Disclaimer
How to change front lower arm on FORD Focus Mk2 Estate (DA_, FFS, DS) – replacement guide
downloads:
2
Views:
22
Important!
This replacement procedure can be used for:
FORD Focus II Estate (DA_, FFS, DS) 1.6 TDCi, FORD Focus II Estate (DA_, FFS, DS) 2.0 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.6 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.4, FORD Focus II Estate (DA_, FFS, DS) 1.6, FORD Focus II Estate (DA_, FFS, DS) 1.6 Ti, FORD Focus II Estate (DA_, FFS, DS) 2.0, FORD Focus II Estate (DA_, FFS, DS) 1.6 TDCi, FORD Focus II Estate (DA_, FFS, DS) 2.0 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.6 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.8 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.8 Flexifuel, FORD Focus II Estate (DA_, FFS, DS) 2.0 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.8, FORD Focus II Estate (DA_, FFS, DS) 2.0 LPG, FORD Focus II Estate (DA_, FFS, DS) 1.6 LPG … View more
The steps may slightly vary depending on the car design.
FORD Focus II Estate (DA_, FFS, DS) 1.6 TDCi, FORD Focus II Estate (DA_, FFS, DS) 2.0 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.6 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.4, FORD Focus II Estate (DA_, FFS, DS) 1.6, FORD Focus II Estate (DA_, FFS, DS) 1.6 Ti, FORD Focus II Estate (DA_, FFS, DS) 2.0, FORD Focus II Estate (DA_, FFS, DS) 1.6 TDCi, FORD Focus II Estate (DA_, FFS, DS) 2.0 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.6 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.8 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.8 Flexifuel, FORD Focus II Estate (DA_, FFS, DS) 2.0 TDCi, FORD Focus II Estate (DA_, FFS, DS) 1.8, FORD Focus II Estate (DA_, FFS, DS) 2.0 LPG, FORD Focus II Estate (DA_, FFS, DS) 1.6 LPG … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Control Arm for Focus II Estate (DA_, FFS, DS) and other FORD models
Alternative products

Wire brush
WD-40 spray
Copper grease
Drive socket # 15
Drive socket # 18
Combination spanner #22
Wheel impact socket #19
Ratchet wrench
Torque wrench
Ball joint puller
Crow bar
Hydraulic transmission jack
Wheel chock
Replacement: front lower arm – FORD FOCUS II Estate (DA_). AUTODOC recommends:
- The replacement procedure is identical for the left and right lower control arms.
- Replacement of the independent suspension lower arm in some cars requires a part of the outlet piping of the additional heater to be removed.
- Please note: all work on the car – FORD FOCUS II Estate (DA_) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1
Secure the wheels with chocks. - Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #19. - Step 3Raise the front of the car and secure on supports.Step 4
Unscrew the wheel bolts.Replacement: front lower arm – FORD FOCUS II Estate (DA_). Tip:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 5
Remove the wheel. - Step 6Remove the lower sound insulation.Please note!Some cars are not equipped with the lower sound insulation.Step 7
Clean all joints of the arm. Use a wire brush. Treat all joints of the arm. Use WD-40 spray.AUTODOC recommends:Replacement: front lower arm – FORD FOCUS II Estate (DA_). After applying the spray, wait a few minutes.Wear protective goggles. - Step 8
Unscrew the ball joint fastening nut. Use a combination spanner #22. - Step 9
Unscrew the fastening nut, remove the control arm from the steering knuckle, using a ball joint puller. - Step 10
Unscrew the front arm fastener. Use a drive socket #18. Use a ratchet wrench. - Step 11
Remove the front fastener of the control arm. Use a crowbar. Use a hammer. - Step 12
Unscrew the rear arm fastener. Use a drive socket #15. Use a ratchet wrench. - Step 13
Remove the rear fastener of the control arm. - Step 14
Remove the arm. Use a crowbar. - Step 15
Clean the mounting seats and the thread of the suspension arm. Use a wire brush. Use WD-40 spray. - Step 16
Install a new arm.Replacement: front lower arm – FORD FOCUS II Estate (DA_). AUTODOC experts recommend:During the installation process, use only new bolts and nuts.Do not damage the ball joint cover. - Step 17
Install the front fastener of the arm. Do not tighten it. - Step 18
Connect the ball joint to the steering knuckle.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the FORD Focus Mk2 Estate (DA_, FFS, DS) model
Popular maintenance tutorials for Ford Focus 2 da
Complete guides for changing the Control arm on different FORD FOCUS models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your FORD Focus II Estate (DA_, FFS, DS)
View more
How I started restoring a driveshaft | Drivetrain restoration – Part 1
Top 5 reasons why the suspension knocks | AUTODOC tips
Revive Your Vehicle's Look | How to Restore Wheel Rims Yourself!
Transform Your Car's Look: 6 Simple Accessories You Need to Try!
Most commonly replaced car parts on FORD FOCUS
Time to replace parts? Get even better deals in our Shop app.

SCAN ME































