Recommended replacement interval for the part category Oil filter : 12 month / 15000 km

Important!

This replacement procedure can be used for:
FORD FOCUS (DAW, DBW) 1.8 Turbo DI / TDDi, FORD FOCUS (DAW, DBW) 1.8 DI / TDDi, FORD FOCUS (DAW, DBW) 1.8 TDCi … View more

The steps may slightly vary depending on the car design.

How to change oil filter and engine oil on FORD FOCUS (DAW) [TUTORIAL AUTODOC]

All the parts you need to replace – Oil Filter for FOCUS (DAW, DBW) and other FORD models

Oil filter

        Oil filter for FORD FOCUS (DAW, DBW) 1.8 Turbo DI / TDDi Diesel (90 hp)
      
        Oil filter for FORD FOCUS (DAW, DBW) 1.8 DI / TDDi Diesel (75 hp)
      
        Oil filter for FORD FOCUS (DAW, DBW) 1.8 TDCi Diesel (100 hp)

Replacement: engine oil and filter – Ford Focus DAW. Tools you'll need:

                        Wire brush
                      
                        All-purpose cleaning spray
                      
                        Torque wrench
                      
                        Drive socket # 13
                      
                        Oil filter cup socket 65-14F
                      
                        Ratchet wrench
                      
                        Oil drain pan
                      
                        Funnel
                      
                        Fender cover

Buy tools

Replacement: engine oil and filter – Ford Focus DAW. AUTODOC recommends:

Replace the oil filter every time when changing motor oil.
Wear gloves to prevent contact with hot liquid.
Please note: all work on the car – Ford Focus DAW – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Open the hood.
Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
Step 3

Unscrew the oil filler plug.
Step 4

Lift the car using a jack or place it over an inspection pit.

Replacement: engine oil and filter – Ford Focus DAW. Tip from AUTODOC:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All work should be done with the engine stopped.
Step 5

Put a waste oil container with at least 5 l capacity under the drainage hole.
Step 6

Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
Step 7

Unscrew the drain plug. Use a drive socket #13. Use a ratchet wrench.
Step 8

Drain the used oil.

Replacement: engine oil and filter – Ford Focus DAW. AUTODOC recommends:
Wait until the oil has completely drained from the drainage hole.Caution! The oil may be hot.
Step 9

Clean the oil filter. Use all-purpose cleaning spray.

Step 10

Unscrew the oil filter. Use the 65-14F socket. Use a ratchet wrench.
Step 11

Prepare a container for the old oil filter. Put the old oil filter in the container.

Replacement: engine oil and filter – Ford Focus DAW. AUTODOC experts recommend:
Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
Step 12

Clean the oil filter seat. Use all-purpose cleaning spray.
Step 13

Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 14

Install a new oil filter.

Please note!
Make sure to install the filter correctly. Don't mix up the sides of the part.
Step 15

Tighten the oil filter. Remember to observe the recommended tightening torque. Use the 65-14F socket. Use a torque wrench. Tighten it to 20 Nm torque.

Replacement: engine oil and filter – Ford Focus DAW. Tip from AUTODOC:
Wait until the oil has completely drained from the drainage hole.
Step 16

Clean the area of the oil pan drainage hole.

Step 17

Screw in the new drainage plug and tighten it. Use a drive socket #13. Use a torque wrench. Tighten it to 26 nm torque.
Step 18

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 19

Lower the car.
Step 20

Remove the oil filler cap.
Step 21

Insert the funnel.
Step 22

Pour oil into the engine through the filler. Required amount of oil: 4,6 l.

Replacement: engine oil and filter – Ford Focus DAW. Professionals recommend:
Use the oil recommended by the manufacturer.
Step 23

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 24

Install the oil filler cap.

Step 25

Tighten the oil filler cap.
Step 26

Run the engine for a few minutes.
Step 27

After the oil pressure warning light goes out, stop the engine.

Step 28

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 29

Remove the fender protection cover.
Step 30

Close the hood.

Replacement: engine oil and filter – Ford Focus DAW. Tip:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change pollen filter on Ford Focus DAW – replacement guide

Free download PDF
1.18 MB
How to change air filter on Ford Focus DAW – replacement guide

Free download PDF
1.02 MB
How to change front brake pads on Ford Focus DAW – replacement guide

Free download PDF
1.79 MB
How to change rear brake pads on Ford Focus DAW – replacement guide

Free download PDF
1.69 MB
How to change front brake discs on Ford Focus DAW – replacement guide

Free download PDF
1.87 MB
How to change rear brake discs on Ford Focus DAW – replacement guide

Free download PDF
2.16 MB

How to change engine oil and filter on FORD Focus Mk3 Hatchback (DYB) – replacement guide

Free download PDF
2.4 MB
How to change engine oil and filter on FORD Focus Mk2 Hatchback (DA_, HCP, DP) – replacement guide

Free download PDF
2.4 MB
How to change engine oil and filter on FORD Focus C-Max (DM2) – replacement guide

Free download PDF
2.39 MB
How to change engine oil and filter on FORD Focus Mk3 Estate (DYB) – replacement guide

Free download PDF
2.39 MB
How to change engine oil and filter on FORD Focus Mk4 Hatchback (HN) – replacement guide

Free download PDF
1.48 MB
How to change engine oil and filter on FORD Focus Mk2 Convertible (DB3) – replacement guide

Free download PDF
2.39 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

DIY starter repair | AUTODOC tips

39K views

Published on: 31/08/2023
How to polish an old engine valve cover to a shiny finish | AUTODOC Tips

8K views

Published on: 30/11/2023
3 things to know before buying summer tyres | AUTODOC tips

3K views

Published on: 18/05/2023
DIY jack restoration | AUTODOC tips

12K views

Published on: 22/09/2022