
Disclaimer
How to change rear ABS sensor on SEAT Toledo II Saloon (1M2) – replacement guide
downloads:
8
Views:
72
Important!
This replacement procedure can be used for:
SEAT Toledo II Saloon (1M2) 1.6, SEAT Toledo II Saloon (1M2) 1.8 20V, SEAT Toledo II Saloon (1M2) 2.3 V5, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.4 16V, SEAT Toledo II Saloon (1M2) 1.6 16V, SEAT Toledo II Saloon (1M2) 2.3 V5 20V, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.8 20VT … View more
The steps may slightly vary depending on the car design.
SEAT Toledo II Saloon (1M2) 1.6, SEAT Toledo II Saloon (1M2) 1.8 20V, SEAT Toledo II Saloon (1M2) 2.3 V5, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.4 16V, SEAT Toledo II Saloon (1M2) 1.6 16V, SEAT Toledo II Saloon (1M2) 2.3 V5 20V, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.9 TDI, SEAT Toledo II Saloon (1M2) 1.8 20VT … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – ABS Sensor for Toledo II Saloon (1M2) and other SEAT models
ABS sensor
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Electronic spray
Copper grease
Multipurpose grease
Torque wrench
Torx bit T30
HEX bit No.H5
HEX bit No.H8
Wheel impact socket #17
Ratchet wrench
Flat screwdriver
Water pump pliers
Pin punch
Tap wrench
Hammer
Crow bar
Wheel chock
Replacement: ABS sensor – SEAT TOLEDO II (1M2). Tip from AUTODOC:
- All work should be done with the engine stopped.
Replacement: ABS sensor – SEAT TOLEDO II (1M2). Use the following procedure:
- Step 1Secure the wheels with chocks.Step 2Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 3Raise the rear of the car and secure on supports.Step 4Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. SEAT TOLEDO II (1M2)
- Step 5Remove the wheel.
- Step 6Clean the ABS sensor fastener. Use a nylon cleaning brush. Use WD-40 spray.
- Step 7Detach the ABS sensor connector. Use a flat screwdriver.
- Step 8Unscrew the ABS sensor fastener. Use HEX No.H5. Use a ratchet wrench.
- Step 9Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
- Step 10Unscrew the brake caliper bracket fasteners. Use HEX No.H8. Use a ratchet wrench. Use a tap wrench.
- Step 11Release the parking brake cable. Use water pump pliers. Use a crowbar.
- Step 12Remove the brake caliper together with its bracket.Replacement: ABS sensor – SEAT TOLEDO II (1M2). AUTODOC experts recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
- Step 13Clean the brake disc fastener. Use a wire brush. Use WD-40 spray.Step 14Unscrew the brake disc fastening. Use Torx T30. Use a ratchet wrench.
- Step 15Remove the brake disc.
- Step 16Disconnect the ABS sensor. Use a pin punch. Use a hammer. Use a crowbar.
- Step 17Clean the ABS sensor mounting seat. Use a wire brush. Use WD-40 spray.
- Step 18Treat the ABS sensor fastener. Use a multipurpose grease.
- Step 19Connect the ABS sensor.
- Step 20Tighten the fastener connecting the ABS sensor to the stub axle. Use HEX No.H5. Use a torque wrench. Tighten it to 6 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the SEAT Toledo II Saloon (1M2) model
Popular maintenance tutorials for Seat Toledo 1m
Complete guides for changing the Wheel speed sensor on different SEAT TOLEDO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your SEAT Toledo II Saloon (1M2)
View more
- Top 5 mistakes when replacing spark plugs | AUTODOC tips
- Revitalize Your Car Interior: DIY Steering Wheel Cover with AUTODOC Tips
- DIY vehicle AC compressor restoration
- Understanding Airbag Light Warnings | Essential Tips for Car Safety
Most commonly replaced car parts on SEAT TOLEDO
Time to replace parts? Get even better deals in our Shop app.

SCAN ME