How to change front brake pads on VW Golf I Convertible (155) – replacement guide
VW GOLF I Cabriolet (155) 1.6, VW GOLF I Cabriolet (155) 1.3, VW GOLF I Cabriolet (155) 1.6, VW GOLF I Cabriolet (155) 1.6, VW GOLF I Cabriolet (155) 1.5 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
Brake pad set
- Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
- The replacement procedure is identical for all brake pads on the same axle.
- All work should be done with the engine stopped.
- Step 1
Open the hood. Unscrew the brake fluid reservoir cap.
- Step 2
Secure the wheels with chocks.
Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 4
Raise the front of the car and secure on supports.
- Step 5
Unscrew the wheel bolts.
AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW GOLF I Cabriolet (155)
- Step 6
Remove the wheel.
- Step 7
Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
- Step 8
Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
- Step 9
Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
- Step 10
Spread the brake pads. Use a crowbar.
- Step 11
Remove the brake caliper.
Replacement: brake pads – VW GOLF I Cabriolet (155). Professionals recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
- Step 12
Remove the brake pads. Use a crowbar.
AUTODOC recommends:Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
- Step 13
Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.
AUTODOC recommends:After applying the spray, wait a few minutes.
- Step 14
Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.
Replacement: brake pads – VW GOLF I Cabriolet (155). Tip:Make sure the disc surface is clean before installing the pads.
- Step 15
Install new brake pads.
AUTODOC recommends:Make sure the pads are installed with linings facing the disc.
Find out which tyre and wheel sizes are compatible with the VW Golf I Convertible (155) model
Popular maintenance tutorials for Golf 1 Convertible
Free download PDF 1.23 MB
Free download PDF 1.91 MB
Free download PDF 2.01 MB
Free download PDF 1.62 MB
Free download PDF 1.39 MB
Free download PDF 2.37 MB
Complete guides for changing the Brake pad set on different VW GOLF models
Free download PDF 1.51 MB
Free download PDF 1.62 MB
Free download PDF 2.36 MB
Free download PDF 2.38 MB
Free download PDF 1.6 MB
Free download PDF 2.2 MB
Track expenses, manage logs, schedule replacements, and more.
K2 ROTON wheel cleaner overview
Top 7 signs of a bad starter
How to tighten cylinder head bolts
How to Fix a Squealing Belt: Causes & Solutions | AUTODOC Expert Tips
Most commonly replaced car parts on VW GOLF
