Disclaimer
How to change front suspension strut on Renault Kangoo KC01 – replacement guide
downloads:
14
Views:
243
Important!
This replacement procedure can be used for:
RENAULT KANGOO (KC0/1_) 1.2 (KC0A, KC0K, KC0F, KC01), RENAULT KANGOO (KC0/1_) 1.4 (KC0C, KC0H, KC0B, KC0M), RENAULT KANGOO (KC0/1_) D 1.9, RENAULT KANGOO (KC0/1_) D 1.9, RENAULT KANGOO (KC0/1_) 1.9 dTi (KC0U), RENAULT KANGOO (KC0/1_) 1.6 16V, RENAULT KANGOO (KC0/1_) 1.5 dCi (KC07), RENAULT KANGOO (KC0/1_) 1.5 dCi (KC08, KC09), RENAULT KANGOO (KC0/1_) 1.5 dCi, RENAULT KANGOO (KC0/1_) 1.6 16V bivalent, RENAULT KANGOO (KC0/1_) 1.5 dCi, RENAULT KANGOO (KC0/1_) 1.5 dCi, RENAULT KANGOO (KC0/1_) 1.6 (KC00), RENAULT KANGOO (KC0/1_) 1.9 RXED, RENAULT KANGOO (KC0/1_) Elect'road RE, RENAULT KANGOO (KC0/1_) 1.5 dCi … View more
The steps may slightly vary depending on the car design.
RENAULT KANGOO (KC0/1_) 1.2 (KC0A, KC0K, KC0F, KC01), RENAULT KANGOO (KC0/1_) 1.4 (KC0C, KC0H, KC0B, KC0M), RENAULT KANGOO (KC0/1_) D 1.9, RENAULT KANGOO (KC0/1_) D 1.9, RENAULT KANGOO (KC0/1_) 1.9 dTi (KC0U), RENAULT KANGOO (KC0/1_) 1.6 16V, RENAULT KANGOO (KC0/1_) 1.5 dCi (KC07), RENAULT KANGOO (KC0/1_) 1.5 dCi (KC08, KC09), RENAULT KANGOO (KC0/1_) 1.5 dCi, RENAULT KANGOO (KC0/1_) 1.6 16V bivalent, RENAULT KANGOO (KC0/1_) 1.5 dCi, RENAULT KANGOO (KC0/1_) 1.5 dCi, RENAULT KANGOO (KC0/1_) 1.6 (KC00), RENAULT KANGOO (KC0/1_) 1.9 RXED, RENAULT KANGOO (KC0/1_) Elect'road RE, RENAULT KANGOO (KC0/1_) 1.5 dCi … View more
The steps may slightly vary depending on the car design.
How to change a front shock strut on RENAULT KANGOO 1 (KC) [TUTORIAL AUTODOC]

All the parts you need to replace – Shock Absorber for KANGOO (KC0/1_) and other RENAULT models
Alternative products

Wire brush
WD-40 spray
Copper grease
Combination spanner #14
Combination spanner #21
Drive socket # 21
HEX bit No.H6.
Wheel impact socket #19
Pin punch
Hammer
Tap wrench
Ratchet wrench
Torque wrench
Crow bar
Hydraulic transmission jack
Hydraulic strut spring compressor
Fender cover
Wheel chock
Replacement: suspension strut – Renault Kangoo KC01. Tip from AUTODOC experts:
- Both shock struts of the front suspension should be replaced simultaneously.
- The replacement procedure is identical for the left and right shock struts of the front suspension.
- Warning! Shut down the engine before starting any work – Renault Kangoo KC01
Carry out replacement in the following order:
- Step 1
Open the bonnet. - Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Remove the shock strut mount cap. Use a crowbar. - Step 4
Loosen the upper fastener of the shock strut mount. Use a combination spanner #21. Use HEX No.H6. Use a ratchet wrench. - Step 5
Secure the wheels with chocks. - Step 6
Loosen the wheel mounting bolts. Use wheel impact socket #19. - Step 7
Raise the front of the car and secure on supports. - Step 8
Unscrew the wheel bolts.AUTODOC recommends:Important! Hold the wheel while unscrewing the fastening bolts. Renault Kangoo KC01 - Step 9
Remove the wheel. - Step 10
Clean the shock strut fasteners. Use a wire brush. Use WD-40 spray. - Step 11
Unscrew the lower fastener connecting the shock strut to the steering knuckle. Use a drive socket #21. Use a combination spanner #21. Use a tap wrench. - Step 12
Prop up the steering knuckle. Use a hydraulic transmission jack. - Step 13
Remove the fastening bolts (2 pieces). Use a hammer. Use a pin punch. - Step 14
Unscrew the upper fastening of the shock absorber strut. Use a drive socket #21.Replacement: suspension strut – Renault Kangoo KC01. AUTODOC recommends:To avoid injuries, hold the shock strut when undoing the fastening bolts. - Step 15
Remove the suspension strut. - Step 16
Set the shock absorber strut on the spring compressor tool.Replacement: suspension strut – Renault Kangoo KC01. Professionals recommend:Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles. - Step 17
Compress the spring. - Step 18
Remove the strut piston rod nut. Use HEX No.H6. Use a combination spanner #14. Use a ratchet wrench. - Step 19
Remove the top strut mount. - Step 20
Release the coil spring. - Step 21
Remove the spring. - Step 22
Remove the shock absorber dust cap and the bump stop. - Step 23
Remove the old shock absorber from the hydraulic coil spring compressor.AUTODOC recommends:Replacement: suspension strut – Renault Kangoo KC01. Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.Before installing a new shock absorber you should pump it manually 3-5 times. - Step 24
Install the new shock absorber on the hydraulic coil spring compressor. - Step 25
Install the dust sleeve and the bump stop on the new shock absorber. - Step 26
Install the spring on the shock absorber. - Step 27
Compress the spring.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the RENAULT Kangoo I (KC) model
Popular maintenance tutorials for Renault Kangoo kc01
Complete guides for changing the Shock absorbers on different RENAULT KANGOO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your RENAULT KANGOO (KC0/1_)
View more
How to replace a timing chain yourself
Top 5 possible reasons your car is shaking or vibrating
Unveiling the secrets: Detecting vacuum leaks with a Smoke Machine | AUTODOC
5 mistakes when replacing consumables
Most commonly replaced car parts on RENAULT KANGOO
ОЕ number
Time to replace parts? Get even better deals in our Shop app.

SCAN ME

































