Disclaimer
How to change engine oil and filter on RENAULT Megane III Grandtour (KZ) – replacement guide
downloads:
30
Views:
337
Recommended replacement interval for the part category Oil filter : 1 year / 20000 km
Important!
This replacement procedure can be used for:
RENAULT MEGANE III Grandtour (KZ0/1) 1.6 BiFuel (KZ03), RENAULT MEGANE III Grandtour (KZ0/1) 1.6 16V (KZ0U, KZ1B, KZ1U), RENAULT MEGANE III Grandtour (KZ0/1) 1.6 16V (KZ0H) … View more
The steps may slightly vary depending on the car design.
RENAULT MEGANE III Grandtour (KZ0/1) 1.6 BiFuel (KZ03), RENAULT MEGANE III Grandtour (KZ0/1) 1.6 16V (KZ0U, KZ1B, KZ1U), RENAULT MEGANE III Grandtour (KZ0/1) 1.6 16V (KZ0H) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for MEGANE III Grandtour (KZ0/1) and other RENAULT models
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Square oil drain plug socket No.8
Oil filter cup socket #74-15F
Oil filter cup socket #76-12F
Ratchet wrench
Funnel
Fender cover
Replacement: engine oil and filter – RENAULT MEGANE III Grandtour (KZ0/1). AUTODOC experts recommend:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Please note: all work on the car – RENAULT MEGANE III Grandtour (KZ0/1) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Pull up the oil dipstick. - Step 4
Unscrew the oil filler plug. - Step 5Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – RENAULT MEGANE III Grandtour (KZ0/1). AUTODOC experts recommend:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 6
Put a waste oil container with at least 5 l capacity under the drainage hole. - Step 7Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.Step 8
Unscrew the drain plug. Use square oil drain plug socket No.8 Use a ratchet wrench. - Step 9
Drain the used oil.Replacement: engine oil and filter – RENAULT MEGANE III Grandtour (KZ0/1). Tip:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 10
Unscrew the oil filter. Use the 76/12-F socket. Use a ratchet wrench. - Step 11
Clean the oil filter seat. Use all-purpose cleaning spray. - Step 12
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 13
Screw the new filter into its place. Use the 74/15-F socket. Use a torque wrench. Tighten it to 20 nm torque. - Step 14
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray. - Step 15
Screw in the new drainage plug and tighten it. Use square oil drain plug socket No.8 Use a torque wrench. Tighten it to 28 nm torque. - Step 16
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the RENAULT Megane III Grandtour (KZ) model
Popular maintenance tutorials for Renault Megane 3 Grandtour
Complete guides for changing the Oil filters on different RENAULT MEGANE models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your RENAULT MEGANE III Grandtour (KZ0/1)
View more
DIY car soundproofing | AUTODOC tips
How to repair a bumper yourself | AUTODOC tips
TOP 5 mistakes when replacing shock absorbers | AUTODOC tips
How to remove scratches from car plastic | AUTODOC tips
Most commonly replaced car parts on RENAULT MEGANE
Time to replace parts? Get even better deals in our Shop app.

SCAN ME




























