Disclaimer
How to change engine oil and filter on PEUGEOT 206 Van – replacement guide
downloads:
3
Views:
23
Recommended replacement interval for the part category Oil filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
PEUGEOT 206 Van 1.1, PEUGEOT 206 Van 1.9 D … View more
The steps may slightly vary depending on the car design.
PEUGEOT 206 Van 1.1, PEUGEOT 206 Van 1.9 D … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for 206 Van and other PEUGEOT models
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Combination spanner #22
Oil filter cup socket 76/14-F
Ratchet wrench
Funnel
Oil drain pan
Fender cover
Replacement: engine oil and filter – PEUGEOT 206 Van. AUTODOC experts recommend:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- All work should be done with the engine stopped.
Replacement: engine oil and filter – PEUGEOT 206 Van. Use the following procedure:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Pull up the oil dipstick.Step 4
Unscrew the oil filler plug. - Step 5Lift the car using a jack or place it over an inspection pit.AUTODOC recommends:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 6
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray. - Step 7
Put a waste oil container with at least 5 l capacity under the drainage hole. - Step 8
Unscrew the drain plug. Use a combination spanner #22. - Step 9
Drain the used oil.Replacement: engine oil and filter – PEUGEOT 206 Van. Tip:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 10Clean the oil filter. Use all-purpose cleaning spray.Step 11
Unscrew the oil filter. Use the 76/14-F socket. Use a ratchet wrench. - Step 12
Put the old oil filter in the container. - Step 13Clean the oil filter seat. Use all-purpose cleaning spray.Step 14
Screw the new filter into its place. Use the 76/14-F socket. Observe the recommended tightening torque. - Step 15
Clean the area of the oil pan drainage hole. - Step 16
Screw in the new drainage plug and tighten it. Use a combination spanner #22. Use a torque wrench. Tighten it to 30 nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the PEUGEOT 206 Van model
Popular maintenance tutorials for PEUGEOT 206 Van
Complete guides for changing the Oil filters on different PEUGEOT 206 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your PEUGEOT 206 Van
View more
How to get your motorcycle ready for spring
How do EGR valves work? | AUTODOC
2 ways to clean the EGR valve – which one is better?
How to tighten cylinder head bolts
Most commonly replaced car parts on PEUGEOT 206
Time to replace parts? Get even better deals in our Shop app.

SCAN ME





























