Recommended replacement interval for the part category Brake disc : 50000 km

Important!

This replacement procedure can be used for:
PEUGEOT 3008 (0U_) 1.6 VTi, PEUGEOT 3008 (0U_) 1.6 HDi, PEUGEOT 3008 (0U_) 1.6 HDi, PEUGEOT 3008 (0U_) 1.6 HDi, PEUGEOT 3008 (0U_) 1.6 BlueHDi, PEUGEOT 3008 (0U_) 1.2, PEUGEOT 3008 (0U_) 1.6 HDi / BlueHDi … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Brake disc

Replacement: brake discs – PEUGEOT 3008. List of the tools you'll need:

                      Wire brush
                    
                      Nylon cleaning brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Brake caliper guide pins grease
                    
                      Copper grease 
                    
                      Torque wrench
                    
                      Combination spanner #13
                    
                      Drive socket # 13
                    
                      Torx bit T30
                    
                      Torx bit T55
                    
                      Wheel impact socket #17
                    
                      Brake caliper wind back tool
                    
                      Ratchet wrench
                    
                      Tap wrench
                    
                      Impact screwdriver
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake discs – PEUGEOT 3008. AUTODOC experts recommend:

Replace the brake disks on the car PEUGEOT 3008 in complete set for each axis. Regardless of the state of components. This will ensure even braking.
The replacement procedure is identical for both brake disks on the same axle.
When changing the brake discs, always replace the brake pads.
All work should be done with the engine stopped.

Replacement: brake discs – PEUGEOT 3008. Use the following procedure:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.

Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. PEUGEOT 3008
Step 6

Remove the wheel.
Step 7

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Unscrew the brake caliper fastening. Use a combination spanner #13.
Step 9

Spread the brake pads. Use a crowbar.
Step 10

Remove the brake caliper.

Replacement: brake discs – PEUGEOT 3008. Tip from AUTODOC experts:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 11

Remove the brake pads. Use a crowbar.
Step 12

Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
Step 13

Unscrew the caliper bracket fastening. Use Torx T55. Use a tap wrench. Use a ratchet wrench.
Step 14

Remove the caliper bracket.
Step 15

Clean the brake disc fasteners. Use a wire brush. Use WD-40 spray.
Step 16

Unscrew the brake disc fastening. Use Torx T30. Use an impact screwdriver.
Step 17

Remove the brake disc.
Step 18

Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease.
Step 19

Install the brake disc.
Step 20

Tighten the brake disc fastening. Use Torx T30. Use a torque wrench. Tighten it to 9 Nm torque.
Step 21

Clean the brake disk surface. Use a brake cleaner.

Replacement: brake discs – PEUGEOT 3008. Tip:
After applying the spray, wait a few minutes.
Step 22

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 23

Treat the brake caliper guide pins. Use the brake caliper guide pin grease.
Step 24

Install the brake caliper bracket.
Step 25

Tighten the brake caliper bracket. Use Torx T55. Use a torque wrench. Tighten it to 105 Nm torque.
Step 26

Install the brake pads.
Step 27

Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.

Replacement: brake discs – PEUGEOT 3008. AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 28

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 29

Install the brake caliper and fix it. Use a drive socket #13. Use a torque wrench. Tighten it to 30 Nm torque.
Step 30

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 31

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 32

Install the wheel.

AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. PEUGEOT 3008
Step 33

Screw in the wheel bolts. Use wheel impact socket #17.
Step 34

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 100 Nm torque.
Step 35

Remove the jacks and chocks.

Replacement: brake discs – PEUGEOT 3008. Professionals recommend:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 36

Tighten the brake fluid reservoir cap. Close the hood.

AUTODOC recommends:
Without starting the engine, press the brake pedal several times until you feel significant resistance.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the PEUGEOT 3008 I (0U_) model

Peugeot 3008 Mk1 tyre size

How to change front wheel bearing on PEUGEOT 3008 I (0U_) – replacement guide

Free download PDF 5.98 MB
How to change spark plugs on PEUGEOT 3008 I (0U_) – replacement guide

Free download PDF 1.17 MB
How to change front anti roll bar links on PEUGEOT 3008 I (0U_) – replacement guide

Free download PDF 1.33 MB
How to change engine oil and filter on PEUGEOT 3008 I (0U_) – replacement guide

Free download PDF 3.11 MB
How to change air filter on PEUGEOT 3008 I (0U_) – replacement guide

Free download PDF 1.99 MB
How to change fuel filter on PEUGEOT 3008 I (0U_) – replacement guide

Free download PDF 931.84 KB

How to change front brake discs on PEUGEOT 3008 (T8) – replacement guide

Free download PDF 2.11 MB
How to change brake discs on a car – replacement tutorial

Universal

Free download PDF 2.92 MB
How to change front brake discs on Peugeot 207 hatchback – replacement guide

Free download PDF 2.79 MB
How to change front brake discs on Peugeot 208 1 – replacement guide

Free download PDF 2.69 MB
How to change rear brake discs on Peugeot 207 hatchback – replacement guide

Free download PDF 2.49 MB
How to change rear brake discs on Peugeot 206 CC 2D – replacement guide

Free download PDF 2.16 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Top Automatic Transmission Blunders You Must Dodge | AUTODOC Insights

7K views

Published on: 26/01/2021
5 signs of a faulty strut mount and how to fix it

28K views

Published on: 28/08/2025
How to easily repair a punctured tyre | AUTODOC tips

3K views

Published on: 25/02/2021
How to choose a used car and not regret it

4K views

Published on: 05/02/2026