Disclaimer
How to change front strut mount on NISSAN PRIMERA Hatchback (P12) – replacement guide
downloads:
1
Views:
19
Important!
This replacement procedure can be used for:
NISSAN PRIMERA Hatchback (P12) 1.6, NISSAN PRIMERA Hatchback (P12) 1.8, NISSAN PRIMERA Hatchback (P12) 2.0, NISSAN PRIMERA Hatchback (P12) 2.2 Di, NISSAN PRIMERA Hatchback (P12) 1.9 dCi, NISSAN PRIMERA Hatchback (P12) 2.2 dCi … View more
The steps may slightly vary depending on the car design.
NISSAN PRIMERA Hatchback (P12) 1.6, NISSAN PRIMERA Hatchback (P12) 1.8, NISSAN PRIMERA Hatchback (P12) 2.0, NISSAN PRIMERA Hatchback (P12) 2.2 Di, NISSAN PRIMERA Hatchback (P12) 1.9 dCi, NISSAN PRIMERA Hatchback (P12) 2.2 dCi … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Strut Mount for PRIMERA Hatchback (P12) and other NISSAN models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #11
Combination spanner #17
Drive socket # 19
Wheel impact socket #21
Ratchet wrench
Torque wrench
Hammer
Flat Screwdriver
Crow bar
Pliers
Hydraulic strut spring compressor
Fender cover
Wheel chock
Replacement: strut mount – NISSAN PRIMERA Hatchback (P12). Tip from AUTODOC:
- All mounts of the front shock struts should be replaced simultaneously.
- The replacement procedure is identical for the mounts of the left and right shock struts of the front suspension.
- Be sure to replace all self-locking nuts and bolts during installation.
- All work should be done with the engine stopped.
Replacement: strut mount – NISSAN PRIMERA Hatchback (P12). Recommended sequence of steps:
- Step 1
Secure the wheels with chocks. - Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #21. - Step 3Raise the front of the car and secure on supports.Step 4
Unscrew the wheel bolts.Replacement: strut mount – NISSAN PRIMERA Hatchback (P12). Tip:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 5
Remove the wheel. - Step 6
Disconnect the brake hose holder from the shock absorber strut. Use pliers. - Step 7
Disconnect the wiring and the brake hose from the bracket on the shock strut. Use a flat screwdriver. - Step 8Clean the fasteners connecting the shock strut to the steering knuckle. Use a wire brush. Use WD-40 spray.Step 9
Unscrew the lower fastener connecting the shock strut to the steering knuckle. Use a combination spanner #17. Use a drive socket #19. Use a ratchet wrench. - Step 10Remove the fastening bolts. Disconnect the steering knuckle from the shock absorber strut.Step 11Lower the car. Open the hood.Step 12Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 13Clean the fasteners of the shock strut upper mount. Use a wire brush. Use WD-40 spray.Step 14
Unscrew the top fastening of the shock strut mount. Use a combination spanner #11.AUTODOC recommends:Important! Hold the suspension strut while unscrewing the fastening bolts. NISSAN PRIMERA Hatchback (P12) - Step 15
Remove the suspension strut. - Step 16
Set the shock absorber strut on the spring compressor tool.Replacement: strut mount – NISSAN PRIMERA Hatchback (P12). Tip:Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles. - Step 17Compress the spring.Step 18
Treat the shock strut rod. Use a wire brush. Use WD-40 spray. - Step 19
Remove the strut piston rod nut. Use a combination spanner #17. - Step 20
Remove the top strut mount. Use a crowbar.Replacement: strut mount – NISSAN PRIMERA Hatchback (P12). AUTODOC recommends:Examine the shock absorber dust cap and the bump stop. Replace them if necessary. - Step 21
Install the upper strut mount and the strut mount bearing. - Step 22
Tighten the shock strut piston rod nut. Use a combination spanner #17. Use a torque wrench. Tighten it to 60 Nm torque.Replacement: strut mount – NISSAN PRIMERA Hatchback (P12). Tip from AUTODOC:Check to make sure the spring is positioned correctly. Avoid its misalignment. - Step 23
Treat the shock strut rod. Use copper grease. - Step 24
Decompress the spring. Remove the assembled shock strut.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the NISSAN Primera Hatchback (P12) model
Popular maintenance tutorials for Nissan Primera P12 Hatchback
Complete guides for changing the Strut mount on different NISSAN PRIMERA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your NISSAN PRIMERA Hatchback (P12)
View more
Save Money on Fuel with These Easy Tips | AUTODOC
Revive Your Tyres: Expert Tips for a Lasting Shine | AUTODOC Guide
How to replace a timing chain yourself
Kolbenschmidt plastic gauge overview
Most commonly replaced car parts on NISSAN PRIMERA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME



























