Recommended replacement interval for the part category Oil filter : 12 month / 15000 km

Important!

This replacement procedure can be used for:
NISSAN NT400 CABSTAR (F24F) 28.12, 32.12, 35.12 (F91AN), NISSAN NT400 CABSTAR (F24F) 35.14, 45.14, NISSAN NT400 CABSTAR (F24F) 35.15, 45.15 … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Oil Filter for NT400 CABSTAR (F24F) and other NISSAN models

Oil filter

        Oil filter for NT400 Cabstar (F24F) Diesel (122 hp)
      
        Oil filter for NT400 Cabstar (F24F) Diesel (136 hp)
      
        Oil filter for NT400 Cabstar (F24F) Diesel (146 hp)

Replacement: engine oil and filter – NISSAN NT400 CABSTAR (F24F). Tools you'll need:

                        All-purpose cleaning spray
                      
                        Drive socket # 14 
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Oil drain pan
                      
                        Funnel
                      
                        Fender cover

Buy tools

Replacement: engine oil and filter – NISSAN NT400 CABSTAR (F24F). AUTODOC experts recommend:

Replace the oil filter every time when changing motor oil.
Wear gloves to prevent contact with hot liquid.
Warning! Shut down the engine before starting any work – NISSAN NT400 CABSTAR (F24F).

Carry out replacement in the following order:

Step 1

Lift the car using a jack or place it over an inspection pit.

Replacement: engine oil and filter – NISSAN NT400 CABSTAR (F24F). Tip:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
Step 2

Put a waste oil container with at least 6 l capacity under the drainage hole.

Step 3

Unscrew the oil filter.
Step 4

Put the old oil filter in the container.

AUTODOC recommends:
Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
Step 5

Clean the oil filter seat. Screw the new filter into its place.
Step 6

Unscrew the drain plug. Use a drive socket #14. Use a ratchet wrench.
Step 7

Drain the used oil.

Replacement: engine oil and filter – NISSAN NT400 CABSTAR (F24F). Tip from AUTODOC:
Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
Step 8

Clean the area of the oil pan drainage hole.

Step 9

Screw in the new drainage plug and tighten it. Use a drive socket #14. Use a torque wrench. Tighten it to 25 Nm torque.
Step 10

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 11

Lower the car. Open the hood.

Step 12

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 13

Unscrew the oil filler plug. Remove the oil filler cap.
Step 14

Insert the funnel.

Step 15

Pour new oil into the engine in the amount recommended by the car manufacturer.

Replacement: engine oil and filter – NISSAN NT400 CABSTAR (F24F). Professionals recommend:
Use the oil recommended by the manufacturer.
Step 16

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 17

Install the oil filler cap.

Step 18

Tighten the oil filler cap.

Step 19

Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.

Step 20

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 21

Remove the fender protection cover. Close the hood.

Replacement: engine oil and filter – NISSAN NT400 CABSTAR (F24F). Tip from AUTODOC experts:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the NISSAN NT400 Cabstar (F24F) model.

Browse tyres

How to change spark plugs on Nissan Qashqai J10 – replacement guide

Free download PDF
2.37 MB
How to change engine oil and filter on Nissan Qashqai J10 – replacement guide

Free download PDF
2.86 MB
How to change engine oil and filter on Nissan X Trail T30 petrol – replacement guide

Free download PDF
1.76 MB
How to change rear suspension lower control arm on Nissan Qashqai J10 – replacement guide

Free download PDF
1.84 MB
How to change front wheel bearing on Nissan Qashqai J10 – replacement guide

Free download PDF
3.71 MB
How to change rear brake pads on Nissan Qashqai J10 – replacement guide

Free download PDF
1.76 MB

How to change engine oil and filter on a car – replacement tutorial

Universal

Free download PDF
2.82 MB
How to change engine oil and filter on Nissan Qashqai J10 – replacement guide

Free download PDF
2.86 MB
How to change engine oil and filter on Nissan X Trail T30 petrol – replacement guide

Free download PDF
1.76 MB
How to change engine oil and filter on Nissan X Trail T30 diesel – replacement guide

Free download PDF
1.08 MB
How to change engine oil and filter on Nissan Micra K12 – replacement guide

Free download PDF
1.6 MB
How to change engine oil and filter on Nissan Micra K11 – replacement guide

Free download PDF
1.46 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

How to reduce fuel consumption | AUTODOC

4K views

Published on: 27/09/2022
How to fix your car with AUTODOC CLUB

16K views

Published on: 30/11/2021
How to remove scratches from a car | AUTODOC tips

7K views

Published on: 12/05/2022
5 mistakes made when washing the engine | AUTODOC tips

29K views

Published on: 22/04/2021