
Disclaimer
How to change engine oil and filter on RENAULT Megane IV Grandtour (K9A/M/N_) – replacement guide
downloads:
10
Views:
100

Recommended replacement interval for the part category Oil filter : 2 year / 30000 km
Important!
This replacement procedure can be used for:
RENAULT Megane IV Grandtour (K9A/M/N_) E-TECH 160 (K9NH) … View more
The steps may slightly vary depending on the car design.
RENAULT Megane IV Grandtour (K9A/M/N_) E-TECH 160 (K9NH) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for Megane IV Grandtour (K9A/M/N_) and other RENAULT models
Oil filter
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Drive socket # 14
Oil filter cup socket 65-14F
Ratchet wrench
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – RENAULT MEGANE IV Grandtour (K9A/M_). AUTODOC experts recommend:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Please note: all work on the car – RENAULT MEGANE IV Grandtour (K9A/M_) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Pull up the oil dipstick.
- Step 4Unscrew the oil filler plug.
- Step 5Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – RENAULT MEGANE IV Grandtour (K9A/M_). Professionals recommend:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 6Put a waste oil container with at least 5 l capacity under the drainage hole.
- Step 7Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
- Step 8Unscrew the drain plug. Use a drive socket #14. Use a ratchet wrench.
- Step 9Drain the used oil.Replacement: engine oil and filter – RENAULT MEGANE IV Grandtour (K9A/M_). Tip from AUTODOC:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
- Step 10Clean the oil filter. Use all-purpose cleaning spray.
- Step 11Unscrew the oil filter. Use the 65-14F socket. Use a ratchet wrench.
- Step 12Remove the oil filter.
- Step 13Clean the oil filter seat. Use all-purpose cleaning spray.
- Step 14Lubricate the rubber seal of the new filter with a little amount of fresh oil.
- Step 15Install a new oil filter.
- Step 16Tighten the oil filter. Remember to observe the recommended tightening torque. Use the 65-14F socket. Use a torque wrench. Tighten it to 24 Nm torque.
- Step 17Clean the oil filter. Use all-purpose cleaning spray.
- Step 18Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
- Step 19Screw in the new drainage plug and tighten it. Use a drive socket #14. Use a torque wrench. Tighten it to 30 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the RENAULT Megane IV Grandtour (K9A/M/N) model
Popular maintenance tutorials for RENAULT Megane 4 Grandtour
Complete guides for changing the Oil filters on different RENAULT MEGANE models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your RENAULT Megane IV Grandtour (K9A/M/N_)
View more
- Revitalize Your Car Interior: DIY Steering Wheel Cover with AUTODOC Tips
- 5 Essential Tips for beginner drivers: Avoid Common Mistakes
- Easy Steps to Paint Brake Calipers Without Special Skills or High Costs
- Drive with Care: 8 Common Bad Driving Habits Explained | AUTODOC
Most commonly replaced car parts on RENAULT MEGANE
Time to replace parts? Get even better deals in our Shop app.

SCAN ME