Disclaimer
How to change front brake pads on FORD Focus Mk3 Hatchback (DYB) – replacement guide
downloads:
48
Views:
1379
Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
FORD FOCUS III 1.6 Ti, FORD FOCUS III 1.6 Ti, FORD FOCUS III 1.6 Flexifuel, FORD FOCUS III 1.6 EcoBoost, FORD FOCUS III 1.6 EcoBoost, FORD FOCUS III 1.6 TDCi, FORD FOCUS III 1.6 TDCi, FORD FOCUS III 2.0 TDCi, FORD FOCUS III 2.0 TDCi, FORD FOCUS III 2.0 TDCi, FORD FOCUS III 2.0 TDCi, FORD FOCUS III 1.6 Ti, FORD FOCUS III 1.0 EcoBoost, FORD FOCUS III 1.0 EcoBoost, FORD FOCUS III 1.6 LPG, FORD FOCUS III 1.6 Flexifuel, FORD FOCUS III 1.6 TDCi ECOnetic, FORD FOCUS III 2.0 Ti-GDi, FORD FOCUS III 1.6 LPG, FORD FOCUS III 2.0, FORD FOCUS III 1.5 EcoBoost, FORD FOCUS III 1.5 EcoBoost, FORD FOCUS III 1.5 TDCi, FORD FOCUS III 1.5 TDCi ECOnetic, FORD FOCUS III 1.5 TDCi, FORD FOCUS III 2.0 TDCi, FORD FOCUS III 2.0 TDCi ST, FORD FOCUS III 1.6 Ti, FORD FOCUS III 1.0 EcoBoost (M1DH) … View more
The steps may slightly vary depending on the car design.
FORD FOCUS III 1.6 Ti, FORD FOCUS III 1.6 Ti, FORD FOCUS III 1.6 Flexifuel, FORD FOCUS III 1.6 EcoBoost, FORD FOCUS III 1.6 EcoBoost, FORD FOCUS III 1.6 TDCi, FORD FOCUS III 1.6 TDCi, FORD FOCUS III 2.0 TDCi, FORD FOCUS III 2.0 TDCi, FORD FOCUS III 2.0 TDCi, FORD FOCUS III 2.0 TDCi, FORD FOCUS III 1.6 Ti, FORD FOCUS III 1.0 EcoBoost, FORD FOCUS III 1.0 EcoBoost, FORD FOCUS III 1.6 LPG, FORD FOCUS III 1.6 Flexifuel, FORD FOCUS III 1.6 TDCi ECOnetic, FORD FOCUS III 2.0 Ti-GDi, FORD FOCUS III 1.6 LPG, FORD FOCUS III 2.0, FORD FOCUS III 1.5 EcoBoost, FORD FOCUS III 1.5 EcoBoost, FORD FOCUS III 1.5 TDCi, FORD FOCUS III 1.5 TDCi ECOnetic, FORD FOCUS III 1.5 TDCi, FORD FOCUS III 2.0 TDCi, FORD FOCUS III 2.0 TDCi ST, FORD FOCUS III 1.6 Ti, FORD FOCUS III 1.0 EcoBoost (M1DH) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Pads for FOCUS III and other FORD models
Alternative products

Wire brush
Brake cleaner
Anti-squeal paste
Copper grease
HEX bit No.H7.
Wheel impact socket #19
Ratchet wrench
Torque wrench
Brake caliper wind back tool
Crow bar
Wheel chock
Replacement: brake pads – FORD FOCUS III. AUTODOC experts recommend:
- Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
- The replacement procedure is identical for all brake pads on the same axle.
- All work should be done with the engine stopped.
Replacement: brake pads – FORD FOCUS III. Use the following procedure:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2
Secure the wheels with chocks. - Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #19. - Step 4Raise the front of the car and secure on supports.Step 5
Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. FORD FOCUS III - Step 6
Remove the wheel. - Step 7
Spread the brake pads. Use a crowbar. - Step 8
Detach the brake caliper retaining spring. Use a crowbar. - Step 9
Remove the dust boot caps of the brake caliper guide pins. - Step 10
Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench. - Step 11
Remove the brake caliper.Replacement: brake pads – FORD FOCUS III. AUTODOC recommends:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. - Step 12
Remove the brake pads.Replacement: brake pads – FORD FOCUS III. Tip:Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced. - Step 13
Press in the brake caliper piston. Use brake caliper wind back tool. - Step 14
Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary. Use a wire brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake pads – FORD FOCUS III. After applying the spray, wait a few minutes.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the FORD Focus Mk3 Hatchback (DYB) model
Popular maintenance tutorials for Ford Focus Mk3
Complete guides for changing the Brake pad set on different FORD FOCUS models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your FORD FOCUS III
View more
Understanding Car Tools: The Key Differences You Need to Know | AUTODOC tips
Revive Your Vehicle's Look | How to Restore Wheel Rims Yourself!
Transform Your Old Engine Valve Cover: Quick Polishing Tips for a Shiny Finish | AUTODOC Tips
What to do if your check engine light is on | AUTODOC tips
Most commonly replaced car parts on FORD FOCUS
Time to replace parts? Get even better deals in our Shop app.

SCAN ME































