Recommended replacement interval for the part category Brake disc : 50000 km

Important!

This replacement procedure can be used for:
NISSAN MICRA V (K14) 0.9 IG-T, NISSAN MICRA V (K14) 1.0, NISSAN MICRA V (K14) 1.5 DCI, NISSAN MICRA V (K14) 1.0, NISSAN MICRA V (K14) 1.0 DIG-T 117, NISSAN MICRA V (K14) 0.9 LPG … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Discs for MICRA V (K14) and other NISSAN models

Alternative products

Brake disc

Replacement: brake discs – NISSAN MICRA V (K14). List of the tools you'll need:

                      Wire brush
                    
                      Nylon cleaning brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Torque wrench
                    
                      Torx bit T30
                    
                      Combination spanner #13
                    
                      Combination spanner #19
                    
                      Drive socket # 13 
                    
                      Drive socket # 18 
                    
                      Wheel impact socket #17
                    
                      Brake caliper wind back tool
                    
                      Ratchet wrench
                    
                      Tap wrench
                    
                      Crow bar
                    
                      Fender cover
                    
                      Wheel chock

Buy tools

Replacement: brake discs – NISSAN MICRA V (K14). AUTODOC experts recommend:

Replace the brake disks on the car NISSAN MICRA V (K14) in complete set for each axis. Regardless of the state of components. This will ensure even braking.
The replacement procedure is identical for both brake disks on the same axle.
When changing the brake discs, always replace the brake pads.
All work should be done with the engine stopped.

Replacement: brake discs – NISSAN MICRA V (K14). Recommended sequence of steps:

Step 1

Open the bonnet.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Unscrew the brake fluid reservoir cap.
Step 4

Secure the wheels with chocks.
Step 5

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 6

Raise the front of the car and secure on supports.

Step 7

Unscrew the wheel bolts.

Replacement: brake discs – NISSAN MICRA V (K14). Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 8

Remove the wheel.
Step 9

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 10

Unscrew the brake caliper fastening. Use a combination spanner #13. Use a combination spanner #19.
Step 11

Spread the brake pads. Use a crowbar.
Step 12

Remove the brake caliper.

Replacement: brake discs – NISSAN MICRA V (K14). AUTODOC experts recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 13

Remove the brake pads.
Step 14

Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
Step 15

Unscrew the caliper bracket fastening. Use a drive socket #18. Use a tap wrench.
Step 16

Remove the caliper bracket.
Step 17

Clean the brake disc fasteners. Use a wire brush. Use WD-40 spray.
Step 18

Unscrew the brake disc fastening. Use Torx T30. Use a ratchet wrench.
Step 19

Remove the brake disc.
Step 20

Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease.
Step 21

Install the brake disc.
Step 22

Tighten the brake disc fastening. Use Torx T30. Use a torque wrench. Tighten it to 9 Nm torque.
Step 23

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake discs – NISSAN MICRA V (K14). After applying the spray, wait a few minutes.
Step 24

Install the brake caliper bracket.
Step 25

Tighten the brake caliper bracket. Use a drive socket #18. Use a torque wrench. Tighten it to 105 Nm torque.
Step 26

Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.

Replacement: brake discs – NISSAN MICRA V (K14). Tip:
After applying the spray, wait a few minutes.
Step 27

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 28

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Step 29

Install the brake pads.
Step 30

Install the brake caliper and fix it. Use a combination spanner #13. Use a combination spanner #19. Use a drive socket #13. Use a torque wrench. Tighten it to 32 Nm torque.
Step 31

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 32

Clean the brake disk surface. Use a brake cleaner.

Replacement: brake discs – NISSAN MICRA V (K14). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 33

Install the wheel.

AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. NISSAN MICRA V (K14)
Step 34

Screw in the wheel bolts. Use wheel impact socket #17.
Step 35

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 105 Nm torque.

Step 36

Remove the jacks and chocks.

AUTODOC recommends:
Important! Replacement: brake discs – NISSAN MICRA V (K14). Check the brake fluid level in the reservoir and top up if necessary.
Step 37

Tighten the brake fluid reservoir cap.

Step 38

Remove the fender protection cover.

Step 39

Close the hood.

Replacement: brake discs – NISSAN MICRA V (K14). Tip from AUTODOC:
Without starting the engine, press the brake pedal several times until you feel significant resistance.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the NISSAN Micra V Hatchback (K14) model

Nissan Micra 5 tyre size

How to change engine oil and filter on NISSAN MICRA V (K14) – replacement guide

Free download PDF
1.54 MB
How to change glow plugs on NISSAN MICRA V (K14) – replacement guide

Free download PDF
1.55 MB
How to change spark plugs on Nissan Qashqai J10 – replacement guide

Free download PDF
2.37 MB
How to change engine oil and filter on Nissan Qashqai J10 – replacement guide

Free download PDF
2.86 MB
How to change front wheel bearing on Nissan Qashqai J10 – replacement guide

Free download PDF
3.71 MB
How to change rear brake pads on Nissan Qashqai J10 – replacement guide

Free download PDF
1.76 MB

How to change front brake discs on Nissan Micra K11 – replacement guide

Free download PDF
1.89 MB
How to change front brake discs on Nissan Micra K12 – replacement guide

Free download PDF
2.13 MB
How to change front brake pads on Nissan Micra K12 – replacement guide

Free download PDF
1.56 MB
How to change front brake discs on NISSAN Micra C+C III (K12) – replacement guide

Free download PDF
2.01 MB
How to change brake discs on a car – replacement tutorial

Universal

Free download PDF
2.92 MB
How to change rear brake discs on Nissan Qashqai J10 – replacement guide

Free download PDF
2.08 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Can You Hear Your Brakes Squeaking? Learn the Causes and DIY Solutions! | AUTODOC Tips

7K views

Published on: 19/01/2021
Transform Your Car's Look: 6 Simple Accessories You Need to Try!

3K views

Published on: 18/11/2021
TOP 5 mistakes during DIY oil change | AUTODOC tips

36K views

Published on: 17/06/2021
#DIY Wheel Rim Restoration: Revive Scratches and Chips Easily!

7K views

Published on: 18/07/2024