002 2.3 V5 Brake Calipers
    Tighten the brake caliper fasteners. Use a combination spanner #15. Use a drive socket #13. Use a torque wrench. Tighten it to 35 Nm torque.
  15. Step 18
    DIY replacement of Brake Calipers on SEAT Toledo II Saloon (1M2) 1.6 2003 is not an issue anymore with our step-by-step tutorial
    Unscrew the brake hose plug. Use HEX No.H6. Use a ratchet wrench.
  16. Step 19
    How to change Brake Calipers on Seat Toledo 1m 1998 - free PDF and video manuals
    Treat the brake hose. Use a brake cleaner.
    AUTODOC recommends:
    Replacement: brake caliper – SEAT TOLEDO II (1M2). After applying the spray, wait a few minutes.
  17. Step 20
    How to replace SEAT Toledo II Saloon (1M2) 1.9 TDI 1999 Brake Calipers - step-by-step manuals and video guides
    Install and fix the brake hose into a new caliper. Use a drive socket #13.
  18. Step 21
    Seat Toledo 1m 1.6 16V 2000 Brake Calipers replacement: free workshop manuals
    Tighten the fastener connecting the brake pipe to the brake caliper. Use a drive socket #13. Use a torque wrench. Tighten it to 35 Nm torque.
  19. Step 22
    Changing Brake Calipers on SEAT Toledo II Saloon (1M2) 1.8 20V 2001 by yourself
    Remove the brake hose clamp.
  20. Step 23
    How to remove SEAT TOLEDO 2.3 V5 2002 Brake Calipers - online easy-to-follow instructions
    Detach the brake caliper bleed screw cap.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the SEAT Toledo II Saloon (1M2) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
SEAT Toledo II Saloon (1M2) Brake Calipers replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY SEAT Toledo II Saloon (1M2) Brake Calipers replacement - online guide
Tips & tricks for your SEAT Toledo II Saloon (1M2)
View more
  • How to change Brake calipers on SEAT Toledo II Saloon (1M2) 1.6 - replacement tricks
    How to Make a DIY Foam Sprayer | AUTODOC tips
  • Changing Caliper Seat Toledo 1m 1.9 TDI - Replacement Tips
    How to restore wheel rims | AUTODOC tips
  • Maintenance Hacks - SEAT Toledo II Saloon (1M2) 1.6 16V Calipers replacement guide
    How to replace a wheel stud | AUTODOC tips
  • Replace Brake calipers on Seat Toledo 1m - free video tips
    Top 5 mistakes when working in the engine bay | AUTODOC tips