
Disclaimer
How to change engine oil and filter on AUDI TT Coupe (8N3) – replacement guide
downloads:
3
Views:
117

Recommended replacement interval for the part category Oil filter : 1 year / 15000 km
Important!
This replacement procedure can be used for:
AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T … View more
The steps may slightly vary depending on the car design.
AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T, AUDI TT Coupe (8N3) 1.8 T quattro, AUDI TT Coupe (8N3) 1.8 T … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for TT Coupe (8N3) and other AUDI models
Oil filter
Alternative products

Oil filter cup socket 65/67-14f
Drive socket # 19
Ring spanner # 19
Torque wrench
Oil drain pan
Funnel
Microfibre towel
Fender cover
AUTODOC recommends:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Use only new O-rings during installation.
- Warning! Shut down the engine before starting any work – AUDI TT (8N3).
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Lift the car using a jack or place it over an inspection pit.AUTODOC recommends:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 4Unscrew the oil filler plug.
- Step 5Undo the fasteners of the oil pan lower cover.Step 6Put a waste oil container with at least 5 l capacity under the drainage hole.
- Step 7Unscrew the drain plug. Use a drive socket No.19 or ring spanner No.19.Step 8Drain the used oil.Replacement: engine oil and filter – AUDI TT (8N3). AUTODOC recommends:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.Step 9Move the container under the oil filter.Step 10Unscrew the oil filter. Use the 65/67-14f socket.Please note!You might need other tools.
- Step 11Prepare a container for the old oil filter.
- Step 12Remove the oil filter. Put the old oil filter in the container.Replacement: engine oil and filter – AUDI TT (8N3). Tip from AUTODOC experts:Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
- Step 13Clean the oil filter seat.
- Step 14Lubricate the rubber seal of the new filter with a little amount of fresh oil.
- Step 15Screw the new filter into its place. Tighten it to 20 nm torque. Use a torque wrench. Use the 65/67-14f socket.Please note!You might need other tools.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the AUDI TT Coupe (8N3) model
Popular maintenance tutorials for Audi TT 8N
Complete guides for changing the Oil filters on different AUDI TT models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your AUDI TT Coupe (8N3)
View more
- What to do if your car’s bonnet won’t open | AUTODOC tips
- Which Coolant is Best? Comparison Test | AUTODOC
- DIY vehicle AC compressor restoration
- Top 5 possible reasons your car is shaking or vibrating
Most commonly replaced car parts on AUDI TT
Time to replace parts? Get even better deals in our Shop app.

SCAN ME