Recommended replacement interval for the part category Brake caliper : 100000 km

Important!

This replacement procedure can be used for:
VAUXHALL Meriva Mk II (B) (S10) 1.3 CDTi, VAUXHALL Meriva Mk II (B) (S10) 1.7 CDTi, VAUXHALL Meriva Mk II (B) (S10) 1.7 CDTi, VAUXHALL Meriva Mk II (B) (S10) 1.4, VAUXHALL Meriva Mk II (B) (S10) 1.4, VAUXHALL Meriva Mk II (B) (S10) 1.3 CDTI, VAUXHALL Meriva Mk II (B) (S10) 1.7 CDTI, VAUXHALL Meriva Mk II (B) (S10) 1.4, VAUXHALL Meriva Mk II (B) (S10) 1.4 LPG, VAUXHALL Meriva Mk II (B) (S10) 1.6 CDTi, VAUXHALL Meriva Mk II (B) (S10) 1.6 CDTi, VAUXHALL Meriva Mk II (B) (S10) 1.6 CDTI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Calipers for Meriva Mk II (B) (S10) and other VAUXHALL models

Brake caliper

        Brake caliper for Meriva Mk2 (B) (S10) Diesel (95 hp)
      
        Brake caliper for Meriva Mk2 (B) (S10) Diesel (131 hp)
      
        Brake caliper for Meriva Mk2 (B) (S10) Diesel (110 hp)
      
        Brake caliper for Meriva Mk2 (B) (S10) Petrol (101 hp)
      
        Brake caliper for Meriva Mk2 (B) (S10) Petrol (120 hp)
      
        Brake caliper for Meriva Mk2 (B) (S10) Diesel (75 hp)
      
        Brake caliper for Meriva Mk2 (B) (S10) Diesel (101 hp)
      
        Brake caliper for Meriva Mk2 (B) (S10) Petrol (140 hp)
      
        Brake caliper for Meriva Mk2 (B) (S10) Petrol/Petroleum Gas (LPG) (120 hp)

Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). Tools you need:

                        Wire brush
                      
                        Brake cleaner 
                      
                        Copper grease 
                      
                        Combination spanner #8
                      
                        Combination spanner #11
                      
                        Drive socket # 8 
                      
                        Drive socket # 11 
                      
                        HEX bit no.H7.
                      
                        Wheel impact socket #17
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Fluid container
                      
                        Brake bleeder kit
                      
                        Brake hose clip
                      
                        Crow bar
                      
                        Wheel chock

Buy tools

Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). Tip from AUTODOC experts:

The replacement procedure is identical for the left and right brake calipers on the same axle.
All work should be done with the engine stopped.

Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). Recommended sequence of steps:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.
Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. VAUXHALL MERIVA Mk II (B)
Step 6

Remove the wheel.
Step 7

Put a container for gathering brake fluid beneath.
Step 8

Clean the area where the brake hose is connected to the caliper, and the guide pins area. Use a wire brush. Use a brake cleaner.

Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 9

Clamp the brake hose off using a brake hose clamp.
Step 10

Unscrew the brake hose from the brake caliper. Use a drive socket #11. Use a ratchet wrench.
Step 11

Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
Step 12

Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
Step 13

Spread the brake pads. Use a crowbar.
Step 14

Pull aside the brake caliper retaining spring. Use a crowbar.
Step 15

Unscrew the brake hose from the brake caliper. Use a drive socket #11.
Step 16

Disconnect the brake hose.
Step 17

Remove the brake caliper.

Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). AUTODOC experts recommend:
When replacing the brake caliper, it is recommended to check the brake hose for damages and, if necessary, to replace it with a new one. When replacing a brake caliper it is recommended to replace brake pads, check the state of the brake discs and replace them with new ones if necessary.
Step 18

Remove the brake pads.
Step 19

Treat the brake hose. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). After applying the spray, wait a few minutes.
Step 20

Install the brake pads.

Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). Professionals recommend:
If going to use the old brake pads, clean them.
Step 21

Install the brake caliper and fix it. Use HEX No.H7. Use a ratchet wrench.
Step 22

Install and fix the brake hose into a new caliper. Use a drive socket #11. Use a ratchet wrench.
Step 23

Snap the brake caliper retaining spring back into place. Use a crowbar.
Step 24

Tighten the brake hose fastener. Use a combination spanner #11. Use a torque wrench. Tighten it to 40 Nm torque.
Step 25

Treat the brake hose. Use a brake cleaner.

Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 26

Remove the brake hose clamp.
Step 27

Tighten the brake caliper fasteners. Use HEX No.H7. Use a torque wrench. Tighten it to 28 Nm torque.
Step 28

Install the dust boot caps of the brake caliper guide pins.
Step 29

Undo the brake bleeder screw. Use a combination spanner #8.
Step 30

Connect the brake bleeder kit to the brake bleeder screw.
Step 31

Bleed the brake caliper system. Without starting the engine, press the brake pedal several times until you feel significant resistance.
Step 32

Tighten the brake bleeder screw. Use a combination spanner #8.
Step 33

Disconnect the brake bleeder kit.
Step 34

Tighten the brake caliper bleed screw. Use a drive socket #8. Use a torque wrench. Tighten it to 11 Nm torque.
Step 35

Clean dirt from the brake hose bolt. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). After applying the spray, wait a few minutes.
Step 36

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 37

Clean the brake disk surface. Use a brake cleaner.

Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). Tip:
After applying the spray, wait a few minutes.
Step 38

Install the wheel.

Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). AUTODOC recommends:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 39

Screw in the wheel bolts. Use wheel impact socket #17.
Step 40

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 110 Nm torque.
Step 41

Remove the jacks and chocks.

AUTODOC recommends:
Important! Replacement: brake caliper – VAUXHALL MERIVA Mk II (B). Check the brake fluid level in the reservoir and top up if necessary.
Step 42

Tighten the brake fluid reservoir cap. Close the hood.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VAUXHALL Meriva Mk2 (B) (S10) model.

VAUXHALL MERIVA Mk II (B) tyre size

How to change rear brake pads on VAUXHALL Meriva Mk II (B) (S10) – replacement guide

Free download PDF
1.98 MB
How to change front brake discs on VAUXHALL Meriva Mk II (B) (S10) – replacement guide

Free download PDF
1.95 MB
How to change front brake pads on VAUXHALL Meriva Mk II (B) (S10) – replacement guide

Free download PDF
1.5 MB
How to change rear brake discs on VAUXHALL Meriva Mk II (B) (S10) – replacement guide

Free download PDF
1.29 MB
How to change rear wheel bearing on VAUXHALL Meriva Mk II (B) (S10) – replacement guide

Free download PDF
2.99 MB
How to change serpentine belt on VAUXHALL Meriva Mk II (B) (S10) – replacement guide

Free download PDF
1.43 MB

How to change front brake caliper on VAUXHALL Meriva Mk I (A) (X03) – replacement guide

Free download PDF
2.15 MB
How to change brake caliper on a car – replacement tutorial

Universal

Free download PDF
2.91 MB
How to change front brake caliper on VAUXHALL Corsa Mk II (C) Hatchback (X01) – replacement guide

Free download PDF
2.15 MB
How to change front brake caliper on VAUXHALL Astra Mk IV (G) CC (T98) – replacement guide

Free download PDF
2.15 MB
How to change front brake caliper on VAUXHALL Astra Mk V (H) (A04) Hatchback – replacement guide

Free download PDF
2.16 MB
How to change front brake caliper on VAUXHALL Corsa Mk III (D) Hatchback (S07) – replacement guide

Free download PDF
2.15 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

3 things that cause engine damage | AUTODOC tips

9K views

Published on: 07/10/2021
Headlight Restoration | AUTODOC tips

8K views

Published on: 13/01/2021
DIY jack restoration | AUTODOC tips

12K views

Published on: 22/09/2022
Coolant comparison test | AUTODOC

11K views

Published on: 18/02/2021