How to change distributor cap on VW GOLF III (1H1) – replacement guide
VW GOLF III (1H1) 1.6, VW GOLF III (1H1) 2.0, VW GOLF III (1H1) 1.8 Syncro (1HX1), VW GOLF III (1H1) 1.8, VW GOLF III (1H1) 1.8 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle

- Follow the terms, recommendations and requirements of the part operation provided by the manufacturer.
- Thoroughly inspect the ignition distributor assembly. Replace any worn parts.
- All work should be done with the engine stopped.
- Step 1
Open the hood.
Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
Step 3
Make marks on the distributor cap to indicate the installation order of the spark plug wires.
- Step 4

Disconnect the spark plug wires from the distributor cap.
Replacement: distributor cap – VW GOLF III (1H1). Tip from AUTODOC experts:Be careful to avoid damaging spark plug wires.
- Step 5

Release the distributor cap clips. Use a crowbar.
- Step 6

Remove the distributor cap.
AUTODOC recommends:Replacement: distributor cap – VW GOLF III (1H1). Do not use excessive force when removing the part as this may damage it.
- Step 7

Install a new distributor cap.
AUTODOC recommends:Replacement: distributor cap – VW GOLF III (1H1). Do not use excessive force during installation. This may damage the part.
- Step 8

Fasten the distributor cap clips.
Find out which tyre and wheel sizes are compatible with the VW Golf III Hatchback (1H1) model
Popular maintenance tutorials for Golf 3
Complete guides for changing the Ignition distributor cap on different VW GOLF models
Track expenses, manage logs, schedule replacements, and more.
Understanding Airbag Light Warnings | Essential Tips for Car Safety
How to Prevent Premature Wear on Your Car Boot Damper | AUTODOC
DIY starter repair | AUTODOC tips
How to prevent car windows from fogging up | AUTODOC tips
Most commonly replaced car parts on VW GOLF























