How to carry out replacement: Wheel Bearing 1.2 Adam M13
Disclaimer
Change Adam M13 1.2 Wheel Bearing yourself – manuals and video tutorials

How to change front wheel bearing on VAUXHALL Adam (M13) – replacement guide

downloads: 4
Views: 103
Download your free tutorial and fix VAUXHALL Adam (M13) 1.4 S problems yourself Download for free 4.09 MB Wheel Bearing for Adam M13 Shop now
Leave a comment Open in a new tab
Important!
This replacement procedure can be used for:
VAUXHALL Adam (M13) 1.4 S … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Wheel Bearing for Adam (M13) and other VAUXHALL models
How to change Wheel bearing kit on Adam M13 1.2 – step-by-step instructions for straightforward car repair Wheel bearing kit
How to change Wheel bearing kit on Adam (M13) – tips for proper car maintenance
Wheel bearing kit for Adam (M13) Petrol (150 hp)
Tools
Replacement: wheel bearing – VAUXHALL ADAM. List of the tools you'll need:
Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #16
Combination spanner #18
Torx bit T30
HEX bit no.H5.
Drive socket # 16
Drive socket # 17
Drive socket # 18
Drive socket # 19
Drive socket # 36
Wheel impact socket #17
Ratchet wrench
Torque wrench
Tap wrench
Pin punch
Flat chisel
Hammer
3-Arm Gear Puller
Vice
Bush and bearing driver set
Flat Screwdriver
Crow bar
Bearing separator
Ball joint puller
Wheel chock
Buy tools
Replacement: wheel bearing – VAUXHALL ADAM. Tip:
  • Do not re-use the bearing assembly of your VAUXHALL ADAM car.
  • The wheel hub bearing replacement procedure is identical for both wheels on the same axle.
  • Please note: all work on the car – VAUXHALL ADAM – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    How to change Wheel Bearing on Adam M13 2012 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 2
    How to replace VAUXHALL Adam (M13) 1.2 2013 Wheel Bearing - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  3. Step 3
    Raise the front of the car and secure on supports.
    Step 4
    Adam M13 1.4 2014 Wheel Bearing replacement: free workshop manuals
    Unscrew the wheel bolts.
    Replacement: wheel bearing – VAUXHALL ADAM. AUTODOC recommends:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  4. Step 5
    Changing Wheel Bearing on VAUXHALL Adam (M13) 1.4 S 2015 by yourself
    Remove the wheel.
  5. Step 6
    How to remove VAUXHALL ADAM 1.2 2016 Wheel Bearing - online easy-to-follow instructions
    Spread the brake pads. Use a crowbar.
  6. Step 7
    How to replace Wheel Bearing on VAUXHALL Adam (M13) 2017: download PDF manuals and video instructions
    Clean the fastener of the driveshaft. Use a wire brush. Use WD-40 spray.
  7. Step 8
    How hard is it to do yourself: Wheel Bearing replacement on Adam M13 1.0 2018 - download illustrated guide
    Unstake the fastener of the driveshaft. Use a flat metal-working chisel. Use a hammer.
  8. Step 9
    Need to know how to renew Wheel Bearing on VAUXHALL ADAM 2019? This free workshop manual will help you to do it yourself
    Unscrew the fastener connecting the drive shaft to the wheel hub. Use a drive socket #36. Use a tap wrench.
  9. Step 10
    Changing of Wheel Bearing on Adam M13 2020 won't be an issue if you follow this illustrated step-by-step guide
    Remove the fastening nut.
  10. Step 11
    VAUXHALL ADAM 1.2 Wheel Bearing replacement: online guides and video tutorials
    Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
  11. Step 12
    Replacing Wheel Bearing on Adam M13 2022 1.2 by yourself
    Unscrew the caliper bracket fastening. Use a drive socket #19. Use a tap wrench.
  12. Step 13
    Adam (M13) 1.2 2023 Wheel Bearing DIY replacement workshop manual
    Remove the brake caliper together with its bracket.
    Replacement: wheel bearing – VAUXHALL ADAM. Tip from AUTODOC experts:
    Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
  13. Step 14
    How to change Wheel Bearing on VAUXHALL Adam (M13) 2024 - tips and tricks
    Clean the brake disc fasteners. Use a wire brush. Use WD-40 spray.
  14. Step 15
    Step-by-step recommendations for DIY replacement Adam M13 2012 1.2 Wheel Bearing
    Unscrew the brake disc fastening Use Torx T30. Use a ratchet wrench.
  15. Step 16
    DIY replacement of Wheel Bearing on VAUXHALL Adam (M13) 1.0 2013 is not an issue anymore with our step-by-step tutorial
    Remove the brake disc.
  16. Step 17
    How to change Wheel Bearing on Adam M13 2012 - free PDF and video manuals
    Clean all joints of the arm. Use a wire brush. Use WD-40 spray.
  17. Step 18
    How to replace VAUXHALL Adam (M13) 1.2 2013 Wheel Bearing - step-by-step manuals and video guides
    Unscrew the ball joint fastening to the steering knuckle. Use a combination spanner #16. Use a drive socket #16. Use a tap wrench.
  18. Step 19
    Adam M13 1.4 2014 Wheel Bearing replacement: free workshop manuals
    Remove the fastening bolt.
  19. Step 20
    Changing Wheel Bearing on VAUXHALL Adam (M13) 1.4 S 2015 by yourself
    Clean the fastener connecting the tie rod end to the steering knuckle. Use a wire brush. Use WD-40 spray.
  20. Step 21
    How to remove VAUXHALL ADAM 1.2 2016 Wheel Bearing - online easy-to-follow instructions
    Unscrew the end fastening nut to the steering knuckle. Use a drive socket #17. Use a ratchet wrench.
  21. Step 22
    How to replace Wheel Bearing on VAUXHALL Adam (M13) 2017: download PDF manuals and video instructions
    Disconnect the tie rod end from the steering knuckle. Use a ball joint puller.
  22. Step 23
    How hard is it to do yourself: Wheel Bearing replacement on Adam M13 1.0 2018 - download illustrated guide
    Disconnect the ABS sensor wiring. Use a crowbar.
  23. Step 24
    Need to know how to renew Wheel Bearing on VAUXHALL ADAM 2019? This free workshop manual will help you to do it yourself
    Detach the ABS sensor connector.
  24. Step 25
    Changing of Wheel Bearing on Adam M13 2020 won't be an issue if you follow this illustrated step-by-step guide
    Unscrew the lower fastener connecting the shock strut to the steering knuckle. Use a combination spanner #18. Use a drive socket #18. Use a ratchet wrench.
  25. Step 26
    VAUXHALL ADAM 1.2 Wheel Bearing replacement: online guides and video tutorials
    Release the fastener connecting the ball joint to the steering knuckle. Use a flat metal-working chisel. Use a hammer.
  26. Step 27
    Replacing Wheel Bearing on Adam M13 2022 1.2 by yourself
    Disconnect the ball joint from the steering knuckle. Use a crowbar.
  27. Step 28
    Adam (M13) 1.2 2023 Wheel Bearing DIY replacement workshop manual
    Detach the driveshaft from the steering knuckle.
    Replacement: wheel bearing – VAUXHALL ADAM. Tip:
    Make sure that the drive shaft is not unloaded (when the car is jacked).
  28. Step 29
    Remove the fastening bolts.
    Step 30
    How to change Wheel Bearing on VAUXHALL Adam (M13) 2024 - tips and tricks
    Disconnect the steering knuckle from the shock absorber strut.
  29. Step 31
    Step-by-step recommendations for DIY replacement Adam M13 2012 1.2 Wheel Bearing
    Remove the steering knuckle together with the hub.
  30. Step 32
    DIY replacement of Wheel Bearing on VAUXHALL Adam (M13) 1.0 2013 is not an issue anymore with our step-by-step tutorial
    Grip the wheel hub together with the bearing in a vice.
  31. Step 33
    How to change Wheel Bearing on Adam M13 2012 - free PDF and video manuals
    Remove the wheel hub from the steering knuckle. Use a pin punch. Use a hammer.
  32. Step 34
    How to replace VAUXHALL Adam (M13) 1.2 2013 Wheel Bearing - step-by-step manuals and video guides
    Pull the bearing inner race out of the wheel hub. Use 3-Arm Gear Puller. Use a bearing separator.
  33. Step 35
    Adam M13 1.4 2014 Wheel Bearing replacement: free workshop manuals
    Clean the ABS sensor fastener. Use a wire brush. Use WD-40 spray.
  34. Step 36
    Changing Wheel Bearing on VAUXHALL Adam (M13) 1.4 S 2015 by yourself
    Unscrew the ABS sensor fastener. Use HEX No.H5. Use a ratchet wrench.
  35. Step 37
    How to remove VAUXHALL ADAM 1.2 2016 Wheel Bearing - online easy-to-follow instructions
    Disconnect the ABS sensor. Use a flat screwdriver.
  36. Step 38
    How to replace Wheel Bearing on VAUXHALL Adam (M13) 2017: download PDF manuals and video instructions
    Remove the wheel hub bearing retaining ring. Use a crowbar. Use a hammer.
  37. Step 39
    How hard is it to do yourself: Wheel Bearing replacement on Adam M13 1.0 2018 - download illustrated guide
    Release the vice and take out the wheel hub together with the bearing.
  38. Step 40
    Need to know how to renew Wheel Bearing on VAUXHALL ADAM 2019? This free workshop manual will help you to do it yourself
    Press out the wheel hub bearing. Use a bush and bearing driver set.
  39. Step 41
    Changing of Wheel Bearing on Adam M13 2020 won't be an issue if you follow this illustrated step-by-step guide
    Clean the hub bearing mounting seat. Use a wire brush. Use WD-40 spray.
  40. Step 42
    VAUXHALL ADAM 1.2 Wheel Bearing replacement: online guides and video tutorials
    Press the new bearing in the steering knuckle. Use a bush and bearing driver set.
    Replacement: wheel bearing – VAUXHALL ADAM. AUTODOC recommends:
    Check to make sure the wheel hub bearing is positioned correctly. Avoid its misalignment. Stop pressing on the surface of the bearing immediately after it has been fitted into its mounting seat.
  41. Step 43
    Replacing Wheel Bearing on Adam M13 2022 1.2 by yourself
    Install the wheel hub bearing retaining ring. Use a flat screwdriver.
  42. Step 44
    Adam (M13) 1.2 2023 Wheel Bearing DIY replacement workshop manual
    Treat the fasteners of the wheel hub bearing. Use WD-40 spray.
  43. Step 45
    How to change Wheel Bearing on VAUXHALL Adam (M13) 2024 - tips and tricks
    Install the wheel hub on the steering knuckle. Use a bush and bearing driver set.
  44. Step 46
    Step-by-step recommendations for DIY replacement Adam M13 2012 1.2 Wheel Bearing
    Install the steering knuckle with a hub in assembly.
  45. Step 47
    DIY replacement of Wheel Bearing on VAUXHALL Adam (M13) 1.0 2013 is not an issue anymore with our step-by-step tutorial
    Connect the ABS sensor.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VAUXHALL Adam (M13) model.

Browse tyres

Popular maintenance tutorials for Adam M13

More manuals for Adam M13

Complete guides for changing the Wheel bearings on different VAUXHALL ADAM models

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
VAUXHALL Adam (M13) Wheel Bearing replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY VAUXHALL Adam (M13) Wheel Bearing replacement - online guide
Tips & tricks for your VAUXHALL Adam (M13)
View more
  • How to change Wheel bearings on VAUXHALL Adam (M13) 1.0 - replacement tricks
    How to paint a brake caliper | AUTODOC tips
    10K views
    Published on: 08/04/2021
  • Changing Hub bearing Adam M13 1.2 - Replacement Tips
    How to fix your car with AUTODOC CLUB
    16K views
    Published on: 30/11/2021
  • Maintenance Hacks - VAUXHALL Adam (M13) 1.4 Wheel bearing kit replacement guide
    Top 5 reasons why your car squeals | AUTODOC Tips
    6K views
    Published on: 26/10/2023
  • Replace Wheel hub bearing on Adam M13 - free video tips
    How to restore a damaged thread | AUTODOC tips
    5K views
    Published on: 04/05/2023

Most commonly replaced car parts on VAUXHALL ADAM

Professional manuals for the most common VAUXHALL models